Searcharxiv⌕ Search

arXiv subjects

Klemens Schüppert

Publications and source records attributed to Klemens Schüppert.

9 recordsLinked to original sources

Ion trap on borosilicate substrate with integrated femtosecond-laser-written waveguide

We present an ion-trap platform on borosilicate glass with an integrated femtosecond-laser-written waveguide for on-chip light delivery. The optical layer is physically separated from the electrode substrate and bonded atop the trap, remaining compatible with silicon-based integration. We engineer single-mode low-loss guidance at 729 nm with tunable mode-field diameter and achieve low-loss curved waveguides down to a radius of curvature of 6 mm. We also extend single-mode operation to a wavelength of 405 nm. The fabrication process is compatible with the industrial fabrication of a single-metal-layer surface-electrode trap, including active fiber alignment and bonding. We validate the platform in a cryogenic trapped-ion system with $^{40}$Ca$^+$, demonstrating trapping, shuttling the ion to a zone in front of the waveguide, and coherent operations driven by 729 nm light delivered through the integrated waveguide. We characterize the effect of the exposed dielectric on the ion and measure stray electric fields that show slow drift at a timescale of hours. The architecture is compatible with hybrid micro-optics (e.g. pick-and-place lenses) to realize single ion addressing and provides a robust, scalable route to integrated light delivery for trapped-ion devices.

quant-ph↗

Femtosecond laser written waveguides in sapphire for visible light delivery

A promising solution for scalable integrated optics of trapped-ion quantum processors are curved waveguides guiding visible light within sapphire bulk material. To the best of our knowledge, no curved waveguides were investigated in sapphire so far, and no measurements of waveguides with visible light in undoped planar sapphire substrates were reported. Here, we demonstrate femtosecond laser writing of depressed cladding waveguides in sapphire. Laser parameters, such as pulse energy, pulse duration, and repetition rate, as well as waveguide geometry parameters, were optimized to guide 728 nm light. This resulted in single-mode waveguides with a propagation loss of 1.9(3) dB/cm. The investigation of curved waveguides showed a sharp increase in total loss for curvature radii below 15 mm. Our results demonstrate the potential of femtosecond laser writing as a powerful technique for creating integrated optical waveguides in the volume of sapphire substrates. Such waveguides could be a building block for integrated optics in trapped-ion quantum processors.

physics.optics↗

Integrating a fiber cavity into a wheel trap for strong ion-cavity coupling

We present an ion trap with an integrated fiber cavity, designed for strong coupling at the level of single ions and photons. The cavity is aligned to the axis of a miniature linear Paul trap, enabling simultaneous coupling of multiple ions to the cavity field. We simulate how charges on the fiber mirrors affect the trap potential, and we test these predictions with an ion trapped in the cavity. Furthermore, we measure micromotion and heating rates in the setup.

quant-ph↗

Heating of a trapped ion induced by dielectric materials

Electric-field noise due to surfaces disturbs the motion of nearby trapped ions, compromising the fidelity of gate operations that are the basis for quantum computing algorithms. We present a method that predicts the effect of dielectric materials on the ion's motion. Such dielectrics are integral components of ion traps. Quantitative agreement is found between a model with no free parameters and measurements of a trapped ion in proximity to dielectric mirrors. We expect that this approach can be used to optimize the design of ion-trap-based quantum computers and network nodes.

quant-ph↗

Microelectromechanical-System-Based Design of a High-Finesse Fiber Cavity Integrated with an Ion Trap

We present a numerical study of a MEMS-based design of a fiber cavity integrated with an ion trap system. Each fiber mirror is supported by a microactuator that controls the mirror's position in three dimensions. The mechanical stability is investigated by a feasibility analysis showing that the actuator offers a stable support of the fiber. The actuators move the fibers' positions continuously with a stroke of more than 10 $μ$m, with mechanical resonance frequencies on the order of kHz. A calculation of the trapping potential shows that a separation between ion and fiber consistent with strong ion-cavity coupling is feasible. Our miniaturized ion-photon interface constitutes a viable approach to integrated hardware for quantum information.

quant-ph↗

Probing surface charge densities on optical fibers with a trapped ion

We describe a novel method to measure the surface charge densities on optical fibers placed in the vicinity of a trapped ion, where the ion itself acts as the probe. Surface charges distort the trapping potential, and when the fibers are displaced, the ion's equilibrium position and secular motional frequencies are altered. We measure the latter quantities for different positions of the fibers and compare these measurements to simulations in which unknown charge densities on the fibers are adjustable parameters. Values ranging from $-10$ to $+50$ e/$μ$m$^2$ were determined. Our results will benefit the design and simulation of miniaturized experimental systems combining ion traps and integrated optics, for example, in the fields of quantum computation, communication and metrology. Furthermore, our method can be applied to any setup in which a dielectric element can be displaced relative to a trapped charge-sensitive particle.

quant-ph↗

Ion-based nondestructive sensor for cavity photon numbers

We dispersively couple a single trapped ion to an optical cavity to extract information about the cavity photon-number distribution in a nondestructive way. The photon-number-dependent AC-Stark shift experienced by the ion is measured via Ramsey spectroscopy. We use these measurements first to obtain the ion-cavity interaction strength. Next, we reconstruct the cavity photon-number distribution for coherent states and for a state with mixed thermal-coherent statistics, finding overlaps above 99% with the calibrated states.

quant-ph↗

Millimeter-long Fiber Fabry-Perot cavities

We demonstrate fiber Fabry-Perot (FFP) cavities with concave mirrors that can be operated at cavity lengths as large as 1.5mm without significant deterioration of the finesse. This is achieved by using a laser dot machining technique to shape spherical mirrors with ultralow roughness and employing single-mode fibers with large mode area for good mode matching to the cavity. Additionally, in contrast to previous FFPs, these cavities can be used over an octave-spanning frequency range with adequate coatings. We also show directly that shape deviations caused by the fiber's index profile lead to a finesse decrease as observed in earlier attempts to build long FFP cavities, and show a way to overcome this problem.

physics.optics↗

Integrated Fiber-Mirror Ion Trap for Strong Ion-Cavity Coupling

We present and characterize fiber mirrors and a miniaturized ion-trap design developed to integrate a fiber-based Fabry-Perot cavity (FFPC) with a linear Paul trap for use in cavity-QED experiments with trapped ions. Our fiber-mirror fabrication process not only enables the construction of FFPCs with small mode volumes, but also allows us to minimize the influence of the dielectric fiber mirrors on the trapped-ion pseudopotential. We discuss the effect of clipping losses for long FFPCs and the effect of angular and lateral displacements on the coupling efficiencies between cavity and fiber. Optical profilometry allows us to determine the radii of curvature and ellipticities of the fiber mirrors. From finesse measurements we infer a single-atom cooperativity of up to $12$ for FFPCs longer than $200 μ$m in length; comparison to cavities constructed with reference substrate mirrors produced in the same coating run indicates that our FFPCs have similar scattering losses. We discuss experiments to anneal fiber mirrors and explore the influence of the atmosphere under which annealing occurs on coating losses, finding that annealing under vacuum increases the losses for our reference substrate mirrors. Our unique linear Paul trap design provides clearance for such a cavity and is miniaturized to shield trapped ions from the dielectric fiber mirrors. We numerically calculate the trap potential in the absence of fibers. In the experiment additional electrodes can be used to compensate distortions of the potential due to the fibers. Home-built fiber feedthroughs connect the FFPC to external optics, and an integrated nanopositioning system affords the possibility of retracting or realigning the cavity without breaking vacuum.

physics.optics↗