arXiv subjects

Jose Ordonez-Miranda

Publications and source records attributed to Jose Ordonez-Miranda.

15 recordsLinked to original sources

arXiv2026

Enhancement of far-field thermal emission via polaritonic cavity modes

Controlling thermal emission is crucial for applications involving thermophotovoltaics, thermal sensing, imaging, and camouflage. While prior studies focused on the emission of thermally excited guided modes (TEGMs) inside cavities, their contribution to the far-field radiation outside cavities has remained unexplored. Here, we demonstrate a tunable far-field thermal channel enabled by TEGMs arising from the coupling of surface phonon-polaritons and cavity resonances. By combining infrared emissivity experiments with fluctuational electrodynamics simulations, we identify distinct spectral features marking the conversion of two-dimensionally confined polaritonic modes into three-dimensional radiative channels. We find that silicon cavities covered with SiO2 enhance the emissivity by up to 200% near the polaritonic spectral resonance, whereas bare silicon cavities yield only broadband enhancement. These findings provide experimental evidence of TEGMs and establish a simple cavity architecture as an effective and scalable platform for tailoring thermal radiation without complex nanofabrication.

cond-mat.mes-hall↗

arXiv2026

Enhanced Near-Field Thermal Radiation Driven by Multiple Corner and Edge Modes in Subwavelength Square Nanowires

We demonstrate that the near-field thermal radiation between subwavelength SiC nanowires with square cross sections is dominated by multiple corner and edge resonances rather than the single surface-phonon-polariton channel of planar surfaces. Fluctuational electrodynamics simulations reveal that these resonances lie within the SiC Reststrahlen band, redshift for thinner nanowires, and yield a four-fold enhancement of thermal conductance. This maximum enhancement occurs when the separation gap nearly matches the nanowire thickness, balancing dimensional confinement and interwire coupling. These findings establish square nanowires as a versatile platform for geometrycontrolled near-field heat transfer in nanoscale heat management and energy conversion.

cond-mat.mes-hall↗

arXiv2025

Ultra-High-Temperature Vacuum Prober for Electrical and Thermal Measurements

We develop an ultra-high-temperature vacuum probe station (UHT-VPS) featuring a sample holder heated by thermal radiation from a silicon carbide heater. This contactless configuration electrically isolates the sample from the high-power heating source through a vacuum gap, ensuring reliable measurements under extreme conditions. The capability of this UHT-VPS to measure electrical signals from 30 nV upward on bulk sapphire is demonstrated using the 3w/2w method. Measurements are continuously operated from 300 to 1150 K, under high vacuum, for a total of about 66 hours without readjusting the contact. They yield the linear and quadratic temperature coefficients of resistance of chromium/platinum micro-resistances, as well as the sapphire's thermal conductivity and thermal diffusivity. By recording the heater and sensor temperature signals up to 30 kHz and fitting them with theoretical models that account for the quadratic TCR of Cr/Pt microwires, we obtain values in agreement with literature data obtained by optical methods. In this temperature range, we also measure thermal conductivity, which cannot be directly accessed by optical techniques. Our system thus provides an effective solution for simultaneously retrieving the electrical and thermal properties of materials using a single set of 3w/2w data up to unprecedented temperature levels.

physics.ins-det↗

arXiv2024

Using oxides to compute with heat

One of the most innovative possibilities offered by oxides is the use of heat currents for computational purposes. Towards this goal, phase-change oxides, including ferroelectrics, ferromagnets and related materials, could reproduce sources, logic units and memories used in current and future computing schemes.

physics.app-ph↗

arXiv2023

Polaritonic Waveguide Emits Super-Planckian Thermal Radiation

Classical Planck's theory of thermal radiation predicts an upper limit of the heat transfer between two bodies separated by a distance longer than the dominant radiation wavelength (far-field regime). This limit can be overcome when the dimensions of the absorbent bodies are smaller than the dominant wavelength due to hybrid electromagnetic waves, known as surface phonon-polaritons (SPhPs). Here, we experimentally demonstrate that the far-field radiative heat transfer between two non-absorbent bodies can also overcome Planck's limit, by coating them with an absorbent material to form a polaritonic waveguide. This super-Planckian far-field thermal radiation is confirmed by measuring the radiative thermal conductance between two silicon plates coated with silicon dioxide nanolayers. The observed conductance is twice higher than Planck's limit and agrees with the predictions of our model for the SPhP waveguide modes. Our findings could be applied to thermal management in microelectronics and silicon photonics.

physics.optics↗

arXiv2022

Asymmetry of tensile vs. compressive elasticity and permeability contributes to the regulation of exchanges in collagen gels

The Starling principle describes exchanges in tissues based on the balance of hydrostatic and osmotic flows. This balance neglects the coupling between mechanics and hydrodynamics, a questionable assumption in strained elastic tissues due to intravascular pressure. Here, we measure the elasticity and permeability of collagen gels under tensile and compressive stress via the comparison of the temporal evolution of pressure in an air cavity sealed at the outlet of a collagen slab with an analytical kinetic model. We observe a drop in the permeability and enhanced strain-stiffening of native collagen gels under compression, both effects being essentially lost after chemical cross-linking. Further, we prove that this asymmetric response accounts for the accumulation of compressive stress upon sinusoidal fluid injection, which modulates the material's permeability. Our results thus show that the properties of collagen gels regulate molecular exchanges and could help understand drug transport in tissues.

physics.bio-ph↗

arXiv2022

Si plate radius influence on the photoacoustic signal processed by neural networks

The effect of the sample radius on the total photoacoustic signal processed by neural networks trained with undistorded and distorded signals is carefully analized for modulation frequencies from 20 to 20 kHz. This is done for signals generated for a 400micrometers thick Si n-type plate, whose radius varies from 2 to 7 mm. It is found that the networks trained with both undistorded or distorded signals yield the best predictions for sample radii between 2 and 3 mm, which is close to the used microphone aperture radius of 1.5 mm. The network trained only with undistorted signals gives the best results for sample radii comparable to the microphone dimensions. The obtained results justify the validity of a theoretical model derived for a sample radius equals to the microphone aperture and indicate the experimental necessity to use samples with radii comparable to this aperture.

cond-mat.mtrl-sci↗

arXiv2021

Observation of quasi-ballistic thermal transport of surface phonon-polaritons over hundreds of micrometres

Long-distance propagation of heat carriers is essential for efficient heat dissipation in microelectronics. However, in dielectric nanomaterials, the primary heat carriers - phonons - can propagate ballistically only for hundreds of nanometres, which limits their heat conduction efficiency. Theory predicts that surface phonon-polaritons (SPhPs) can overcome this limitation and conduct heat without dissipation for hundreds of micrometres. In this work, we experimentally demonstrate such long-distance heat transport by SPhPs. Using the 3$ω$ technique, we measure the in-plane thermal conductivity of SiN nanomembranes for different heater-sensor distances (100 and 200 $μ$m), membrane thicknesses (30 - 200 nm), and temperatures (300 - 400 K). We find that in contrast with thick membranes, thin nanomembranes support heat conduction by SPhPs, as evidenced by an increase in the thermal conductivity with temperature. Remarkably, the thermal conductivity measured 200 $μ$m away from the heater are consistently higher than that measured 100 $μ$m closer. This result suggests that heat conduction by SPhPs is quasi-ballistic over at least hundreds of micrometres. Thus, our findings show that SPhPs can enhance heat dissipation in polar nanomembranes and find applications in thermal management, near-field radiation, and polaritonics.

cond-mat.mes-hall↗

arXiv2019

Surface phonon-polaritons enhance thermal conduction in SiN nanomembranes

Surface phonon-polaritons can carry energy on the surface of dielectric films and thus are expected to contribute to heat conduction. However, the contribution of surface phonon-polaritons (SPhPs) to thermal transport has not been experimentally demonstrated yet. In this work, we experimentally measure the effective in-plane thermal conductivity of amorphous silicon nitride membrane and show that it can indeed be increased by SPhPs significantly when the membrane thickness scales down. In particular, by heating up a thin membrane (<100 nm) from 300 to 800 K, the thermal conductivity increases twice due to SPhPs contribution.

cond-mat.mes-hall↗

arXiv2019

Thermal Conductivity Enhancement by Surface Electromagnetic Waves Propagating along Multilayered Structures with Asymmetric Surrounding Media

Enhancement of thermal conductivity via surface electromagnetic waves (SEWs) supported in nanostructures has recently drawn attention as a remedy for issues raised due to the reduction of thermal conductivity in nanoscale confinement. Among them, multilayered structures on a substrate are prevalent in nano-sized systems, such as electronic nanodevices, meaning that analysis on those structures is indispensable. In this work, three basic multilayered structures are selected and the analytical expressions for SEWs supported in each structure are derived. This analytical approach enables us to figure out which factors are crucial for enhancing SEW thermal conductivity using multilayers. It is also found that the solution can be extended to various materials and provide the guidelines on which configurations are desirable for increasing the thermal conductivity. Furthermore, the analytical solutions reduce the calculation time significantly such that the optimal configuration, which can additionally yield SEW thermal conductivity of 1.27 W/m$\cdot$K corresponding to 90\% of the thermal conductivity of bulk glass, is found with the genetic algorithm. This study thus provides a new method for efficiently managing thermal issues in nano-sized devices.

physics.app-ph↗

arXiv2017

VO 2 -based radiative thermal transistor in the static regime

We study a near-field radiative thermal transistor analogous to an electronic one made of a VO 2 base placed between two silica semi-infinite plates playing the roles of the transistor collector and emitter. The fact that VO 2 exhibits an insulator to metal transition is exploited to modulate and/or amplify heat fluxes between the emitter and the collector, by applying a thermal current on the VO 2 base. We study the transistor behavior in 4 typical regimes where the emitter-base and base-collector separation distances can be larger or smaller than the thermal wavelength, and in which the VO 2 layer can be opaque or transparent. Thermal currents variations with the base temperatures are calculated and analyzed. An optimum configuration for base thickness and separation distance maximizing the thermal transistor modulation factor is found.

physics.optics↗

arXiv2016

Quantum Thermal Rectification to design thermal diodes and transistors

We study in this article how heat can be exchanged between two level systems (TLS) each of them being coupled to a thermal reservoir. Calculation are performed solving a master equation for the density matrix using the Born markov-approximation. We analyse the conditions for which a thermal diode and a thermal transistor can be obtained as well as their optimization.

quant-ph↗

arXiv2016

Quantum thermal transistor

We demonstrate that a thermal transistor can be made up with a quantum system of 3 interacting subsystems , coupled to a thermal reservoir each. This thermal transistor is analogous to an electronic bipolar one with the ability to control the thermal currents at the collector and at the emitter with the imposed thermal current at the base. This is achieved determining the heat fluxes by means of the strong-coupling formalism. For the case of 3 interacting spins, in which one of them is coupled to the other 2, that are not directly coupled, it is shown that high amplification can be obtained in a wide range of energy parameters and temperatures. The proposed quantum transistor could, in principle, be used to develop devices such as a thermal modulator and a thermal amplifier in nano systems.

quant-ph↗

arXiv2015

Steady State and Modulated Heat Conduction in Layered Systems Predicted by the Phonon Boltzmann Transport Equation

Based on the phonon Boltzmann transport equation under the relaxation time approximation, analytical expressions for the temperature profiles of both steady state and modulated heat conduction inside a thin film deposited on a substrate are derived and analyzed. It is shown that both steady state and modulated components of the temperature depend strongly on the ratio between the film thickness and the average phonon mean free path, and they exhibit the diffusive behavior as predicted by the Fourier law of heat conduction when this ratio is much larger than the unity. In contrast, in the ballistic regime when this ratio is comparable to or smaller than the unity, the steady-state temperature tends to be independent of position, while the amplitude and the phase of the modulated temperature appear to be lower than those determined by the Fourier law. Furthermore, we derived an invariant of heat conduction and a simple formula for the cross-plane thermal conductivity of dielectric thin films, which could be a useful guide for understanding and optimizing the thermal performance of the layered systems. This work represents the Boltzmann transport equation-based extension of the Rosencwaig and Gerko work [J. Appl. Phys. 47, 64 (1976)], which is based on the Fourier law and has widely been used as the theoretical framework for the development of photoacoustic and photothermal techniques. This work might shed some light on developing a theoretical basis for the determination of the phonon MFP and relaxation time using ultrafast laser-based transient heating techniques.

cond-mat.mes-hall↗

arXiv2013

Quantized Thermal Conductance of Nanowires at Room Temperature due to Surface Phonon-Polaritons

Based on the Landauer formalism, we demonstrate that the thermal conductance due to the propagation of surface phonon-polaritons along a polar nanowire is independent of the material characteristics and is given by Pi^2kB^2T/3h. The giant propagation length of these energy carriers establishes that this quantization holds not only for a temperature much smaller than 1 K, as is the case of electrons and phonons, but also for temperatures comparable to room temperature, which can significantly facilitate its observation and application in the thermal management of nanoscale electronics and photonics.

cond-mat.mes-hall↗