arXiv subjects

K. Takata

Publications and source records attributed to K. Takata.

4 recordsLinked to original sources

arXiv2014

Optical and Near-Infrared Polarimetry of Highly Reddened Type Ia Supernova 2014J: Peculiar Properties of Dust in M82

We presented optical and near-infrared multi-band linear polarimetry of the highly reddened Type Ia SN~2014J appeared in M82. SN~2014J exhibits large polarization at shorter wavelengths, e.g., $4.8$\% in $B$ band, and the polarization decreases rapidly at longer wavelengths, with the position angle of the polarization remaining at approximately $40^{\circ}$ over the observed wavelength range. These polarimetric properties suggest that the observed polarization is likely to be caused predominantly by the interstellar dust within M82. Further analysis shows that the polarization peaks at a wavelengths much shorter than those obtained for the Galactic dust. The wavelength dependence of the polarization can be better described by an inverse power law rather than by Serkowski law for Galactic interstellar polarization. These suggests that the nature of the dust in M82 may be different from that in our Galaxy, with polarizing dust grains having a mean radius of $<0.1\ μ$m.

astro-ph.SR↗

arXiv2000

Design, fabrication and measurement of the first rounded damped detuned accelerator structure (RDDS1)

As a joint effort in the JLC/NLC research program, we have developed a new type of damped detuned accelerator structure with optimized round-shaped cavities (RDDS). This paper discusses some important R&D aspects of the first structure in this series (RDDS1). The design aspects covered are the cell design with sub-MHz precision, HOM detuning, coupling and damping technique and wakefield simulation. The fabrication issues covered are ultra-precision cell machining with micron accuracy, assembly and diffusion bonding technologies to satisfactorily meet bookshelf, straightness and cell rotational alignment requirements. The measurements described are the RF properties of single cavities and complete accelerator section, as well as wakefields from the ASSET tests at SLAC. Finally, future improvements are also discussed.

physics.acc-ph↗

arXiv2000

Fabrication Process of Rounded Damped Detuned Structure

Following the successful design and fabrication of Damped Detuned Structures (DDS), the JLC/NLC linear collider project advanced to Rounded Damped Detuned Structures (RDDS) with curved cross section of the cavity shape for increased shunt impedance. Various advanced techniques for fabricating RDDS1 disks comparing to those for DDS were established to satisfy the dimension accuracy of +-1 micron over the entire surface made by ultra-precision turning. These disks were assembled with almost the same stacking and bonding jigs and processes as those of DDS3 assembly. In consequence, the assembly showed little disk-to-disk misalignment within 1 micron before and after the process. Though, it had 200 micron smooth bowing, which was subsequently corrected as DDS3, and flares at both ends.

hep-ex↗

arXiv2000

Meeting Tight Frequency Requirement of Rounded Damped Detuned Structure

Following successful design and fabrication of damped detuned structures, the R&D for the accelerating structures of the NLC/JLC linear collider project proceeded to studies of Rounded Damped Detuned Structure with curved cross section of the cavity shape for increased shunt impedance. The important features of the structure are the accurately tuned accelerating mode frequency and the distribution of the first dipole modes smooth and close to the design distribution. These requirements were met based on the high-accuracy diamond turning with its capability to realize the periphery tolerance of two microns. The lowest dipole mode frequencies scattered by 0.6 MHz RMS. The error in the accelerating mode frequency averaged over a structure was 0.1 MHz by applying a feed-forward method.

hep-ex↗