arXiv subjects

K. P. Skokov

Publications and source records attributed to K. P. Skokov.

4 recordsLinked to original sources

arXiv2023

A multi-stage, first-order phase transition in LaFe11.8Si1.2: interplay between the structural, magnetic and electronic degrees of freedom

Alloys with a first-order magnetic transition are central to solid-state refrigeration technology, sensors and actuators, or spintronic devices. The discontinuous nature of the transition in these materials is a consequence of the coupling between the magnetic, electronic and structural subsystems, but in a real experiment, it is difficult to observe and analyze the simultaneous evolution of all the subsystems. As a result, it is very hard to determine the main mechanisms of the transition and purposefully develop these advanced magnetic materials. To resolve this issue, we changed the existing paradigm and conducted simultaneous measurements of the macroscopic properties - magnetization, temperature change of the sample, longitudinal and transversal magnetostrictions - to reveal the rich details of the magneto-structural, first-order transition occurring in the prototypical alloy LaFe11.8Si1.2. We complement these findings with experiments on the atomistic scale, i.e., x-ray absorption spectroscopy (XAS), x-ray magnetic circular dichroism (XMCD) and Mössbauer spectroscopy, and then combine them with first-principles calculations to reveal the full complexity and two-stage nature of the transition. This new approach can be successfully extended to a large class of advanced magnetic materials that exhibit analogous transformations.

cond-mat.mtrl-sci↗

arXiv2021

Influence of the martensitic transformation kinetics on the magnetocaloric effect in Ni-Mn-In

The inverse magnetocaloric effect (MCE) in Ni-Mn-based Heusler compounds occurs during the magnetostructural transition between low-temperature, low-magnetization martensite and high-temperature, high-magnetization austenite. In this study, we analyze the metamagnetic transformation of a $Ni_{49.8}Mn_{35}In_{15.2}$ compound by simultaneous adiabatic temperature change and strain measurements in pulsed magnetic fields up to 10 T. We observe an adiabatic temperature change of -10 K and a strain of -0.22 % when the reverse martensitic transition is fully induced at a starting temperature of 285 K. By a variation of the magnetic field-sweep rates between 316 Ts$^{-1}$, 865 Ts$^{-1}$ and 1850 Ts$^{-1}$, the transitional dynamics of the reverse martensitic transformation have been investigated. Our experiments reveal an apparent delay upon the end of the reverse martensitic transformation at field rates exceeding 865 Ts$^{-1}$ which is related to the annihilation of retained martensite. As a consequence, the field hysteresis increases and higher fields are required to saturate the transition. In contrast, no time-dependent effects on the onset of the reverse martensitic transformation were observed in the studied field-sweep range. Our results demonstrate that kinetic effects in Heusler compounds strongly affect the magnetic cooling cycle, especially when utilising a multicaloric "exploiting-hysteresis cycle" where high magnetic field-sweep rates are employed.

cond-mat.mtrl-sci↗

arXiv2019

Dynamics of the magnetoelastic phase transition and adiabatic temperature change in Mn1.3Fe0.7P0.5Si0.55

The adiabatic temperature change DTad of a Mn1.3Fe0.7P0.5Si0.55 Fe2P-type alloy was measured under different magnetic field-sweep rates from 0.93 Ts-1 to 2870 Ts-1. We find a field-sweep-rate independent magnetocaloric effect due to a partial alignment of magnetic moments in the paramagnetic region overlapping with the magnetocaloric effect of the first-order phase transition. Additionally, the first-order phase transition is not completed even in fields up to 20 T leading to a non-saturating behavior of DTad. Measurements in different pulsed fields reveal that the first-order phase transition cannot follow the fast field changes as previously assumed, resulting in a distinct field-dependent hysteresis in DTad.

physics.app-ph↗

arXiv2015

Magnetic properties of (Fe$_{1-x}$Co$_x$)$_2$B alloys and the effect of doping by 5$d$ elements

We have explored, computationally and experimentally, the magnetic properties of \fecob{} alloys. Calculations provide a good agreement with experiment in terms of the saturation magnetization and the magnetocrystalline anisotropy energy with some difficulty in describing Co$_2$B, for which it is found that both full potential effects and electron correlations treated within dynamical mean field theory are of importance for a correct description. The material exhibits a uniaxial magnetic anisotropy for a range of cobalt concentrations between $x=0.1$ and $x=0.5$. A simple model for the temperature dependence of magnetic anisotropy suggests that the complicated non-monotonous temperature behaviour is mainly due to variations in the band structure as the exchange splitting is reduced by temperature. Using density functional theory based calculations we have explored the effect of substitutional doping the transition metal sublattice by the whole range of 5$d$ transition metals and found that doping by Re or W elements should significantly enhance the magnetocrystalline anisotropy energy. Experimentally, W doping did not succeed in enhancing the magnetic anisotropy due to formation of other phases. On the other hand, doping by Ir and Re was successful and resulted in magnetic anisotropies that are in agreement with theoretical predictions. In particular, doping by 2.5~at.\% of Re on the Fe/Co site shows a magnetocrystalline anisotropy energy which is increased by 50\% compared to its parent (Fe$_{0.7}$Co$_{0.3}$)$_2$B compound, making this system interesting, for example, in the context of permanent magnet replacement materials or in other areas where a large magnetic anisotropy is of importance.

cond-mat.mtrl-sci↗