arXiv subjects

K. Ziȩtara

Publications and source records attributed to K. Ziȩtara.

12 recordsLinked to original sources

arXiv2026

Prospects for the detection of gamma rays using Cherenkov telescopes enhanced by a ground array observatory

We study through detailed simulated data and their optimized analysis the expected performance of the Single-Mirror Small-Size imaging atmospheric Cherenkov Telescopes (SST-1M) potentially located inside a high-altitude array of Water-Cherenkov Detectors (WCDs) inspired by the current foreseen design of the Southern Wide-field Gamma-ray Observatory (SWGO). For such a hybrid setup, we show an improvement in the flux sensitivity above 10 TeV by about 60% for monocular and 30% for stereoscopic SST-1M observation, due to the improved gamma/hadron separation when additional parameters from the WCD array are used. We also discuss further benefits of the hybrid gamma observatory concept and its technical challenges.

astro-ph.IM↗

arXiv2025

The SST-1M stereoscopic system

The Single-Mirror Small-Size Telescope (SST-1M) is an Imaging Atmospheric Cherenkov Telescope designed for detecting very high-energy gamma rays. With a compact design achieved through the adoption of silicon-photomultiplier pixels and a lightweight structure, SST-1M offers a large field of view of about 9° and features a mirror system of 4 m diameter with an optical PSF (at 80% of photon inclusion) of 0.08° on axis and 0.21° at 4° off-axis, and a fully digitizing readout almost deadtime free up to few kHz. The SST-1M achieved a high-performance and cost-effective solution for implementing an array of small-sized telescopes. The stereoscopic system of two SST-1Ms is temporarily installed at the Ondřejov Observatory in the Czech Republic. From an altitude of only about 510 m and in harsh meteorological conditions, the system is detecting galactic sources and flares of AGNs. The accurate calibration of the detector and the simulation benchmark are ongoing. The results of its performance are shown. A future final location is being considered and a future performance outlook is discussed.

astro-ph.IM↗

arXiv2025

The SST-1M imaging atmospheric Cherenkov telescope for gamma-ray astrophysics

The SST-1M is a Small-Sized Telescope (SST) designed to provide a cost-effective and high-performance solution for gamma-ray astrophysics, particularly for energies beyond a few TeV. The goal is to integrate this telescope into an array of similar instruments, leveraging its lightweight design, earthquake resistance, and established Davies-Cotton configuration. Additionally, its optical system is designed to function without a protective dome, allowing it to withstand the harsh atmospheric conditions typical of mountain environments above 2000 m. The SST-1M utilizes a fully digitizing camera system based on silicon photomultipliers (SiPMs). This camera is capable of digitizing all signals from the UV-optical light detectors, allowing for the implementation of various triggers and data analysis methods. We detail the process of designing, prototyping, and validating this system, ensuring that it meets the stringent requirements for gamma-ray detection and performance. An SST-1M stereo system is currently operational and collecting data at the Ondřejov observatory in the Czech Republic, situated at 500 m. Preliminary results from this system are promising. A forthcoming paper will provide a comprehensive analysis of the performance of the telescopes in detecting gamma rays and operating under real-world conditions.

astro-ph.IM↗

arXiv2024

Analysis of commissioning data from SST-1M : A Prototype of Single-Mirror Small Size Telescope

SST-1M is a prototype of a single-mirror Small Size Telescope developed by a consortium of institutes from Poland, Switzerland and the Czech Republic. With a wide field of view of 9 degrees, SST-1Ms are designed to detect gamma-rays in the energy range between 1 and 300 TeV. The design of the SST-1M follows the Davies-Cotton concept, with a 9.42m2 multi-segment mirror. SST-1M is equipped with DigiCam camera, which features a fully digital readout and trigger system using 250 MHz ADC, and a compact Photo-Detector Plane (PDP) composed of 1296 pixels, each made of a hexagonal light guide coupled to silicone photomultipliers (SiPM). Two SST-1M telescopes are currently being commissioned at the Ondrejov Observatory in the Czech Republic, where they are successfully observing Cerenkov events in stereo. This contribution will present an overview of calibration strategies and performance evaluation based on data collected at the observatory.

astro-ph.IM↗

arXiv2021

Development of an advanced SiPM camera for the Large Size Telescope of the Cherenkov Telescope Array

Silicon photomultipliers (SiPMs) have become the baseline choice for cameras of the small-sized telescopes (SSTs) of the Cherenkov Telescope Array (CTA). On the other hand, SiPMs are relatively new to the field and covering large surfaces and operating at high data rates still are challenges to outperform photomultipliers (PMTs). The higher sensitivity in the near infra-red and longer signals compared to PMTs result in higher night sky background rate for SiPMs. However, the robustness of the SiPMs represents a unique opportunity to ensure long-term operation with low maintenance and better duty cycle than PMTs. The proposed camera for large size telescopes will feature $0.05 degree pixels, low power and fast front-end electronics and a fully digital readout. In this work, we present the status of dedicated simulations and data analysis for the performance estimation. The design features and the different strategies identified, so far, to tackle the demanding requirements and the improved performance are described.

astro-ph.IM↗

arXiv2017

Control Software for the SST-1M Small-Size Telescope prototype for the Cherenkov Telescope Array

The SST-1M is a 4-m Davies--Cotton atmospheric Cherenkov telescope optimized to provide gamma-ray sensitivity above a few TeV. The SST-1M is proposed as part of the Small-Size Telescope array for the Cherenkov Telescope Array (CTA), the first prototype has already been deployed. The SST-1M control software of all subsystems (active mirror control, drive system, safety system, photo-detection plane, DigiCam, CCD cameras) and the whole telescope itself (master controller) uses the standard software design proposed for all CTA telescopes based on the ALMA Common Software (ACS) developed to control the Atacama Large Millimeter Array (ALMA). Each subsystem is represented by a separate ACS component, which handles the communication to and the operation of the subsystem. Interfacing with the actual hardware is performed via the OPC UA communication protocol, supported either natively by dedicated industrial standard servers (PLCs) or separate service applications developed to wrap lower level protocols (e.g. CAN bus, camera slow control) into OPC UA. Early operations of the telescope without the camera were already carried out. The camera is fully assembled and is capable to perform data acquisition using artificial light source.

astro-ph.IM↗

arXiv2017

Performance of a small size telescope (SST-1M) camera for gamma-ray astronomy with the Cherenkov Telescope Array

The foreseen implementations of the Small Size Telescopes (SST) in CTA will provide unique insights into the highest energy gamma rays offering fundamental means to discover and under- stand the sources populating the Galaxy and our local neighborhood. Aiming at such a goal, the SST-1M is one of the three different implementations that are being prototyped and tested for CTA. SST-1M is a Davies-Cotton single mirror telescope equipped with a unique camera technology based on SiPMs with demonstrated advantages over classical photomultipliers in terms of duty-cycle. In this contribution, we describe the telescope components, the camera, and the trigger and readout system. The results of the commissioning of the camera using a dedicated test setup are then presented. The performances of the camera first prototype in terms of expected trigger rates and trigger efficiencies for different night-sky background conditions are presented, and the camera response is compared to end-to-end simulations.

astro-ph.IM↗

arXiv2017

Development of a strategy for calibrating the novel SiPM camera of the SST-1M telescope proposed for the Cherenkov Telescope Array

CTA will comprise a sub-array of up to 70 small size telescopes (SSTs) at the southern array. The SST-1M project, a 4 m-diameter Davies Cotton telescope with 9 degrees FoV and a 1296 pixels SiPM camera, is designed to meet the requirements of the next generation ground based gamma-ray observatory CTA in the energy range above 3 TeV. Silicon photomultipliers (SiPM) cameras of gamma-ray telescopes can achieve good performance even during high night sky background conditions. Defining a fully automated calibration strategy of SiPM cameras is of great importance for large scale production validation and online calibration. The SST-1M sub-consortium developed a software compatible with CTA pipeline software (CTApipe). The calibration of the SST-1M camera is based on the Camera Test Setup (CTS), a set of LED boards mounted in front of the camera. The CTS LEDs are operated in pulsed or continuous mode to emulate signal and night sky background respectively. Continuous and pulsed light data analysis allows us to extract single pixel calibration parameters to be used during CTA operation.

astro-ph.HE↗

arXiv2015

Prototype of the SST-1M Telescope Structure for the Cherenkov Telescope Array

A single-mirror small-size (SST-1M) Davies-Cotton telescope with a dish diameter of 4 m has been built by a consortium of Polish and Swiss institutions as a prototype for one of the proposed small-size telescopes for the southern observatory of the Cherenkov Telescope Array (CTA). The design represents a very simple, reliable, and cheap solution. The mechanical structure prototype with its drive system is now being tested at the Institute of Nuclear Physics PAS in Krakow. Here we present the design of the prototype and results of the performance tests of the structure and the drive and control system.

astro-ph.IM↗

arXiv2015

Software design for the control system for Small-Size Telescopes with single-mirror of the Cherenkov Telescope Array

The Small-Size Telescope with single-mirror (SST-1M) is a 4 m Davies-Cotton telescope and is among the proposed telescope designs for the Cherenkov Telescope Array (CTA). It is conceived to provide the high-energy ($>$ few TeV) coverage. The SST-1M contains proven technology for the telescope structure and innovative electronics and photosensors for the camera. Its design is meant to be simple, low-budget and easy-to-build industrially. Each device subsystem of an SST-1M telescope is made visible to CTA through a dedicated industrial standard server. The software is being developed in collaboration with the CTA Medium-Size Telescopes to ensure compatibility and uniformity of the array control. Early operations of the SST-1M prototype will be performed with a subset of the CTA central array control system based on the Alma Common Software (ACS). The triggered event data are time stamped, formatted and finally transmitted to the CTA data acquisition. The software system developed to control the devices of an SST-1M telescope is described, as well as the interface between the telescope abstraction to the CTA central control and the data acquisition system.

astro-ph.IM↗

arXiv2015

Development of the optical system for the SST-1M telescope of the Cherenkov Telescope Array observatory

The prototype of a Davies-Cotton small size telescope (SST-1M) has been designed and developed by a consortium of Polish and Swiss institutions and proposed for the Cherenkov Telescope Array (CTA) observatory. The main purpose of the optical system is to focus the Cherenkov light emitted by extensive air showers in the atmosphere onto the focal plane detectors. The main component of the system is a dish consisting of 18 hexagonal mirrors with a total effective collection area of 6.47 m2 (including the shadowing and estimated mirror reflectivity). Such a solution was chosen taking into account the analysis of the Cherenkov light propagation and based on optical simulations. The proper curvature and stability of the dish is ensured by the mirror alignment system and the isostatic interface to the telescope structure. Here we present the design of the optical subsystem together with the performance measurements of its components.

astro-ph.IM↗

arXiv2015

Performance of the SST-1M telescope for the Cherenkov Telescope Array observatory

The single mirror small-size telescope (SST-1M) is one of the telescope projects being proposed for the Cherenkov Telescope Array observatory by a sub-consortium of Polish and Swiss institutions. The SST-1M prototype structure is currently being constructed at the Institute of Nuclear Physics in Cracow, Poland, while the camera will be assembled at the University of Geneva, Switzerland. This prototype enables measurements of parameters having a decisive influence on the telescope performance. We present results of numerical simulations of the SST-1M performance based on such measurements. The telescope effective area, the expected trigger rates and the optical point spread function are calculated.

astro-ph.IM↗