arXiv subjects

Jiri Blumenstein

Publications and source records attributed to Jiri Blumenstein.

13 recordsLinked to original sources

arXiv2026

Framework for Indoor Wireless Propagation Modeling Through Wireless Insite

Multipaths, reflections, diffractions, and material interactions complicate indoor wireless propagation modelling. More than 80% of wireless data is consumed indoors; hence, planning successful deployments and maximizing network performance depends on accurate propagation modelling of indoor environments. This work explains a complete framework for indoor wireless propagation modelling via ray tracing simulation in a step-by-step manner. The ray tracing simulations are conducted with Wireless Insite, a proprietary electromagnetic propagation software, whereas SketchUp is used at the input side for layout construction from the field measurements, and MATLAB is used at the output side for portraying channel model parameters such as power delay profile (PDP). A whole floor of the authors' department is modelled, and different transmitter-receiver locations were tested for possible use cases such as coverage hole prediction.

eess.SP↗

arXiv2026

LSTM-Based Power Delay Profile Predictions for Intra-Bus Wireless Propagation

Longlshort-term memory (LSTM) is a deep learning model that can capture long-term dependencies of wireless channel models and is highly adaptable to short-term changes in a wireless environment. This paper proposes a simple LSTM model to predict the channel transfer function (CTF) for a given transmitter-receiver location inside a bus for the 60 GHz millimetre wave band. The average error of the derived power delay profile (PDP) taps, obtained from the predicted CTFs, was less than 10% compared to the ground truth.

eess.SP↗

arXiv2026

Angularly-Resolved 3D Foliage Modeling and Measurements at 60 and 80 GHz: From Stochastic Geometry to Deterministic Channel Characterization

In this paper, we show a stochastic approach to generate a 3D model of a foliage, which is then used for deterministic ray-tracing channel modeling. This approach is verified by a measurement campaign at 60 and 80 GHz with 2 GHz bandwidth. The wireless channel is characterized by path-loss and RMS delay spread and we show the angular dependency of those parameters when the receiver is placed on a half-circle around the tree. Besides electromagnetic material properties, the 3D model is characterized by several interpretable parameters, including tree volume, leaf size, leaf density, and the tree crown shape parameter.

eess.SP↗

arXiv2026

Stochastic 3-D Foliage Modeling at 80 GHz: Experimental Validation and Ray-Tracing Simulations

A stochastic modeling methodology for 3-D foliage is presented, aimed at enhancing ray-tracing simulations. The model supports adjustable stochastic geometry, density, and shape to capture variability in foliage structures. The model is validated through experimental measurements of representative vegetation. The influence of foliage density and size on path loss and root mean square delay spread is analyzed to demonstrate the applicability of the model in the 80 GHz frequency band.

eess.SP↗

arXiv2026

Microdiversity and Vegetation Influence on Forward Scattering at 60 GHz and 80 GHz

Understanding the impact of vegetation and small-scale antenna movements on signal propagation is important for the design and optimization of high-frequency wireless communication systems. This paper presents an experimental study analyzing signal propagation at 60 GHz and 80 GHz in the presence of vegetation, with a focus on forward scattering and microdiversity effects. A controlled measurement campaign was conducted in an indoor environment, where the influence of a potted plant placed in the line-of-sight (LOS) path between the transmitter and receiver was investigated. The study examines the effects of antenna micro-shifts on the channel impulse response (CIR), highlighting variations in received power due to small positional changes of the antennas. The results indicate that the 80 GHz band exhibits higher sensitivity to micro-movements compared to the 60 GHz band, leading to greater fluctuations in received power.

eess.SP↗

arXiv2026

Vehicle-to-Vehicle Millimeter-Wave Channel Characterization at 60 and 80 GHz

This paper presents results from a vehicle-to-vehicle channel measurement campaign conducted in the millimeter-wave (MMW) frequency bands at center frequencies of 60GHz and 80GHz, each with a bandwidth of 2GHz. The measurements were performed in a dynamic oncoming-vehicle scenario using a time-domain channel sounder with high-resolution data acquisition. Power delay profiles were extracted to study the temporal evolution of multipath components, and the root mean square (RMS) delay spread was analyzed to characterize the temporal dispersion of the channel. The results demonstrate differences between the two frequency bands. At 60GHz, the RMS delay spread is well approximated by a Gaussian distribution with a higher median value, while at 80GHz it follows a lognormal distribution with a lower median. Furthermore, the number of resolvable multipath components was found to be nearly twice as high at 60\,GHz compared to 80GHz, highlighting the impact of antenna beamwidth and frequency-dependent propagation mechanisms.

eess.SP↗

arXiv2026

Comparison of 60 GHz and 80 GHz Vehicle-to-Vehicle Channels Using Delay and Doppler Characteristics

The aim of this paper is to provide a comparison of channel characteristics for vehicle-to-vehicle (V2V) communication at 60 GHz and 80 GHz frequency bands in a high-mobility scenario where two vehicles pass each other in opposite directions. The study is based on measurements of the time-varying channel impulse response capturing the behavior of multi-path propagation during vehicle motion. By directly comparing these two frequency bands under identical measurement conditions, we attempt to quantify the differences in power delay profile, root mean square (RMS) delay spread, RMS Doppler spread, and intervals (regions) of stationarity in time domain. The results show that these bands do not differ significantly, but the 80 GHz band exhibits somewhat greater RMS delay spread and RMS Doppler spread when calculated over the entire delay-Doppler spectrum, and conversely exhibits shorter stationarity regions. However, the characteristics of the measurement setup in the two bands and their influence on comparative measurements must be considered. In particular, attention must be paid to the impact of antennas.

eess.SP↗

arXiv2026

Millimeter Wave Path Loss for Diverse Antenna Patterns in Outdoor Environment

Empirical path loss models are defined for a specific antenna system used during measurements and characterized by a particular radiation pattern and main lobe beam width. In this paper, we propose a novel approach to modifying such a model to estimate path loss for antenna systems with different radiation patterns and beam widths. This method is based on a multi-elliptical propagation model, enabling a more flexible adaptation of the path loss model. The paper presents the general concept of the proposed method and numerical study results demonstrating the influence of the antenna pattern shape and its beam width on path loss estimation.

eess.SP↗

arXiv2025

Long-term channel analysis at 60 and 80 GHz for autonomous ground vehicles

This paper presents a comprehensive measurement campaign aimed at evaluating indoor-to-indoor radio channels in dynamic scenarios, with a particular focus on applications such as autonomous ground vehicles (AGV). These scenarios are characterized by the height of the antennas, addressing the unique challenges of near-ground communication. Our study involves long-term measurements (20 minutes of continuous recording per measurement) of the channel impulse response (CIR) in the 60 GHz and 80 GHz frequency bands, each with a bandwidth of 2.048 GHz. We investigate the variations in channel characteristics, focusing on parameters such as root mean square (RMS) delay spread and the Rician factor.

eess.SP↗

arXiv2025

Channel modeling for 60 GHz fixed mmWave O2I and O2O uplink with angular misalignment

In this letter, we examine the effect of misalignment angle on cluster-based power delay profile (PDP) modeling for a 60 GHz millimeter-wave uplink. The analysis uses real-world data, where fixed uplink scenarios are realized by placing the transmitter at ground level and the receiver at the building level. Both outdoor-to-indoor (O2I) and outdoor-to-outdoor (O2O) scenarios are studied. Using the misalignment angle and the scenario as inputs, we propose a statistical PDP simulation algorithm based on the Saleh-Valenzuela model. Different goodness-of-fit metrics reveal that our proposed algorithm is robust to both O2I and O2O scenarios and can approximate the PDPs fairly well, even in case of misalignment.

eess.SP↗

arXiv2025

Synthesis of omnidirectional path loss model based on directional model and multi-elliptical geometry

Millimeter wave (mmWave) technology offers high throughput but has a limited radio range, necessitating the use of directional antennas or beamforming systems such as massive MIMO. Path loss (PL) models using narrow-beam antennas are known as directional models, while those using omnidirectional antennas are referred to as omnidirectional models. To standardize the analysis, omnidirectional PL models for mmWave ranges have been introduced, including TR 38.901 by 3GPP, which is based on measurements from directional antennas. However, synthesizing these measurements can be complex and time-consuming. This study proposes a numerical approach to derive an omnidirectional model from directional data using multi-elliptical geometry. We assessed the effectiveness of this method against existing PL models for mmWaves that are available in the literature.

eess.SP↗

arXiv2025

Variability of radio signal attenuation by single deciduous tree versus reception angle at 80 GHz

Vegetation significantly affects radio signal attenuation, influenced by factors such as signal frequency, plant species, and foliage density. Existing attenuation models typically address specific scenarios, like single trees, rows of trees, or green spaces, with the ITU-R P.833 recommendation being a widely recognized standard. Most assessments for single trees focus on the primary radiation direction of the transmitting antenna. This paper introduces a novel approach to evaluating radio signal scattering by a single deciduous tree. Through measurements at 80 GHz and a bandwidth of approximately 2 GHz, we analyze how total signal attenuation varies with the reception angle relative to the transmitter-tree axis. The findings from various directional measurements contribute to a comprehensive attenuation model applicable to any reception angle and also highlight the impact of bandwidth on the received signal level.

eess.SP↗

arXiv2019

Sparsity in the Delay-Doppler Domain for Measured 60 GHz Vehicle-to-Infrastructure Communication Channels

We report results from millimeter wave vehicle-to-infrastructure (V2I) channel measurements conducted on Sept. 25, 2018 in an urban street environment, down-town Vienna, Austria. Measurements of a frequency-division multiplexed multiple-input single-output channel have been acquired with a time-domain channel sounder at 60 GHz with a bandwidth of 100 MHz and a frequency resolution of 5 MHz. Two horn antennas were used on a moving transmitter vehicle: one horn emitted a beam towards the horizon and the second horn emitted an elevated beam at 15-degrees up-tilt. This configuration was chosen to assess the impact of beam elevation on V2I communication channel characteristics: propagation loss and sparsity of the local scattering function in the delay-Doppler domain. The measurement results within urban speed limits show high sparsity in the delay-Doppler domain.

eess.SP↗