SearcharxivSearch

arXiv subjects

Jiri Rezek

Publications and source records attributed to Jiri Rezek.

2 recordsLinked to original sources

Crystalline b-Ga2O3 thin films deposited via reactive magnetron sputtering of a liquid Ga target

Ga2O3 thin films were deposited by reactive magnetron sputtering from a liquid gallium target. The influence of deposition temperature, substrate type, and discharge parameters on the structural and electrical properties was systematically investigated. Films deposited on silicon and quartz glass exhibit polycrystalline growth, whereas sapphire substrates enable highly oriented growth of b-Ga2O3 with a preferred (-201) orientation. The lowest electrical resistivity of 7x10_3 ohm.cm was obtained for films deposited on sapphire at a temperature of 585C. At this temperature, the films reach sufficient crystalline quality to enable efficient charge carrier transport and thus the manifestation of unintentional conductivity. At higher deposition temperatures, pronounced crystallization occurs; however, it is not homogeneous throughout the entire film thickness, which leads to a deterioration of the electrical properties. These results demonstrate that, despite intrinsic limitations, reactive magnetron sputtering can be successfully employed for the preparation of Ga2O3 thin films with optimized electrical properties when appropriate substrates and deposition temperatures are selected.

cond-mat.mtrl-sci

Enhancement of hole mobility in high-rate reactively sputtered Cu2O thin films induced by laser thermal annealing

In presented work, a reactive high-power impulse magnetron sputtering (r-HiPIMS) was used for high-rate deposition ( 170 nm/min) of Cu2O films. Films were deposited on a standard soda-lime glass (SLG) substrate at a temperature of 190C. As-deposited films exhibit poor hole mobility in the orders of 1 cm2/Vs. We have systematically studied the effect of laser thermal annealing (LTA) procedure performed using high-power infrared laser under different laser parameters (number of pulses, length of the pulse). We have found, LTA procedure could significantly enhance the hole mobility (up to 24 cm2/Vs in our case). We have also fitted the results of a temperature-dependent Hall measurement to clarify the mechanism of the reported increase in hole mobility. Moreover, we have discussed the effect of the LTA procedure on microstructure (crystallinity, surface morphology) and on the value of optical band gap.

physics.app-ph