arXiv subjects

Klaus Kassner

Publications and source records attributed to Klaus Kassner.

25 records · Page 2Linked to original sources

arXiv2002

Does ohmic heating influence the flow field in thin-layer electrodeposition?

In thin-layer electrodeposition the dissipated electrical energy leads to a substantial heating of the ion solution. We measured the resulting temperature field by means of an infrared camera. The properties of the temperature field correspond closely with the development of the concentration field. In particular we find, that the thermal gradients at the electrodes act like a weak additional driving force to the convection rolls driven by concentration gradients.

nlin.PS↗

arXiv2002

Amplitude equations for systems with long-range interactions

We derive amplitude equations for interface dynamics in pattern forming systems with long-range interactions. The basic condition for the applicability of the method developed here is that the bulk equations are linear and solvable by integral transforms. We arrive at the interface equation via long-wave asymptotics. As an example, we treat the Grinfeld instability, and we also give a result for the Saffman-Taylor instability. It turns out that the long-range interaction survives the long-wave limit and shows up in the final equation as a nonlocal and nonlinear term, a feature that to our knowledge is not shared by any other known long-wave equation. The form of this particular equation will then allow us to draw conclusions regarding the universal dynamics of systems in which nonlocal effects persist at the level of the amplitude description.

cond-mat↗

arXiv2002

Experimental investigation of the initial regime in fingering electrodeposition: dispersion relation and velocity measurements

Recently a fingering morphology, resembling the hydrodynamic Saffman-Taylor instability, was identified in the quasi-two-dimensional electrodeposition of copper. We present here measurements of the dispersion relation of the growing front. The instability is accompanied by gravity-driven convection rolls at the electrodes, which are examined using particle image velocimetry. While at the anode the theory presented by Chazalviel et al. describes the convection roll, the flow field at the cathode is more complicated because of the growing deposit. In particular, the analysis of the orientation of the velocity vectors reveals some lag of the development of the convection roll compared to the finger envelope.

nlin.PS↗

arXiv2002

Why the Bradley aberration cannot be used to measure absolute speeds. A comment

In a recent article in this journal [G. Sardin, Measure of the absolute speed through the Bradley aberration of light beams on a three-axis frame, Europhys. Lett. 53 (2001) 310], Sardin proposed to use the Bradley aberration of light for the construction of a speedometer capable of measuring absolute speeds. The purpose of this comment is to show that the device would not work.

astro-ph↗

arXiv2001

Pattern formation in directional solidification under shear flow. I: Linear stability analysis and basic patterns

An asymptotic interface equation for directional solidification near the absolute stabiliy limit is extended by a nonlocal term describing a shear flow parallel to the interface. In the long-wave limit considered, the flow acts destabilizing on a planar interface. Moreover, linear stability analysis suggests that the morphology diagram is modified by the flow near the onset of the Mullins-Sekerka instability. Via numerical analysis, the bifurcation structure of the system is shown to change. Besides the known hexagonal cells, structures consisting of stripes arise. Due to its symmetry-breaking properties, the flow term induces a lateral drift of the whole pattern, once the instability has become active. The drift velocity is measured numerically and described analytically in the framework of a linear analysis. At large flow strength, the linear description breaks down, which is accompanied by a transition to flow-dominated morphologies, described in a companion paper. Small and intermediate flows lead to increased order in the lattice structure of the pattern, facilitating the elimination of defects. Locally oscillating structures appear closer to the instability threshold with flow than without.

cond-mat↗

arXiv2000

Phase field under stress

A phase-field approach describing the dynamics of a strained solid in contact with its melt is developed. By rigorous asymptotic analysis we show that the sharp-interface limit of this model recovers the continuum model equations for the Grinfeld instability. Moreover, we use our approach to derive hitherto unknown sharp-interface equations for a situation including a field of body forces. The numerical utility of the phase-field approach is demonstrated by comparison with a sharp-interface simulation. We then investigate the dynamics of extended systems within the phase-field model which contains an inherent lower length cutoff, thus avoiding cusp singularities. It is found that a periodic array of grooves generically evolves into a superstructure which arises from a series of imperfect period doublings. For wavenumbers close to the fastest-growing mode of the linear instability, the first period doubling can be obtained analytically. Both the dynamics of an initially periodic array and a random initial structure can be described as a coarsening process with winning grooves temporarily accelerating whereas losing ones decelerate and even reverse their direction of motion.

cond-mat.stat-mech↗

arXiv1999

Influence of uniaxial stress on the lamellar spacing of eutectics

Directional solidification of lamellar eutectic structures submitted to uniaxial stress is investigated. In the spirit of an approximation first used by Jackson and Hunt, we calculate the stress tensor for a two-dimensional crystal with triangular surface, using a Fourier expansion of the Airy function. crystal with triangular surface in contact with its melt, given that a uniaxial external stress is applied. The effect of the resulting change in chemical potential is introduced into the standard model for directional solidification of a lamellar eutectic. This calculation is motivated by an observation, made recently [I. Cantat, K. Kassner, C. Misbah, and H. Müller-Krumbhaar, Phys. Rev. E, in press] that the thermal gradient produces similar effects as a strong gravitational field in the case of dilute-alloy solidification. Therefore, the coupling between the Grinfeld and the Mullins-Sekerka instabilities becomes strong, as the critical wavelength of the former instability gets reduced to a value close to that of the latter. Analogously, in the case of eutectics, the characteristic length scale of the Grinfeld instability should be reduced to a size not extremely far from typical lamellar spacings. In a Jackson-Hunt like approach we average the undercooling, including the stress term, over a pair of lamellae. Following Jackson and Hunt, we assume the selected wavelength to be determined by the minimum undercooling criterion and compute its shift due to the external stress. we realize the shifting of the wavelength by the application of external stress. In addition, we find that in general the volume fraction of the two solid phases is changed by uniaxial stress. Implications for experiments on eutectics are discussed.

cond-mat.stat-mech↗