arXiv subjects

Jean-Francois Ostiguy

Publications and source records attributed to Jean-Francois Ostiguy.

3 recordsLinked to original sources

arXiv2021

Space Charge Driven Emittance Growth and the Effect of Octupoles in IOTA

The Integrable Optics Test Accelerator (IOTA) at Fermilab is a small machine dedicated to a broad frontier accelerator physics program. An important aspect of this program is to investigate the potential benefits of the resonance free tune spread achievable with integrable optics to store and accelerate high intensity proton beams for which space charge is significant. In this context, a good understanding of proton beam emittance growth and particle loss mechanisms is essential. Assuming nominal design parameters, simulations show that for a bunched beam, the bulk of emittance growth takes place immediately following injection, typically within tens of turns. We attempt to account for this growth using a simplified RMS mismatch theory; some of its limitations and possible improvements are briefly discussed. We then compare theoretical predictions to simulations performed using the PIC code pyORBIT. Further exploring ways to mitigate emittance growth and reduce particle loss, we compare two beam matching strategies: (1) matching at the injection point (2) matching at the center of the nonlinear (octupole) insertion region where $β_x = β_y$. To observe how nonlinearity affects emittance growth and whether it dominates growth due to mismatch, we track two different distributions. Finally, we explore the potential of using octupoles in a quasi-integrable configuration to mitigate growth using a variety of initial distributions both at reduced and full intensities.

physics.acc-ph↗

arXiv2021

Modeling Transverse Space Charge effects in IOTA with pyORBIT

The role and mitigation of space charge effects are important aspects of the beam physics research to be performed at the Integrable Optics Test Accelerator (IOTA) at Fermilab. The impact of nonlinear integrability (partial and complete) on space charge driven incoherent and coherent resonances will be a new feature of this accelerator and has the potential to influence the design of future low energy proton synchrotrons. In this report we model transverse space charge effects using the PIC code pyORBIT. First we benchmark the single particle tracking results against MADX with checks on symplecticity, tune footprints, and dynamic aperture in a partially integrable lattice realized with a special octupole string insert. Our space charge calculations begin with an examination of the 4D symplecticity. Short term tracking is done first with the initial bare lattice and then with a matching of the rms values with space charge. Next, we explore slow initialization of charge as a technique to establish steady state and reduce emittance growth and beam loss following injection into a mismatched lattice. We establish values of space charge simulation parameters so as to ensure numerical convergence. Finally, we compare the simulated space charge induced tune shifts and footprints against theory.

physics.acc-ph↗

arXiv2020

Fields and Characteristic Impedances of Dipole and Quadrupole Cylindrical Stripline Kickers

We present semi-analytical methods for calculating the electromagnetic field in dipole and quadrupole stripline kickers with curved plates of infinitesimal thickness. Two different methods are used to solve Laplace's equation by reducing it either to a single or to two coupled matrix equations; they are shown to yield equivalent results. Approximate analytic solutions for the lowest order fields (dipole or quadrupole) are presented and their useful range of validity are shown. The kickers plates define a set of coupled transmission lines and the characteristic impedances of modes relevant to each configuration are calculated. The solutions are compared with those obtained from a finite element solver and found to be in good agreement. Mode matching to an external impedance determines the kicker geometry and this is discussed for both kicker types. We show that a heuristic scaling law can be used to determine the dependence of the characteristic impedance on plate thickness. The solutions found by semi-analytical methods can be used as a starting point for a more detailed kicker design.

physics.acc-ph↗