arXiv subjects

Jonathan N. Tinsley

Publications and source records attributed to Jonathan N. Tinsley.

8 recordsLinked to original sources

arXiv2026

Technical Proposal for the Atom Interferometer CERN Experiment (AICE) Facility

We present the technical proposal for the Atom Interferometer CERN Experiment (AICE), a $\mathcal{O}(100)$ m vertical atom interferometer to be installed against the wall of the PX46 access shaft to the LHC. AICE is conceived as a versatile and flexible long-baseline atom-interferometry facility whose primary scientific goal is probing for bosonic ultralight dark matter (ULDM) in a mass range inaccessible to other experiments, with a secondary goal of pioneering the exploration of gravitational waves (GWs) with frequencies in the range ${\sim}$0.03-3 Hz as a pathfinder for future longer-baseline detectors. The initial configuration employs ultracold $^{87}$Sr atoms in a single-photon 698-nm interferometer with three shaft-based atom sources in a multi-source gradiometer geometry, supported by one surface reference source for laser stabilisation and diagnostics, to target scalar ULDM. Operation with $^{88}$Sr will give sensitivity to axion-like particles (ALPs), vector ULDM with $B-L$ couplings and violation of the principle of equivalence, while a $^{171}$Yb upgrade will improve the sensitivity to $B-L$ couplings and equivalence violations. Probing the Einstein equivalence principle (EP) and measuring $α$ will proceed in parallel with the ULDM searches. A conceptual feasibility study and a detailed technical implementation study have established that PX46 is a uniquely mature and implementation-ready site, with no technical showstoppers. Completing site preparation works during LS3 would enable the subsequent installation and operation of AICE without impacting HL-LHC operations. The detector design builds on the VLBAI and MAGIS experiments and the AION-10 Technical Design Report, scaling the strontium gradiometer architecture to the $\sim$100 m baseline. AICE is endorsed by the TVLBAI Proto-Collaboration, comprising 57 institutions in 22 countries.

hep-ex↗

arXiv2026

Characterisation of a strontium cold atom source using fluorescence spectroscopy and time-of-flight

We demonstrate a characterisation methodology for a strontium atomic beam, produced by a two-dimensional magneto-optical trap and delivered via a resonant push beam, using fluorescence spectroscopy and time-of-flight (ToF). This provides insight into the beam characteristics of a cold atom source, allowing for direct measurement of the transverse velocity spread, longitudinal velocity distributions, divergence, and the capturable flux for further cooling. From the ToF measurements, we derive a series of flux-per-longitudinal-velocity distributions at varying push saturation parameters ($s_{\mathrm{push}}$) using both a unidirectional and counter-propagating resonant probe beam. A simulation-derived factor is applied to the unidirectional probe longitudinal velocity distribution to account for differences in the scattering rate scaling. The distributions are integrated up to an estimated 3D-MOT capture velocity of \SI{30}{\meter\per\second}. For our system, we find that at $s_{\mathrm{push}} = 0.45$, we obtain a flux of $(1.7 \pm 0.4)\times10^{8}$ atoms/s and $(1.5 \pm 0.4)\times10^{8}$ atoms/s, using a unidirectional probe beam and counter-propagating probe, respectively. These measurements provide a framework for characterising cold atomic sources for applications such as 3D MOT loading and atom interferometers.

physics.atom-ph↗

arXiv2025

Letter of Intent: AICE -- 100m Atom Interferometer Experiment at CERN

We propose an O(100)m Atom Interferometer (AI) experiment -- AICE -- to be installed against a wall of the PX46 access shaft to the LHC. This experiment would probe unexplored ranges of the possible couplings of bosonic ultralight dark matter (ULDM) to atomic constituents and undertake a pioneering search for gravitational waves (GWs) at frequencies intermediate between those to which existing and planned experiments are sensitive, among other fundamental physics studies. A conceptual feasibility study showed that this AI experiment could be isolated from the LHC by installing a shielding wall in the TX46 gallery, and surveyed issues related to the proximity of the LHC machine, finding no technical obstacles. A detailed technical implementation study has shown that the preparatory civil-engineering work, installation of bespoke radiation shielding, deployment of access-control systems and safety alarms, and installation of an elevator platform could be carried out during LS3, allowing installation and operation of the AICE detector to proceed during Run 4 without impacting HL-LHC operation. These studies have established that PX46 is a uniquely promising location for an AI experiment. We foresee that, if the CERN management encourages this Letter of Intent, a significant fraction of the Terrestrial Very Long Baseline Atom Interferometer (TVLBAI) Proto-Collaboration may wish to contribute to AICE.

hep-ex↗

arXiv2023

Design and simulation of a source of cold cadmium for atom interferometry

We present a novel optimised design for a source of cold atomic cadmium, compatible with continuous operation and potentially quantum degenerate gas production. The design is based on spatially segmenting the first and second-stages of cooling with the the strong dipole-allowed $^1$S$_0$-$^1$P$_1$ transition at 229 nm and the 326 nm $^1$S$_0$-$^3$P$_1$ intercombination transition, respectively. Cooling at 229 nm operates on an effusive atomic beam and takes the form of a compact Zeeman slower ($\sim$5 cm) and two-dimensional magneto-optical trap (MOT), both based on permanent magnets. This design allows for reduced interaction time with the photoionising 229 nm photons and produces a slow beam of atoms that can be directly loaded into a three-dimensional MOT using the intercombination transition. The efficiency of the above process is estimated across a broad range of experimentally feasible parameters via use of a Monte Carlo simulation, with loading rates up to 10$^8$ atoms/s into the 326 nm MOT possible with the oven at only 100 $^\circ$C. The prospects for further cooling in a far-off-resonance optical-dipole trap and atomic launching in a moving optical lattice are also analysed, especially with reference to the deployment in a proposed dual-species cadmium-strontium atom interferometer.

physics.atom-ph↗

arXiv2022

Practical limits for large-momentum-transfer clock atom interferometers

Atom interferometry on optical clock transitions is being pursued for numerous long-baseline experiments both terrestrially and for future space missions. Crucial to meeting these experiments' required sensitivities is the implementation of large momentum transfer ($>$10$^3\hbar k$). Here we show that to sequentially apply such a large momentum via $π$ pulses places stringent requirements on the frequency noise of the interferometry laser, finding that the linewidth is required to be considerably lower than has previously been suggested. This is due to imperfect pulse fidelity in the presence of noise and is apparent even for an atom at rest interacting with resonant light, making this a fundamental constraint on operational fidelity for a given laser and pulse sequence. Within this framework, we further present and analyse two high-power, frequency-stabilised laser sources designed to perform interferometry on the $^1$S$_0$ - $^3$P$_0$ clock transitions of cadmium and strontium, respectively operating at 332 nm and 698 nm.

physics.atom-ph↗

arXiv2021

Watt-level blue light for precision spectroscopy, laser cooling and trapping of strontium and cadmium atoms

High-power and narrow-linewidth laser light is a vital tool for atomic physics, being used for example in laser cooling and trapping and precision spectroscopy. Here we produce Watt-level laser radiation at 457.49 nm and 460.86 nm of respective relevance for the cooling transitions of cadmium and strontium atoms. This is achieved via the frequency doubling of a kHz-linewidth vertical-external-cavity surface-emitting laser (VECSEL), which is based on a novel gain chip design enabling lasing at > 2 W in the 915-928 nm region. Following an additional doubling stage, spectroscopy of the $^1S_0\to{}^1P_1$ cadmium transition at 228.89 nm is performed on an atomic beam, with all the transitions from all eight natural isotopes observed in a single continuous sweep of more than 4 GHz in the deep ultraviolet. The absolute value of the transition frequency of Cd-114 and the isotope shifts relative to this transition are determined, with values for some of these shifts provided for the first time

physics.atom-ph↗

arXiv2020

Canceling the cavity length induced phase noise in an optical ring cavity for phase shift measurement and spin squeezing

We demonstrate a new method of light phase shift measurement using a high-finesse optical ring cavity which exhibits reduced phase noise due to cavity length fluctuations. Two laser beams with a frequency difference of one cavity free spectral range are simultaneously resonant with the cavity, demonstrating noise correlations in the error signals due to the common-mode cavity length fluctuations. The differential error signal shows a 30 dB reduction in cavity noise down to the noise floor in a frequency range up to half the cavity linewidth ($δν/2 \simeq 30$ kHz). Various noise sources are analyzed and their contributions to the noise floor are evaluated. Additionally, we apply this noise-reduced phase shift measurement scheme in a simulated spin-squeezing experiment where we have achieved a factor of 40 improvement in phase sensitivity with a phase resolution of 0.7 mrad, which may remove one important barrier against attaining highly spin-squeezed states. The demonstrated method is the first reported measurement using an optical ring cavity and two independent beams, a flexible situation. This method can find direct application to non-destructive measurements in quantum systems, such as for the generation of spin-squeezed states in atom interferometers and atomic clocks.

physics.atom-ph↗

arXiv2019

Sr atom interferometry with the optical clock transition as a gravimeter and a gravity gradiometer

We characterize the performance of a gravimeter and a gravity gradiometer based on the $^{1}$S$_{0}$-$^3$P$_0$ clock transition of strontium atoms. We use this new quantum sensor to measure the gravitational acceleration with a relative sensitivity of $1.7\times10^{-5}$, representing the first realisation of an atomic interferometry gravimeter based on a single-photon transition. Various noise contributions to the gravimeter are measured and characterized, with the current primary limitation to sensitivity seen to be the intrinsic noise of the interferometry laser itself. In a gravity gradiometer configuration, a differential phase sensitivity of 1.53~rad/$\sqrt{Hz}$ was achieved at an artificially introduced differential phase of $π/2$~rad. We experimentally investigated the effects of the contrast and visibility based on various parameters and achieve a total interferometry time of 30~ms, which is longer than previously reported for such interferometers. The characterization and determined limitations of the present apparatus employing $^{88}$Sr atoms provides a guidance for the future development of large-scale clock-transition gravimeters and gravity gradiometers with alkali-earth and alkali-earth-like atoms (e.g., $^{87}$Sr, Ca, Yb).

physics.atom-ph↗