arXiv subjects

Jinming Zhou

Publications and source records attributed to Jinming Zhou.

4 recordsLinked to original sources

arXiv2023

On the optimality of Kalman Filter for Fault Detection

Kalman filter is widely used for residual generation in fault detection. It leads to optimality in fault detection using some performance indices and also leads to statistically sound residual evaluation and threshold setting. This paper shows that these nice features do not necessarily imply an optimal fault detection performance. Based on a performance index related to fault detection rate and false alarm rate, several occasions where Kalman filter should not be used are pointed out; further the residual evaluation and threshold setting are discussed, in which it is pointed out that in stochastic setting an optimal statistical test of Kamlan filter is not related to optimality of commonly used detection performance indicators. The theoretical analysis is verified through Monte Carlo simulations and Tennessee Eastman process (TEP) dataset.

eess.SY↗

arXiv2023

A critical look at deep neural network for dynamic system modeling

Neural network models become increasingly popular as dynamic modeling tools in the control community. They have many appealing features including nonlinear structures, being able to approximate any functions. While most researchers hold optimistic attitudes towards such models, this paper questions the capability of (deep) neural networks for the modeling of dynamic systems using input-output data. For the identification of linear time-invariant (LTI) dynamic systems, two representative neural network models, Long Short-Term Memory (LSTM) and Cascade Foward Neural Network (CFNN) are compared to the standard Prediction Error Method (PEM) of system identification. In the comparison, four essential aspects of system identification are considered, then several possible defects and neglected issues of neural network based modeling are pointed out. Detailed simulation studies are performed to verify these defects: for the LTI system, both LSTM and CFNN fail to deliver consistent models even in noise-free cases; and they give worse results than PEM in noisy cases.

cs.LG↗

arXiv2023

Analysis and tuning of a three-term DMC

Most MPC (Model Predictive Control) algorithms used in industries and studied in the control academia use a two-term QP (quadratic programming), where the first term is the weighted norm of the output errors, and the second term is that of the input increments. In this work, a DMC (Dynamic Matrix Control) algorithm that uses three-term QP is studied, where the third term is the weighted norm of the output increments. In the analysis, a relationship between the three-term DMC and the two-term DMC is established; based on that, the closed-loop response curves are derived. Based on the analysis, two controller tuning procedures are developed for the three-term DMC, one for closed-loop step response and one for disturbance reduction. Finally, it will be proven that the three-term DMC can achieve a higher performance and robustness than the two-term DMC can. Simulation studies are used to demonstrate the findings and the tuning methods.

eess.SY↗

arXiv2019

Mechanical properties of ultra-hard nanocrystalline cubic boron nitride

Nanostructure and mechanical properties of bulk nanocristalline cubic boron nitride have been studied by transmission electron microscopy, and micro- and nanoindentation. The obtained data on hardness, elastic properties and fracture toughness clearly indicate that nano-cBN belongs to a family of advanced ultra-hard materials.

cond-mat.mtrl-sci↗