SearcharxivSearch

arXiv subjects

Ke Nie

Publications and source records attributed to Ke Nie.

3 recordsLinked to original sources

Fluxonium as a control qubit for bosonic quantum information

Bosonic codes in superconducting resonators are a hardware-efficient avenue for quantum error correction and benefit from favorable error hierarchies provided by long-lived cavities compared to typical superconducting qubits. The required coupling to an ancillary control qubit, however, can negate these benefits by inducing highly detrimental effects such as excess decoherence and undesired nonlinearities. An important question is thus whether a cavity-qubit coupling can be realized that offers readout and control capabilities without spoiling the cavity. Here, motivated by its long lifetime and design flexibility of its Hamiltonian, we experimentally investigate the fluxonium as a control qubit for superconducting cavities. We couple a fluxonium qubit to a superconducting resonator in the strong-dispersive regime and use it to measure the coherence and inherited nonlinearities of the resonator. We then demonstrate universal control by preparing and characterizing resonator Fock states and their superpositions, with fidelities limited by resonator decay in our planar prototype device. Finally, we use the predictability of the resonator's inherited nonlinearities to show numerically that the fluxonium can reach cavity-coupling regimes that eliminate undesirable cavity nonlinearities. These results demonstrate the potential of the fluxonium as a high-performance bosonic control qubit for superconducting cavities.

quant-ph

Readout-induced leakage of the fluxonium qubit

Dispersive readout is widely used to perform high-fidelity measurement of superconducting qubits. Much work has been focused on the qubit readout fidelity, which depends on the achievable signal-to-noise ratio and the qubit relaxation time. As groups have pushed to increase readout fidelity by increasing readout photon number, dispersive readout has been shown to strongly affect the post-measurement qubit state. Such effects hinder the effectiveness of quantum error correction, which requires measurements that both have high readout fidelity and are quantum non-demolition (QND). Here, we experimentally investigate non-QND effects in the fluxonium. We map out the state evolution of fluxonium qubits in the presence of resonator photons and observe that these photons induce transitions in the fluxonium both within and outside the qubit subspace. We numerically model our system and find that transitions to higher-excited states and coupling to an external spurious mode are necessary to explain observed non-QND effects.

quant-ph

Parametrically-controlled microwave-photonic interface for the fluxonium

Converting quantum information from stationary qubits to traveling photons enables both fast qubit initialization and efficient generation of flying qubits for redistribution of quantum information. This conversion can be performed using cavity-sideband transitions. In the fluxonium, however, direct cavity-sideband transitions are forbidden due to parity symmetry. Here we circumvent this parity selection rule by using a three-wave mixing element to couple the fluxonium to a resonator. We experimentally demonstrate a scheme for interfacing the fluxonium with traveling photons through microwave-induced parametric conversion. We perform fast reset on the fluxonium qubit, initializing it with >95% ground-state population. We then implement controlled release and temporal shaping of a flying photon, useful for quantum state transfer and remote entanglement. The simplicity and flexibility of our demonstrated scheme enables fluxonium-based remote entanglement architectures.

quant-ph