arXiv subjects

Julien Dejonghe

Publications and source records attributed to Julien Dejonghe.

6 recordsLinked to original sources

arXiv2026

Laboratory characterization of Hierarchical Fringe Tracking

One of the main limitations in long-baseline interferometry lies in its fringe tracking sensitivity. The challenge is therefore to maximize this sensitivity while minimizing the spreading of the signal on the detector. This is the goal at the core of the hierarchical fringe tracking (HFT) concept. We present the laboratory characterization of the $2^{nd}$ generation HFT chips operating in the near infrared (H band) for up to 4 telescopes with more linear phase and group delay estimators, allowing a strong simplification of the tracking algorithm. We show a comparison between theoretical intensity outputs for an optimized phase delay chip, and the laboratory measurements of two chips with different designs. The results do not reach the expectations but get close to them with the 10-outputs chip. Ultimately, this new chip is intended for implementation on the VLTI, CHARA or on the future Xuyi 100m-baseline Stellar Interferometer using three telescopes.

astro-ph.IM↗

arXiv2026

Interferometric Survey of Stellar Parameters: Towards homogeneous FGK stars parameters and surface-brightness color relation in the context of PLATO space mission

The estimation of stellar angular diameters can be performed from the surface brightness - color relation (SBCR) and photometry. The SBCR have been considered by the PLATO space mission as an independent empirical alternative for estimating stellar radii of FGK stars. In this context, we have implemented an homogeneous approach not only for calibrating the SBCR for FGK-IV/V stars but, also for determining their fundamental parameters in order to place the stars reliably on the HR diagram and to study their impact on the SBCR. We have performed interferometric observations of 18 quiescent FGK-IV/V stars in the Gaia color range of $3.088 \leq G \leq 5.498$. For the first time, we used 3 different interferometers operating in the $R$, $H$ , and $K$ bands to measure polychromatic limb-darkened angular diameters (LDAD). In parallel, by using public domain spectra we have estimated the stellar parameters ($T_{eff}$, $log g$ and Z) by using the open python tool iSpec. We achieved an average accuracy of 2.3% for the LDAD based on polychromatic observations. However, we have observed that our SBCR does not follow the calibration of the relation between surface brightness and color in Gaia found in the literature. Furthermore, we found that $log g$ and $Z$ have no impact on the SBC relation; given the characteristics of our sample of quiescent stars, it constitutes an ideal set of targets for conducting a new SBCR calibration within the framework of the PLATO space mission. In this context, we reported a SBCR calibration with $\sigma_{RMS} = $ 0.012, 0.009, 0.009 in the $G, G_{BP}$ and $G_{RP}$ Gaia bands, respectively. This article is part of a series of papers reporting the first results obtained using a polychromatic approach to measure LDAD, employing a fully homogeneous methodology for both determining the fundamental parameters of stars and measuring the LDAD, $\theta_{LD}$.

astro-ph.SR↗

arXiv2024

Recent and Upcoming Upgrades for MIRC-X and MYSTIC on the CHARA Array

MIRC-X and MYSTIC are six-telescope near-infrared beam (1.08-2.38 ${\mu}$m) combiners at the CHARA Array on Mt Wilson CA, USA. Ever since the commissioning of MIRC-X (J and H bands) in 2018 and MYSTIC (K bands) in 2021, they have been the most popular and over-subscribed instruments at the array. Observers have been able to image stellar objects with sensitivity down to 8.1 mag in H and 7.8 mag in K-band under the very best conditions. In 2022 MYSTIC was upgraded with a new ABCD mode using the VLTI/GRAVITY 4-beam integrated optics chip, with the goal of improving the sensitivity and calibration. The ABCD mode has been used to observe more than 20 T Tauri stars; however, the data pipeline is still being developed. Alongside software upgrades, we detail planned upgrades to both instruments in this paper. The main upgrades are: 1) Adding a motorized filter wheel to MIRC-X along with new high spectral resolution modes 2) Updating MIRC-X optics to allow for simultaneous 6T J+H observations 3) Removing the warm window between the spectrograph and the warm optics in MYSTIC 4) Adding a 6T ABCD mode to MIRC-X in collaboration with CHARA/SPICA 5) Updating the MIRC-X CRED-ONE camera funded by Prof. Kraus from U. Exeter 6) Carrying out science verification of the MIRC-X polarization mode 7) Developing new software for ABCD-mode data reduction and more efficient calibration routines. We expect these upgrades to not only improve the observing experience, but also increase the sensitivity by 0.4 mag in J+H-bands, and 1 mag in K-band.

astro-ph.IM↗

arXiv2023

Three-dimensional atmospheric dynamics of Jupiter from ground-based Doppler imaging spectroscopy in the visible

We present three-dimensional (3D) maps of Jupiter's atmospheric circulation at cloud-top level from Doppler-imaging data obtained in the visible domain with JIVE, the second node of the JOVIAL network, which is mounted on the Dunn Solar Telescope at Sunspot, New Mexico. We report on 12 nights of observations between May 4 and May 30, 2018, representing a total of about 80 hours. Firstly, the average zonal wind profile derived from our data is compatible with that derived from cloud-tracking measurements performed on Hubble Space Telescope images obtained in April 2018 from the Outer Planet Atmospheres Legacy (OPAL) program. Secondly, we present the first ever two-dimensional maps of Jupiter's atmospheric circulation from Doppler measurements. The zonal velocity map highlights well-known atmospheric features, such as the equatorial hot spots and the Great Red Spot (GRS). In addition to zonal winds, we derive meridional and vertical velocity fields from the Doppler data. The motions attributed to vertical flows are mainly located at the boundary between the equatorial belts and tropical zones, which could indicate active motion in theses regions. Qualitatively, these results compare well to recent Juno data that have unveiled the three-dimensional structure of Jupiter's wind field. To the contrary, the motions attributed to meridional circulation are very different from what is obtained by cloud tracking, except at the GRS. Because of limitations with data resolution and processing techniques, we acknowledge that our measurement of vertical or meridional flows of Jupiter are still to be confirmed.

astro-ph.EP↗

arXiv2022

CHARA/SPICA: a 6-telescope visible instrument for the CHARA Array

With a possible angular resolution down to 0.1-0.2 millisecond of arc using the 330 m baselines and the access to the 600-900 nm spectral domain, the CHARA Array is ideally configured for focusing on precise and accurate fundamental parameters of stars. CHARA/SPICA (Stellar Parameters and Images with a Cophased Array) aims at performing a large survey of stars all over the Hertzsprung-Russell diagram. This survey will also study the effects of the different kinds of variability and surface structure on the reliability of the extracted fundamental parameters. New surface-brightness-colour relations will be extracted from this survey, for general purposes on distance determination and the characterization of faint stars. SPICA is made of a visible 6T fibered instrument and of a near-infrared fringe sensor. In this paper, we detail the science program and the main characteristics of SPICA-VIS. We present finally the initial performance obtained during the commissioning.

astro-ph.IM↗

arXiv2022

SPICA-FT: The new fringe tracker of the CHARA array

SPICA-FT is part of the CHARA/SPICA instrument which combines a visible 6T fibered instrument (SPICAVIS) with a H-band 6T fringe sensor. SPICA-FT is a pairwise ABCD integrated optics combiner. The chip is installed in the MIRC-X instrument. The MIRC-X spectrograph could be fed either by the classical 6T fibered combiner or by the SPICA-FT integrated optics combiner. SPICA-FT also integrates a dedicated fringe tracking software, called the opd-controller communicating with the main delay line through a dedicated channel. We present the design of the integrated optics chip, its implementation in MIRC-X and the software architecture of the group-delay and phase-delay control loops. The final integrated optics chip and the software have been fully characterized in the laboratory. First on-sky tests of the integrated optics combiner began in 2020. We continue the on-sky tests of the whole system (combiner + software) in Spring and Summer 2022. We present the main results, and we deduce the preliminary performance of SPICA-FT.

astro-ph.IM↗