Searcharxiv⌕ Search

arXiv subjects

Julien Perruisseau-Carrier

Publications and source records attributed to Julien Perruisseau-Carrier.

At least 19 recordsLinked to original sources
arXiv2016

Spatial Multiplexing of QPSK Signals with a Single Radio: Antenna Design and Over-the-Air Experiments

The paper describes the implementation and performance analysis of the first fully-operational beam-space MIMO antenna for the spatial multiplexing of two QPSK streams. The antenna is composed of a planar three-port radiator with two varactor diodes terminating the passive ports. Pattern reconfiguration is used to encode the MIMO information onto orthogonal virtual basis patterns in the far-field. A measurement campaign was conducted to compare the performance of the beam-space MIMO system with a conventional 2-by-?2 MIMO system under realistic propagation conditions. Propagation measurements were conducted for both systems and the mutual information and symbol error rates were estimated from Monte-Carlo simulations over the measured channel matrices. The results show the beam-space MIMO system and the conventional MIMO system exhibit similar finite-constellation capacity and error performance in NLOS scenarios when there is sufficient scattering in the channel. In comparison, in LOS channels, the capacity performance is observed to depend on the relative polarization of the receiving antennas.

cs.IT↗
arXiv2014

Gate-controlled mid-infrared light bending with aperiodic graphene nanoribbons array

Graphene plasmonic nanostructures enable subwavelength confinement of electromagnetic energy from the mid-infrared down to the terahertz frequencies. By exploiting the spectrally varying light scattering phase at vicinity of the resonant frequency of the plasmonic nanostructure, it is possible to control the angle of reflection of an incoming light beam. We demonstrate, through full-wave electromagnetic simulations based on Maxwell equations, the electrical control of the angle of reflection of a mid-infrared light beam by using an aperiodic array of graphene nanoribbons, whose widths are engineered to produce a spatially varying reflection phase profile that allows for the construction of a far-field collimated beam towards a predefined direction.

physics.optics↗
arXiv2014

Nonlocal Electromagnetic Response of Graphene Nanostructures

Nonlocal electromagnetic effects of graphene arise from its naturally dispersive dielectric response. We present semi-analytical solutions of nonlocal Maxwell's equations for graphene nano-ribbons array with features around 100 nm, where we found prominent departures from its local response. Interestingly, the nonlocal corrections are stronger for light polarization parallel to the ribbons, which manifests as additional broadening of the Drude peak. For the perpendicular polarization case, nonlocal effects lead to blue-shifts of the plasmon peaks. These manifestations provide a physical measure of nonlocal effects, and we quantify their dependence on ribbon width, doping and wavelength.

physics.optics↗
arXiv2014

MEMS-reconfigurable metamaterials and antenna applications

This paper reviews some of our contributions to reconfigurable metamaterials, where dynamic control is enabled by micro-electro-mechanical systems (MEMS) technology. First, we show reconfigurable composite right/left handed transmission lines (CRLH-TLs) having state of the art phase velocity variation and loss, thereby enabling efficient reconfigurable phase shifters and leaky-wave antennas (LWA). Second, we present very low loss metasurface designs with reconfigurable reflection properties, applicable in reflectarrays and partially reflective surface (PRS) antennas. All the presented devices have been fabricated and experimentally validated. They operate in X- and Ku-bands.

physics.optics↗
arXiv2014

Reconfigurable THz Plasmonic Antenna Concept Using a Graphene Stack

The concept and analysis of a Terahertz (THz) frequency-reconfigurable antenna using graphene are presented. The antenna exploits dipole-like plasmonic resonances that can be frequency-tuned on large range via the electric field effect in a graphene stack. In addition to efficient dynamic control, the proposed approach allows high miniaturization and good direct matching with continuous wave THz sources. A qualitative model is used to explain the excellent impedance stability under reconfiguration. These initial results are very promising for future all-graphene THz transceivers and sensors. Keywords: Reconfigurable antenna, Graphene, Plasmons, Terahertz, frequency-tuning.

physics.optics↗
arXiv2014

User Effects in Beam-Space MIMO

The performance and design of the novel single-RF-chain beam-space MIMO antenna concept is evaluated for the first time in the presence of the user. First, the variations of different performance parameters are evaluated when placing a beam-space MIMO antenna in close proximity to the user body in several typical operating scenarios. In addition to the typical degradation of conventional antennas in terms of radiation efficiency and impedance matching, it is observed that the user body corrupts the power balance and the orthogonality of the beam-space MIMO basis. However, capacity analyses show that throughput reduction mainly stems from the absorption in user body tissues rather than from the power imbalance and the correlation of the basis. These results confirm that the beam-space MIMO concept, so far only demonstrated in the absence of external perturbation, still performs very well in typical human body interaction scenarios.

cs.IT↗
arXiv2014

Predicting input impedance and efficiency of graphene reconfigurable dipoles using a simple circuit model

An analytical circuit model able to predict the input impedance of reconfigurable graphene plasmonic dipoles is presented. A suitable definition of plasmonic characteristic impedance, employing natural currents, is used to for consistent modeling of the antenna-load connection in the circuit. In its purely analytical form, the model shows good agreement with full-wave simulations, and explains the remarkable tuning properties of graphene antennas. Furthermore, using a single full-wave simulation and scaling laws, additional parasitic elements can be determined for a vast parametric space, leading to very accurate modeling. Finally, we also show that the modeling approach allows fair estimation of radiation efficiency as well. The approach also applies to thin plasmonic antennas realized using noble metals or semiconductors.

physics.optics↗
arXiv2014

Efficient MIMO Transmission of PSK Signals With a Single-Radio Reconfigurable Antenna

Crucial developments to the recently introduced signal-space approach for multiplexing multiple data symbols using a single-radio switched antenna are presented. First, we introduce a general framework for expressing the spatial multiplexing relation of the transmit signals only from the antenna scattering parameters and the modulating reactive loading. This not only avoids tedious far-field calculations, but more importantly provides an efficient and practical strategy for spatially multiplexing PSK signals of any modulation order. The proposed approach allows ensuring a constant impedance matching at the input of the driving antenna for all symbol combinations, and as importantly uses only passive reconfigurable loads. This obviates the use of reconfigurable matching networks and active loads, respectively, thereby overcoming stringent limitations of previous single-feed MIMO techniques in terms of complexity, efficiency, and power consumption. The proposed approach is illustrated by the design of a realistic very compact antenna system optimized for multiplexing QPSK signals. The results show that the proposed approach can bring the MIMO benefits to the low-end user terminals at a reduced RF complexity.

cs.IT↗
arXiv2014

Sinusoidally-Modulated Graphene Leaky-Wave Antenna for Electronic Beamscanning at THz

This paper proposes the concept, analysis and design of a sinusoidally-modulated graphene leaky-wave antenna with beam scanning capabilities at a fixed frequency. The antenna operates at terahertz frequencies and is composed of a graphene sheet transferred onto a back-metallized substrate and a set of polysilicon DC gating pads located beneath it. In order to create a leaky-mode, the graphene surface reactance is sinusoidally-modulated via graphene's field effect by applying adequate DC bias voltages to the different gating pads. The pointing angle and leakage rate can be dynamically controlled by adjusting the applied voltages, providing versatile beamscanning capabilities. The proposed concept and achieved performance, computed using realistic material parameters, are extremely promising for beamscanning at THz frequencies, and could pave the way to graphene-based reconfigurable transceivers and sensors.

cond-mat.mes-hall↗
arXiv2013

Copper and Transparent-Conductor Reflectarray Elements on Thin-Film Solar Cell Panels

This work addresses the integration of reflectarray antennas (RA) on thin film Solar Cell (SC) panels, as a mean to save real estate, weight, or cost in platforms such as satellites or transportable autonomous antenna systems. Our goal is to design a good RA unit cell in terms of phase response and bandwidth, while simultaneously achieving high optical transparency and low microwave loss, to preserve good SC and RA energy efficiencies, respectively. Since there is a trade-off between the optical transparency and microwave surface conductivity of a conductor, here both standard copper and transparent conductors are considered. The results obtained at the unit cell level demonstrates the feasibility of integrating RA on a thin-film SC, preserving for the first time good performance in terms of both SC and RA efficiency. For instance, measurement at X-band demonstrate families of cells providing a phase range larger than 270° with average microwave loss of -2.45dB (resp. -0.25dB) and average optical transparency in the visible spectrum of 90% (resp. 85%) using transparent conductive multilayer (resp. a copper layer).

physics.optics↗
arXiv2013

Fundamental limits and near-optimal design of graphene modulators and non-reciprocal devices

The potential of graphene for use in photonic applications was evidenced by recent demonstrations of modulators, polarisation rotators, and isolators. These promising yet preliminary results raise crucial questions: what is the optimal performance achievable by more complex designs using multilayer structures, graphene patterning, metal additions, or a combination of these approaches, and how can this optimum design be achieved in practice? Today, the complexity of the problem, which is magnified by the variability in graphene parameters, leaves the design of these new devices to time-consuming and suboptimal trial-and-error procedures. We address this issue by first demonstrating that the relevant figures of merit for the devices above are subject to absolute theoretical upper bounds. Strikingly these limits are related only to the conductivity tensor of graphene; thus, we can provide essential roadmap information such as the best possible device performance versus wavelength and graphene quality. Second, based on the theory developed, physical insight, and detailed simulations, we demonstrate how structures closely approaching these fundamental limits can be designed, demonstrating the possibility of significant improvement. These results are believed to be of paramount importance for the design of graphene-based modulators, rotators, and isolators and are also directly applicable to other 2-dimensional materials.

physics.optics↗
arXiv2013

Reconfigurable Reflectarrays and Array Lenses for Dynamic Antenna Beam Control: A Review

Advances in reflectarrays and array lenses with electronic beam-forming capabilities are enabling a host of new possibilities for these high-performance, low-cost antenna architectures. This paper reviews enabling technologies and topologies of reconfigurable reflectarray and array lens designs, and surveys a range of experimental implementations and achievements that have been made in this area in recent years. The paper describes the fundamental design approaches employed in realizing reconfigurable designs, and explores advanced capabilities of these nascent architectures, such as multi-band operation, polarization manipulation, frequency agility, and amplification. Finally, the paper concludes by discussing future challenges and possibilities for these antennas.

physics.optics↗
arXiv2013

Towards Compact and Frequency-Tunable Antenna Solutions for MIMO Transmission with a Single RF Chain

Recently, a technique called beam-space MIMO has been demonstrated as an effective approach for transmitting multiple signals while using a single RF-chain. In this work, we present novel design considerations and a compact antenna solution to stimulate the deployment of beam-space MIMO in future wireless applications. Targeting integration in small wireless devices, the novel antenna is made of a single integrated radiator rather than an array of physically-separated dipoles. It also drastically simplifies the implementation of variable loads and DC bias circuits for BPSK modulated signals, and does not require any external reconfigurable matching circuit. Finally, we show that this antenna system could be reconfigured by dynamic adjustment of terminating loads to preserve its beam-space multiplexing capabilities over a 1:2 tuning range, thereby promoting the convergence of MIMO and dynamic spectrum allocation via reduced-complexity hardware. A prototype achieving single-RF-chain multiplexing at a fixed frequency is designed and measured, showing excellent agreement between simulations and measurements.

cs.IT↗
arXiv2013

Graphene Antennas: Can Integration and Reconfigurability Compensate for the Loss?

In this opening presentation we will first recall the main characteristics of graphene conductivity and electromagnetic wave propagation on graphene-based structures. Based on these observations and different graphene antenna simulations from microwave to Terahertz, we will discuss the issue of antenna efficiency, integration and reconfigurability, as function of the operation frequency range. While the applicability of graphene for antennas at microwave appears limited to particular cases where very low efficiency can be tolerated for integration or transparency purpose, the plasmonic nature of graphene conductivity at terahertz frequency allows unprecedented antenna properties and in particular efficient dynamic reconfiguration.

physics.optics↗
arXiv2013

Integral Equation Analysis of Plane Wave Scattering by Coplanar Graphene-Strip Gratings in the THz Range

The plane wave scattering and absorption by finite and infinite gratings of free-space standing infinitely long graphene strips are studied in the THz range. A novel numerical approach, based on graphene surface impedance, hyper-singular integral equations, and the Nystrom method, is proposed. This technique guarantees fast convergence and controlled accuracy of computations. Reflectance, transmittance, and absorbance are carefully studied as a function of graphene and grating parameters, revealing the presence of surface plasmon resonances. Specifically, larger graphene relaxation times increases the number of resonances in the THz range, leading to higher wave transmittance due to the reduced losses; on the other hand an increase of graphene chemical potential up-shifts the frequency of plasmon resonances. It is also shown that a relatively low number of graphene strips (>10) are able to reproduce Rayleigh anomalies. These features make graphene strips good candidates for many applications, including tunable absorbers and frequency selective surfaces.

cond-mat.mes-hall↗
arXiv2012

Tunable Graphene Reflective Cells for THz Reflectarrays and Generalized Law of Reflection

A tunable graphene-based reflective cell operating at THz is proposed for use in reconfigurable-beam reflectarrays, or similarly to implement the so-called generalized law of reflection. The change in the complex conductivity of graphene when biased by an electric field allows controlling the phase of the reflected field at each element of the array. Additionally, the slow wave propagation supported by graphene drastically reduces the dimensions of the cell, which allows smaller inter-element spacing hence better array performance. An elementary cell is optimized and its scattering parameters computed, demonstrating a dynamic phase range of 300 degrees and good loss figure for realistic chemical potential variations. Finally, a circuit model is proposed and shown to very accurately predict the element response.

physics.optics↗
arXiv2012

Manipulation of Giant Faraday Rotation in Graphene Metasurfaces

Faraday rotation is a fundamental magneto-optical phenomenon used in various optical control and magnetic field sensing techniques. Recently, it was shown that a giant Faraday rotation can be achieved in the low-THz regime by a single monoatomic graphene layer. Here, we demonstrate that this exceptional property can be manipulated through adequate nano-patterning, notably achieving giant rotation up to 6THz with features no smaller than 100nm. The effect of the periodic patterning on the Faraday rotation is predicted by a simple physical model, which is then verified and refined through accurate full-wave simulations.

physics.optics↗