arXiv subjects

K. Põder

Publications and source records attributed to K. Põder.

7 recordsLinked to original sources

arXiv2025

Updated baseline design for HALHF: the hybrid, asymmetric, linear Higgs factory

Particle physicists aim to construct a electron-positron Higgs factory as the next major particle collider. However, the high associated costs motivate the development of more affordable collider designs. Plasma-wakefield acceleration is a promising technology to this end. HALHF is a proposal for a Higgs factory that utilizes beam-driven plasma-wakefield acceleration to accelerate electrons to high energy with high gradient, while using radio-frequency acceleration to accelerate positrons to a lower energy. This asymmetry sidesteps a major difficulty in plasma acceleration: that of accelerating positrons with high efficiency and quality. Since publication, several challenges were identified in the original baseline design. We summarize the updated baseline design, which addresses these challenges, and describe the parameter- and cost-optimization process used to arrive at this design.

physics.acc-ph↗

arXiv2025

Bounding elastic photon-photon scattering at $\sqrt s \approx 1\,$MeV using a laser-plasma platform

We report on a direct search for elastic photon-photon scattering using x-ray and $γ$ photons from a laser-plasma based experiment. A gamma photon beam produced by a laser wakefield accelerator provided a broadband gamma spectrum extending to above $E_γ= 200$ MeV. These were collided with a dense x-ray field produced by the emission from a laser heated germanium foil at $E_x \approx 1.4$ keV, corresponding to an invariant mass of $\sqrt{s} = 1.22 \pm 0.22$ MeV. In these asymmetric collisions elastic scattering removes one x-ray and one high-energy $γ$ photon and outputs two lower energy $γ$ photons. No changes in the $γ$ photon spectrum were observed as a result of the collisions allowing us to place a 95% upper bound on the cross section of $1.5 \times 10^{15}\,μ$b. Although far from the QED prediction, this represents the lowest upper limit obtained so far for $\sqrt{s} \lesssim 1$ MeV.

hep-ex↗

arXiv2024

Controlled Injection in a Laser Plasma Accelerator via an Optically Generated Waveguide Constriction

We propose a novel scheme for controlling the injection of a high-quality electron bunch into a channel-guided laser plasma accelerator. This all-optical technique, constricted waveguide injection, creates a highly tunable controlled injection structure natively within a plasma waveguide, a key requirement for efficient acceleration of high-quality multi-GeV electron beams. We describe a simple optical setup to tailor the plasma and present start-to-end simulations showing the injection structure formation and the generation of a 1.1 GeV electron beam with 10 pC of charge and 0.35 % energy spread using 1 J of drive laser energy. Highly tunable tailored plasma sources, like those proposed here, enable fine control over the injection and acceleration processes and thus will be crucial for the development of application-focused laser plasma accelerators.

physics.acc-ph↗

arXiv2022

Longitudinally resolved measurement of energy-transfer efficiency in a plasma-wakefield accelerator

Energy-transfer efficiency is an important quantity in plasma-wakefield acceleration, especially for applications that demand high average power. Conventionally, the efficiency is measured using an electron spectrometer; an invasive method that provides an energy-transfer efficiency averaged over the full length of the plasma accelerator. Here, we experimentally demonstrate a novel diagnostic utilizing the excess light emitted by the plasma after a beam-plasma interaction, which yields noninvasive, longitudinally resolved measurements of the local energy-transfer efficiency from the wake to the accelerated bunch; here, as high as (58 $\pm$ 3)%. This method is suitable for online optimization of individual stages in a future multistage plasma accelerator, and enables experimental studies of the relation between efficiency and transverse instability in the acceleration process.

physics.acc-ph↗

arXiv2022

Confined Continuous-Flow Plasma Source For High-Average-Power Laser Plasma Acceleration

Over the last decades, significant advances in high-power laser systems have enabled rapid progress in the development of laser-driven plasma accelerators. Today, the results obtained in beam stability and reproducibility present laser plasma acceleration as a viable and promising alternative to conventional accelerators. As several electron beam and secondary sources applications require high average currents, a major focus is now on increasing the beam's repetition rate. In the following, we introduce a novel plasma source for kHz electron acceleration, providing a continuous and spatially confined gas flow, while minimising the gas load in the acceleration chamber.

physics.acc-ph↗

arXiv2020

Automation and control of laser wakefield accelerators using Bayesian optimisation

Laser wakefield accelerators promise to revolutionise many areas of accelerator science. However, one of the greatest challenges to their widespread adoption is the difficulty in control and optimisation of the accelerator outputs due to coupling between input parameters and the dynamic evolution of the accelerating structure. Here, we use machine learning techniques to automate a 100 MeV-scale accelerator, which optimised its outputs by simultaneously varying up to 6 parameters including the spectral and spatial phase of the laser and the plasma density and length. Most notably, the model built by the algorithm enabled optimisation of the laser evolution that might otherwise have been missed in single-variable scans. Subtle tuning of the laser pulse shape caused an 80% increase in electron beam charge, despite the pulse length changing by just 1%.

physics.acc-ph↗

arXiv2020

Evolution of longitudinal plasma-density profiles in discharge capillaries for plasma wakefield accelerators

Precise characterization and tailoring of the spatial and temporal evolution of plasma density within plasma sources is critical for realizing high-quality accelerated beams in plasma wakefield accelerators. The simultaneous use of two independent diagnostic techniques allowed the temporally and spatially resolved detection of plasma density with unprecedented sensitivity and enabled the characterization of the plasma temperature at local thermodynamic equilibrium in discharge capillaries. A common-path two-color laser interferometer for obtaining the average plasma density with a sensitivity of $2\times 10^{15}$ cm$^{-2}$ was developed together with a plasma emission spectrometer for analyzing spectral line broadening profiles with a resolution of $5\times 10^{15}$ cm$^{-3}$. Both diagnostics show good agreement when applying the spectral line broadening analysis methodology of Gigosos and Carde{ñ}oso. Measured longitudinally resolved plasma density profiles exhibit a clear temporal evolution from an initial flat-top to a Gaussian-like shape in the first microseconds as material is ejected out from the capillary, deviating from the often-desired flat-top profile. For plasma with densities of 0.5-$2.5\times 10^{17}$ cm$^{-3}$, temperatures of 1-7 eV were indirectly measured. These measurements pave the way for highly detailed parameter tuning in plasma sources for particle accelerators and beam optics.

physics.plasm-ph↗