arXiv subjects

Joachim Dahl Thomsen

Publications and source records attributed to Joachim Dahl Thomsen.

11 recordsLinked to original sources

arXiv2026

Quantification of magnetic interactions in van der Waals heterostructures using Lorentz transmission electron microscopy and electron holography

Magnetic van der Waals (vdW) materials are promising for memory and logic applications because of their highly tunable magnetic properties and compatibility with vdW heterostructure devices. However, coupling between magnetic textures in stacked layers is difficult to resolve in conventional plan-view measurements because the magnetic signal is integrated over the sample thickness. Here, these interactions are quantified in Fe$_3$GeTe$_2$ (FGT)/graphite/FGT heterostructures using cross-sectional Lorentz transmission electron microscopy and off-axis electron holography, enabling reconstruction of the local magnetic induction within and between the layers. Domain alignment weakens with increasing FGT separation, yielding a stray-field coupling length scale of $λ= 37 \pm 7$ nm for the cross-sectional geometry studied here, corresponding to the average separation at which domain misalignment first emerges. This length scale corresponds to an approximately 23% reduction in the interlayer magnetic induction relative to bulk FGT. Surface effects result in a reduced magnetic induction compared to bulk FGT up to $\sim$100 nm from a surface. Comparisons of experimental data with model-based iterative reconstructions of the magnetization and micromagnetic simulations shows that the reduction in induction near surfaces is due to demagnetizing and stray fields. These results quantify the magnetic induction in stacked vdW magnets and guide the design of devices that require controllable coupling between magnetic textures.

cond-mat.mtrl-sci↗

arXiv2026

Towards reliable electrical measurements of superconducting devices inside a transmission electron microscope

Correlating structure with electronic functionality is central to the engineering of quantum materials and devices whose properties depend sensitively on disorder. Transmission electron microscopy (TEM) offers high spatial resolution together with access to structural, electronic, and magnetic degrees of freedom. However, operando electrical transport measurements on functional quantum devices remain rare, particularly at liquid helium temperature. Here, we demonstrate electrical transport measurements of niobium nitride (NbN) devices inside a TEM using a continuous-flow liquid-helium-cooled sample holder. By optimizing a thermal radiation shield to limit radiation from the nearby pole pieces of the objective lens, we achieve an estimated base sample temperature of 8-9 K, as inferred from the superconducting transition temperatures of our devices. We find that both electron beam illumination and objective lens excitation perturb the superconducting state. In addition, we evaluate the imaging capabilities and stability of the sample holder at low temperature by imaging the magnetic domain structure of the van der Waals ferromagnet CrBr$_3$. Finally, we perform calculations that underscore the importance of cryo-shielding for minimizing thermal radiation onto the device. This capability enables correlative low-temperature TEM studies, in which structural, spectroscopic, and electrical transport data can be obtained from the same device, thereby providing a platform for probing the microscopic origins of quantum phenomena.

cond-mat.supr-con↗

arXiv2025

The morphology and interface structure of titanium on graphene

Titanium (Ti) is an adhesion and contact metal commonly used in nanoelectronics and two-dimensional (2D) materials research. However, when Ti is deposited on graphene (Gr), we obtain dramatically different film morphology depending on the experimental conditions. Through a combination of transmission electron microscopy, Raman spectroscopy, and ab initio density functional theory calculations, we show that the most critical parameters are the number of Gr layers, the nature of the Gr support, and the deposition temperature. Particularly distinctive is the island morphology and large defect density of Ti on monolayer Gr, compared to bilayer or thicker Gr. We propose that this results from structural and mechanical differences between monolayer and thicker Gr flakes, where monolayer Gr is more flexible, exhibits larger surface roughness and therefore lower Ti diffusivity, and is more easily damaged. Our results highlight the extreme sensitivity of Ti morphology on Gr to processing and substrate conditions, allowing us to propose design rules for controlling Ti-Gr interface properties and morphology and to discuss the implications for other technologically relevant metal deposition processes.

cond-mat.mtrl-sci↗

arXiv2025

Electric-Field Control of Magnetic Skyrmion Chirality in a Centrosymmetric 2D van der Waals Magnet

Two-dimensional van der Waals magnets hosting topological magnetic textures, such as skyrmions, show promise for applications in spintronics and quantum computing. Electrical control of these topological spin textures would enable novel devices with enhanced performance and functionality. Here, using electron microscopy combined with in situ electric and magnetic biasing, we show that the skyrmion chirality, whether left-handed or right-handed, in insulating Cr2Ge2Te6, is controlled by external electric field direction applied during magnetic field cooling process. The electric-field-tuned chirality remains stable, even amid variations in magnetic and electric fields. Our theoretical investigation reveals that nonzero Dzyaloshinskii-Moriya interactions between the nearest neighbors, induced by the external electric field, change their sign upon reversing the electric field direction, thereby facilitating chirality selection. The electrical control of magnetic chirality demonstrated in this study can be extended to other non-metallic centrosymmetric skyrmion-hosting magnets, opening avenues for future device designs in topological spintronics and quantum computing.

cond-mat.mes-hall↗

arXiv2024

Direct visualization of defect-controlled diffusion in van der Waals gaps

Diffusion processes govern fundamental phenomena such as phase transformations, doping, and intercalation in van der Waals (vdW) bonded materials. Here, we quantify the diffusion dynamics of W atoms by visualizing the motion of individual atoms at three different vdW interfaces: BN/vacuum, BN/BN, and BN/WSe2, by recording scanning transmission electron microscopy movies. Supported by density functional theory calculations, we infer that in all cases diffusion is governed by intermittent trapping at electron beam-generated defect sites. This leads to diffusion properties that depend strongly on the number of defects. These results suggest that diffusion and intercalation processes in vdW materials are highly tunable and sensitive to crystal quality. The demonstration of imaging, with high spatial and temporal resolution, of layers and individual atoms inside vdW heterostructures offers possibilities for direct visualization of diffusion and atomic interactions, as well as for experiments exploring atomic structures, their in-situ modification, and electrical property measurements of active devices combined with atomic resolution imaging.

cond-mat.mtrl-sci↗

arXiv2024

The effect of surface oxidation and crystal thickness on magnetic properties and magnetic domain structures of Cr2Ge2Te6

Van der Waals (vdW) magnetic materials such as Cr2Ge2Te6 (CGT) show promise for novel memory and logic applications. This is due to their broadly tunable magnetic properties and the presence of topological magnetic features such as skyrmionic bubbles. A systematic study of thickness and oxidation effects on magnetic domain structures is important for designing devices and vdW heterostructures for practical applications. Here, we investigate thickness effects on magnetic properties, magnetic domains, and bubbles in oxidation-controlled CGT crystals. We find that CGT exposed to ambient conditions for 5 days forms an oxide layer approximately 5 nm thick. This oxidation leads to a significant increase in the oxidation state of the Cr ions, indicating a change in local magnetic properties. This is supported by real space magnetic texture imaging through Lorentz transmission electron microscopy. By comparing the thickness dependent saturation field of oxidized and pristine crystals, we find that oxidation leads to a non-magnetic surface layer which is thicker than the oxide layer alone. We also find that the stripe domain width and skyrmionic bubble size are strongly affected by the crystal thickness in pristine crystals. These findings underscore the impact of thickness and surface oxidation on the properties of CGT such as saturation field and domain/skyrmionic bubble size and suggest a pathway for manipulating magnetic properties through a controlled oxidation process.

cond-mat.mtrl-sci↗

arXiv2022

Mechanisms of quasi-van der Waals epitaxy of 3D metallic nanoislands on suspended 2D materials

Understanding structure at the interface between two-dimensional (2D) materials and 3D metals is crucial for designing novel 2D/3D heterostructures and improving the performance of many 2D material devices. Here, we quantify and discuss the 2D/3D interface structure and the 3D morphology in several materials systems. We first deposit facetted Au nanoislands on graphene and transition metal dichalcogenides, using measurements of the equilibrium island shape to determine values for the 2D/Au interface energies and examining the role of surface reconstructions, chemical identity, and defects on the grown structures. We then deposit the technologically relevant metals Ti and Nb under conditions where kinetic rather than thermodynamic factors govern growth. We describe a transition from dendritic to facetted islands as a function of growth temperature and discuss the factors determining island shape in these materials systems. Finally, we show that suspended 2D materials enable the fabrication of a novel type of 3D/2D/3D heterostructure and discuss the growth mechanism. We suggest that emerging nanodevices will utilize such versatile fabrication of 2D/3D heterostructures with well-characterized interfaces and morphologies.

cond-mat.mtrl-sci↗

arXiv2022

Suspended graphene membranes to control Au nucleation and growth

Control of nucleation sites is an important goal in materials growth: nuclei in regular arrays may show emergent photonic or electronic behavior, and once the nuclei coalesce into thin films, the nucleation density influences parameters such as surface roughness, stress, and grain boundary structure. Tailoring substrate properties to control nucleation is therefore a powerful tool for designing functional thin films and nanomaterials. Here, we examine nucleation control for metals deposited on two-dimensional (2D) materials in a situation where substrate effects are absent and heterogeneous nucleation sites are minimized. Through quantification of faceted, epitaxial Au island nucleation on graphene, we show that ultra-low nucleation densities with nuclei several micrometers apart can be achieved on suspended graphene under conditions where we measure the nucleation density to be 2-3 orders of magnitude higher on the adjacent supported substrate. We estimate diffusion distances using nucleation theory and find a strong sensitivity of nucleation and diffusion to suspended graphene thickness. We suggest that nucleation site density control via substrate tuning may act as a platform for applications where non-lithographic patterning of metals on graphene is beneficial.

cond-mat.mtrl-sci↗

arXiv2022

Direct Imaging and Electronic Structure Modulation of Moiré Superlattices at the 2D/3D Interface

The atomic structure at the interface between two-dimensional (2D) and three-dimensional (3D) materials influences properties such as contact resistance, photo-response, and high-frequency electrical performance. Moiré engineering is yet to be utilized for tailoring this 2D/3D interface, despite its success in enabling correlated physics at 2D/2D interfaces. Using epitaxially aligned MoS2/Au{111} as a model system, we demonstrate the use of advanced scanning transmission electron microscopy (STEM) combined with a geometric convolution technique in imaging the crystallographic 32 A moiré pattern at the 2D/3D interface. This moiré period is often hidden in conventional electron microscopy, where the Au structure is seen in projection. We show, via ab initio electronic structure calculations, that charge density is modulated according to the moiré period, illustrating the potential for (opto-)electronic moiré engineering at the 2D/3D interface. Our work presents a general pathway to directly image periodic modulation at interfaces using this combination of emerging microscopy techniques.

cond-mat.mtrl-sci↗

arXiv2021

Atomistic spin textures on-demand in the van der Waals layered magnet CrSBr

Controlling magnetism in low dimensional materials is essential for designing devices that have feature sizes comparable to several critical length scales that exploit functional spin textures, allowing the realization of low-power spintronic and magneto-electric hardware. [1] Unlike conventional covalently-bonded bulk materials, van der Waals (vdW)-bonded layered magnets [2-4] offer exceptional degrees of freedom for engineering spin textures. [5] However, their structural instability has hindered microscopic studies and manipulations. Here, we demonstrate nanoscale structural control in the layered magnet CrSBr creating novel spin textures down to the atomic scale. We show that it is possible to drive a local structural phase transformation using an electron beam that locally exchanges the bondings in different directions, effectively creating regions that have vertical vdW layers embedded within the horizontally vdW bonded exfoliated flakes. We calculate that the newly formed 2D structure is ferromagnetically ordered in-plane with an energy gap in the visible spectrum, and weak antiferromagnetism between the planes. Our study lays the groundwork for designing and studying novel spin textures and related quantum magnetic phases down to single-atom sensitivity, potentially to create on-demand spin Hamiltonians probing fundamental concepts in physics, [6-10] and for realizing high-performance spintronic, magneto-electric and topological devices with nanometer feature sizes. [11,12]

cond-mat.mes-hall↗

arXiv2018

A general approach for the synthesis of two-dimensional binary compounds

Only a few of the vast range of potential two-dimensional materials have been isolated or synthesised to date. Typically, 2D materials are discovered by mechanically exfoliating naturally occurring bulk crystals to produce atomically thin layers, after which a material-specific vapour synthesis method must be developed to grow interesting candidates in a scalable manner. Here we show a general approach for synthesising thin layers of two-dimensional binary compounds. We apply the method to obtain high quality, epitaxial MoS2 films, and extend the principle to the synthesis of a wide range of other materials - both well-known and never-before isolated - including transition metal sulphides, selenides, tellurides, and nitrides. This approach greatly simplifies the synthesis of currently known materials, and provides a general framework for synthesising both predicted and unexpected new 2D compounds.

cond-mat.mtrl-sci↗