arXiv subjects

Junichiro Shiomi

Publications and source records attributed to Junichiro Shiomi.

65 records · Page 4Linked to original sources

arXiv2015

Crystal structure dependent thermal conductivity in two-dimensional phononic crystal nanostructures

Thermal phonon transport in square- and triangular-lattice Si phononic crystal (PnC) nanostructures with a period of 300 nm was investigated by measuring the thermal conductivity using micrometer-scale time-domain thermoreflectance. The placement of circular nanoholes has a strong influence on thermal conductivity when the periodicity is within the range of the thermal phonon mean free path. A staggered hole structure, i.e., a triangular lattice, has lower thermal conductivity, where the difference in thermal conductivity depends on the porosity of the structure. The largest difference in conductivity of approximately 20% was observed at a porosity of around 30%. This crystal structure dependent thermal conductivity can be understood by considering the local heat flux disorder created by a staggered hole structure. Numerical simulation using the Monte Carlo technique was also employed and also showed the lower thermal conductivity for a triangular lattice structure. Besides gaining a deeper understanding of nanoscale thermal phonon transport, this information would be useful in the design of highly efficient thermoelectric materials created by nanopatterning.

cond-mat.mes-hall↗

arXiv2014

Surface structure determines dynamic wetting

Liquid wetting of a surface is omnipresent in nature and the advance of micro-fabrication and assembly techniques in recent years offers increasing ability to control this phenomenon. Here, we identify how surface roughness influences the initial dynamic spreading of a partially wetting droplet by studying the spreading on a solid substrate patterned with microstructures just a few micrometers in size. We reveal that the roughness influence can be quantified in terms of a line friction coefficient for the energy dissipation rate at the contact line, and that this can be described in a simple formula in terms of the geometrical parameters of the roughness and the line-friction coefficient of the planar surface. We further identify a criterion to predict if the spreading will be controlled by this surface roughness or by liquid inertia. Our results point to the possibility of selectively controlling the wetting behavior by engineering the surface structure.

physics.flu-dyn↗

arXiv2014

Quantitative Temperature Dependence of Longitudinal Spin Seebeck Effect at High Temperatures

This article reports temperature-dependent measurements of longitudinal spin Seebeck effects (LSSEs) in Pt/Y$_3$Fe$_5$O$_{12}$ (YIG)/Pt systems in a high temperature range from room temperature to above the Curie temperature of YIG. The experimental results show that the magnitude of the LSSE voltage in the Pt/YIG/Pt systems rapidly decreases with increasing the temperature and disappears above the Curie temperature. The critical exponent of the LSSE voltage in the Pt/YIG/Pt systems at the Curie temperature was estimated to be 3, which is much greater than that for the magnetization curve of YIG. This difference highlights the fact that the mechanism of the LSSE cannot be explained in terms of simple static magnetic properties in YIG.

cond-mat.mtrl-sci↗

arXiv2014

Thermal Interface Conductance between Aluminum and Silicon by Molecular Dynamics Simulations

The thermal interface conductance between Al and Si was simulated by a non-equilibrium molecular dynamics method. In the simulations, the coupling between electrons and phonons in Al are considered by using a stochastic force. The results show the size dependence of the interface thermal conductance and the effect of electron-phonon coupling on the interface thermal conductance. To understand the mechanism of interface resistance, the vibration power spectra are calculated. We find that the atomic level disorder near the interface is an important aspect of interfacial phonon transport, which leads to a modification of the phonon states near the interface. There, the vibrational spectrum near the interface greatly differs from the bulk. This change in the vibrational spectrum affects the results predicted by AMM and DMM theories and indicates new physics is involved with phonon transport across interfaces. Keywords:

cond-mat.mtrl-sci↗

arXiv2013

Gallium Arsenide Thermal Conductivity and Optical Phonon Relaxation Times from First-Principles Calculations

In this paper, thermal conductivity of crystalline GaAs is calculated using first-principles lattice dynamics. The harmonic and cubic force constants are obtained by fitting them to the force-displacement data from density functional theory calculations. Phonon dispersion is calculated from dynamical matrix constructed using the harmonic force constants and phonon relaxation times are calculated using Fermi Golden rule. The calculated GaAs thermal conductivity agrees well with experimental data. Thermal conductivity accumulations as a function of phonon mean free path and as a function of wavelength are obtained. Our results predict significant size effect on the GaAs thermal conductivity in the nanoscale. Relaxation times of optical phonons and their contributions from different scattering channels are also studied. Such information will help understanding hot phonon effects in GaAs-based devices.

cond-mat.mtrl-sci↗

arXiv2012

Microscopic mechanism of low thermal conductivity in lead-telluride

The microscopic physics behind low lattice thermal conductivity of single crystal rocksalt lead telluride (PbTe) is investigated. Mode-dependent phonon (normal and umklapp) scattering rates and their impact on thermal conductivity were quantified by the first-principles-based anharmonic lattice dynamics calculations that accurately reproduce thermal conductivity in a wide temperature range. The low thermal conductivity of PbTe is attributed to the scattering of longitudinal acoustic phonons by transverse optical phonons with large anharmonicity, and small group velocity of the soft transverse acoustic phonons. This results in enhancing the relative contribution of optical phonons, which are usually minor heat carrier in bulk materials.

cond-mat.mtrl-sci↗

arXiv2011

Reduction of Phonon Lifetimes and Thermal Conductivity of a Carbon Nanotube on Amorphous Silica

We use molecular dynamics simulations to examine the phonon lifetimes in (10,10) carbon nano-tubes (CNTs), both when isolated and when supported on amorphous SiO2 substrates. We deter-mine the Umklapp, normal, boundary and CNT-substrate phonon scattering rates from the com-puted inverse lifetimes. Suspended CNTs have in-plane optical phonon lifetimes between 0.7-2 ps, consistent with recent experiments, but contact with the substrate leads to a lifetime reduction to the 0.6-1.3 ps range. The thermal conductivity of the supported CNT is also computed to be ~30 percent lower than that of the isolated CNT. The thermal boundary conductance estimated from the CNT-substrate phonon scattering rates is in good agreement with that computed from the Green-Kubo relation and with previous experimental results. The results highlight that solid substrates can strongly affect and could be even used to tune the thermal properties of CNTs.

cond-mat.mes-hall↗

arXiv2008

Water transport inside a single-walled carbon nanotube driven by temperature gradient

In this work, by means of molecular dynamics simulations, we consider mass transport of a water cluster inside a single-walled carbon nanotube (SWNT) with the diameter of about 1.4 nm. The influence of the non-equilibrium thermal environment on the confined water cluster has been investigated by imposing a longitudinal temperature gradient to the SWNT. It is demonstrated that the water cluster is transported with the average acceleration proportional to the temperature gradient. Additional equilibrium simulations suggest that the temperature dependence of the potential energy of the confined water is sufficient to realize the transport. Particularly for the system with hydrophobic interface, the water-water intrinsic potential energy appears to play a dominant role. The transport simulations were also performed for a system with a junction between two different SWNTs. The results suggest that an angstrom difference in diameter may result in large barrier for water transported through a small diameter SWNT.

cond-mat.other↗

arXiv2007

Electrothermal flow in Dielectrophoresis of Single-Walled Carbon Nanotubes

We theoretically investigate the impact of the electrothermal flow on the dielectrophoretic separation of single-walled carbon nanotubes (SWNT). The electrothermal flow is observed to control the motions of semiconducting SWNTs in a sizeable domain near the electrodes under typical experimental conditions, therefore helping the dielectrophoretic force to attract semiconducting SWNTs in a broader range. Moreover, with the increase of the surfactant concentration, the electrothermal flow is enhanced, and with the change of frequency, the pattern of the electrothermal flow changes. It is shown that under some typical experimental conditions of dielectrophoresis separation of SWNTs, the electrothermal flow is a dominating factor in determining the motion of SWNTs.

cond-mat.mtrl-sci↗

arXiv2007

Molecular dynamics of ice-nanotube formation inside carbon nanotubes

The first order phase transition of a water cluster confined in a dynamic single-walled carbon nanotube is investigated using a classical molecular dynamics (MD) method. The formation of ice-nanotube is monitored through the structure factor and potential energies. The transition temperature and its diameter dependence obtained by the simulations agree well with those of previously reported experiments. The transition temperature of the ice-nanotube was shown to take a maximum value of around room temperature with the number of the ring members n=5. Potential energy contribution to the phase change is generally dominated by that of the intrinsic water-water interaction, while that of water-carbon interaction plays a significant role on determining the dependence of transition temperature on the nanotube diameter.

cond-mat.mtrl-sci↗

arXiv2006

Heat conduction of single-walled carbon nanotube isotope-superlattice structures: A molecular dynamics study

Heat conduction of single-walled carbon nanotubes (SWNTs) isotope-superlattice is investigated by means of classical molecular dynamics simulations. Superlattice structures were formed by alternately connecting SWNTs with different masses. On varying the superlattice period, the critical value with minimum effective thermal conductivity was identified, where dominant physics switches from zone-folding effect to thermal boundary resistance of lattice interface. The crossover mechanism is explained with the energy density spectra where zone-folding effects can be clearly observed. The results suggest that the critical superlattice period thickness depends on the mean free path distribution of diffusive-ballistic phonons. The reduction of the thermal conductivity with superlattice structures beats that of the one-dimensional alloy structure, though the minimum thermal conductivity is still slightly higher than the value obtained by two-dimensional random mixing of isotopes.

cond-mat.mtrl-sci↗