arXiv subjects

Kaixuan Zhu

Publications and source records attributed to Kaixuan Zhu.

8 recordsLinked to original sources

arXiv2026

Power-Bandwidth Scaling of Resonantly Coupled Soliton Microcombs

A soliton microcomb requires increasing pump power as its optical bandwidth is broadened. Resonant pumping through an auxiliary microresonator can reduce the power required to sustain a soliton, but simultaneously increases the power required for soliton formation. We show that this competition leads to optimal inter-resonator coupling, and the predicted minimum input pump power scales as the two-thirds power of the comb bandwidth, in contrast to the quadratic scaling under direct pumping. Experiments support the opposing power trends, providing a design rule for power-efficient, ultra-broadband soliton microcombs.

physics.optics↗

arXiv2025

Integrated soliton microcombs beyond the turnkey limit

Soliton microcombs generated in optical microresonators are accelerating the transition of optical frequency combs from laboratory instruments to industrial platforms. Self injection locking (SIL) enables direct driving of soliton microcombs by integrated lasers, providing turnkey initiation and improved coherence, but it also pins the pump close to resonance, limiting both spectral span and tuning flexibility. Here we theoretically and experimentally demonstrate that introducing a thermally tunable auxiliary microresonator extends the bandwidth of SIL soliton microcombs. By engineering hybridization of the pumped resonance, we achieve deterministic access to single soliton states and then push operation into a far detuned regime inaccessible to direct initiation. The resulting combs reach a near 200 nm span at a 25 GHz repetition rate, while preserving the SIL-enabled noise suppression throughout. Moreover, the added degree of freedom afforded by the coupled resonator architecture enables orthogonal control of the comb's repetition rate and center frequency. These advances expand the spectral reach and controllability of integrated soliton microcombs for information processing and precision metrology.

physics.optics↗

arXiv2025

Electrically-pumped soliton microcombs on thin-film lithium niobate

Thin-film lithium niobate (TFLN) has enabled efficient on-chip electro-optic modulation and frequency conversion for information processing and precision measurement. Extending these capabilities with optical frequency combs unlocks massively parallel operations and coherent optical-to-microwave transduction, which are achievable in TFLN microresonators via Kerr microcombs. However, fully integrated Kerr microcombs directly driven by semiconductor lasers remain elusive, which has delayed integration of these technologies. Here we demonstrate electrically pumped TFLN Kerr microcombs without optical amplification. With optimized laser-to-chip coupling and optical quality factors, we generate soliton microcombs at a 200 GHz repetition frequency with an optical span of 180 nm using only 25 mW of pump power. Moreover, self-injection locking enables turnkey initiation and substantially narrows the laser linewidth. Our work provides integrated comb sources for TFLN-based communicational, computational, and metrological applications.

physics.optics↗

arXiv2025

Power-efficient ultra-broadband soliton microcombs in resonantly-coupled microresonators

The drive to miniaturize optical frequency combs for practical deployment has spotlighted microresonator solitons as a promising chip-scale candidate. However, these soliton microcombs could be very power-hungry when their span increases, especially with fine comb spacings. As a result, realizing an octave-spanning comb at microwave repetition rates for direct optical-microwave linkage is considered not possible for photonic integration due to the high power requirements. Here, we introduce the concept of resonant-coupling to soliton microcombs to reduce pump consumption significantly. Compared to conventional waveguide-coupled designs, we demonstrate (i) a threefold increase in spectral span for high-power combs and (ii) up to a tenfold reduction in repetition frequency for octave-spanning operation. This configuration is compatible with laser integration and yields reliable, turnkey soliton generation. By eliminating the long-standing pump-power bottleneck, microcombs will soon become readily available for portable optical clocks, massively parallel data links, and field-deployable spectrometers.

physics.optics↗

arXiv2025

Compact Turnkey Soliton Microcombs at Microwave Rates via Wafer-Scale Fabrication

Soliton microcombs generated in nonlinear microresonators facilitate the photonic integration of timing, frequency synthesis, and astronomical calibration functionalities. For these applications, low-repetition-rate soliton microcombs are essential as they establish a coherent link between optical and microwave signals. However, the required pump power typically scales with the inverse of the repetition rate, and the device footprint scales with the inverse of square of the repetition rate, rendering low-repetition-rate soliton microcombs challenging to integrate within photonic circuits. This study designs and fabricates silicon nitride microresonators on 4-inch wafers with highly compact form factors. The resonator geometries are engineered from ring to finger and spiral shapes to enhance integration density while attaining quality factors over 10^7. Driven directly by an integrated laser, soliton microcombs with repetition rates below 10 GHz are demonstrated via turnkey initiation. The phase noise performance of the synthesized microwave signals reaches -130 dBc/Hz at 100 kHz offset frequency for 10 GHz carrier frequencies. This work enables the high-density integration of soliton microcombs for chip-based microwave photonics and spectroscopy applications.

physics.optics↗

arXiv2025

Soliton microcombs in X-cut LiNbO3 microresonators

Chip-scale integration of optical frequency combs, particularly soliton microcombs, enables miniaturized instrumentation for timekeeping, ranging, and spectroscopy. Although soliton microcombs have been demonstrated on various material platforms, realizing complete comb functionality on photonic chips requires the co-integration of high-speed modulators and efficient frequency doublers, features that are available in a monolithic form on X-cut thin-film lithium niobate (TFLN). However, the pronounced Raman nonlinearity associated with extraordinary light in this platform has so far precluded soliton microcomb generation. Here, we report the generation of transverse-electric-polarized soliton microcombs with a 25 GHz repetition rate in high-Q microresonators on X-cut TFLN chips. By precisely orienting the racetrack microresonator relative to the optical axis, we mitigate Raman nonlinearity and enable soliton formation under continuous-wave laser pumping. Moreover, the soliton microcomb spectra are extended to 350 nm with pulsed laser pumping. This work expands the capabilities of TFLN photonics and paves the way for the monolithic integration of fast-tunable, self-referenced microcombs.

physics.optics↗

arXiv2024

Dynamics of the quintic wave equation with nonlocal weak damping

This article presents a new scheme for studying the dynamics of a quintic wave equation with nonlocal weak damping in a 3D smooth bounded domain. As an application, the existence and structure of weak, strong, and exponential attractors for the solution semigroup of this equation are obtained. The investigation sheds light on the well-posedness and long-time behavior of nonlinear dissipative evolution equations with nonlinear damping and critical nonlinearity.

math.AP↗

arXiv2024

Broadband microwave-rate dark pulse microcombs in dissipation-engineered LiNbO$_3$ microresonators

Kerr microcombs generated in optical microresonators provide broadband light sources bridging optical and microwave signals. Their translation to thin-film lithium niobate unlocks second-order nonlinear optical interfaces such as electro-optic modulation and frequency doubling for completing comb functionalities. However, the strong Raman response of LiNbO$_3$ has complicated the formation of Kerr microcombs. Until now, dark pulse microcombs, requiring a double balance between Kerr nonlinearity and normal group velocity dispersion as well as gain and loss, have remained elusive in LiNbO$_3$ microresonators. Here, by incorporating dissipation engineering, we demonstrate dark pulse microcombs with 25 GHz repetition frequency and 200 nm span in a high-$Q$ LiNbO$_3$ microresonator. Resonances near the Raman-active wavelengths are strongly damped by controlling phase-matching conditions of a specially designed pulley coupler. The coherence and tunability of the dark pulse microcombs are also investigated. Our work provides a solution to realize high-power microcombs operating at microwave rates on LiNbO$_3$ chips, promising new opportunities for the monolithic integration of applications spanning communication to microwave photonics.

physics.optics↗