arXiv subjects

Koen Tiels

Publications and source records attributed to Koen Tiels.

27 records · Page 2Linked to original sources

arXiv2018

Data driven discrete-time parsimonious identification of a nonlinear state-space model for a weakly nonlinear system with short data record

Many real world systems exhibit a quasi linear or weakly nonlinear behavior during normal operation, and a hard saturation effect for high peaks of the input signal. In this paper, a methodology to identify a parsimonious discrete-time nonlinear state space model (NLSS) for the nonlinear dynamical system with relatively short data record is proposed. The capability of the NLSS model structure is demonstrated by introducing two different initialisation schemes, one of them using multivariate polynomials. In addition, a method using first-order information of the multivariate polynomials and tensor decomposition is employed to obtain the parsimonious decoupled representation of the set of multivariate real polynomials estimated during the identification of NLSS model. Finally, the experimental verification of the model structure is done on the cascaded water-benchmark identification problem.

eess.SY↗

arXiv2018

A Local Polynomial Approach to Nonparametric Estimation of the Best Linear Approximation of Lithium-Ion Battery From Multiple Datasets

Battery short-term electrical impedance behavior varies between linear, linear time-varying, or nonlinear at different operating conditions. Data-based electrical impedance modeling techniques often model the battery as a linear time-invariant system at all operating conditions. In addition, these techniques require extensive and time consuming experimentation. Often due to sensor failures during experiments, constraints in data acquisition hardware, varying operating conditions, and the slow dynamics of the battery, it is not always possible to acquire data in a single experiment. Hence, multiple experiments must be performed. In this letter, a local polynomial approach is proposed to estimate nonparametrically the best linear approximation of the electrical impedance affected by varying levels of nonlinear distortion, from a series of input current and output voltage data subrecords of arbitrary length.

eess.SY↗

arXiv2018

Structure Discrimination in Block-Oriented Models Using Linear Approximations: A Theoretic Framework

In this paper we show that it is possible to retrieve structural information about complex block-oriented nonlinear systems, starting from linear approximations of the nonlinear system around different setpoints.The key idea is to monitor the movements of the poles and zeros of the linearized models and to reduce the number of candidate models on the basis of these observations. Besides the well known open loop single branch Wiener-, Hammerstein-, and Wiener-Hammerstein systems, we also cover a number of more general structures like parallel (multi branch) Wiener-Hammerstein models, and closed loop block oriented models, including linear fractional representation (LFR) models.

eess.SY↗

arXiv2018

Nonlinear state-space modelling of the kinematics of an oscillating circular cylinder in a fluid flow

The flow-induced vibration of bluff bodies is an important problem of many marine, civil, or mechanical engineers. In the design phase of such structures, it is vital to obtain good predictions of the fluid forces acting on the structure. Current methods rely on computational fluid dynamic simulations (CFD), with a too high computational cost to be effectively used in the design phase or for control applications. Alternative methods use heuristic mathematical models of the fluid forces, but these lack the accuracy (they often assume the system to be linear) or flexibility to be useful over a wide operating range. In this work we show that it is possible to build an accurate, flexible and low-computational-cost mathematical model using nonlinear system identification techniques. This model is data driven: it is trained over a user-defined region of interest using data obtained from experiments or simulations, or both. Here we use a Van der Pol oscillator as well as CFD simulations of an oscillating circular cylinder to generate the training data. Then a discrete-time polynomial nonlinear state-space model is fit to the data. This model relates the oscillation of the cylinder to the force that the fluid exerts on the cylinder. The model is finally validated over a wide range of oscillation frequencies and amplitudes, both inside and outside the so-called lock-in region. We show that forces simulated by the model are in good agreement with the data obtained from CFD.

eess.SY↗

arXiv2018

Comparison of several data-driven nonlinear system identification methods on a simplified glucoregulatory system example

In this paper, several advanced data-driven nonlinear identification techniques are compared on a specific problem: a simplified glucoregulatory system modeling example. This problem represents a challenge in the development of an artificial pancreas for T1DM treatment, since for this application good nonlinear models are needed to design accurate closed-loop controllers to regulate the glucose level in the blood. Block-oriented as well as state-space models are used to describe both the dynamics and the nonlinear behavior of the insulin-glucose system, and the advantages and drawbacks of each method are pointed out. The obtained nonlinear models are accurate in simulating the patient's behavior, and some of them are also sufficiently simple to be considered in the implementation of a model-based controller to develop the artificial pancreas.

eess.SY↗

arXiv2018

Identification of block-oriented nonlinear systems starting from linear approximations: A survey

Block-oriented nonlinear models are popular in nonlinear system identification because of their advantages of being simple to understand and easy to use. Many different identification approaches were developed over the years to estimate the parameters of a wide range of block-oriented nonlinear models. One class of these approaches uses linear approximations to initialize the identification algorithm. The best linear approximation framework and the $ε$-approximation framework, or equivalent frameworks, allow the user to extract important information about the system, guide the user in selecting good candidate model structures and orders, and prove to be a good starting point for nonlinear system identification algorithms. This paper gives an overview of the different block-oriented nonlinear models that can be identified using linear approximations, and of the identification algorithms that have been developed in the past. A non-exhaustive overview of the most important other block-oriented nonlinear system identification approaches is also provided throughout this paper.

eess.SY↗

arXiv2017

Parameter reduction in nonlinear state-space identification of hysteresis

Hysteresis is a highly nonlinear phenomenon, showing up in a wide variety of science and engineering problems. The identification of hysteretic systems from input-output data is a challenging task. Recent work on black-box polynomial nonlinear state-space modeling for hysteresis identification has provided promising results, but struggles with a large number of parameters due to the use of multivariate polynomials. This drawback is tackled in the current paper by applying a decoupling approach that results in a more parsimonious representation involving univariate polynomials. This work is carried out numerically on input-output data generated by a Bouc-Wen hysteretic model and follows up on earlier work of the authors. The current article discusses the polynomial decoupling approach and explores the selection of the number of univariate polynomials with the polynomial degree, as well as the connections with neural network modeling. We have found that the presented decoupling approach is able to reduce the number of parameters of the full nonlinear model up to about 50\%, while maintaining a comparable output error level.

eess.SY↗

arXiv2016

Wiener system identification with generalized orthonormal basis functions

Many nonlinear systems can be described by a Wiener-Schetzen model. In this model, the linear dynamics are formulated in terms of orthonormal basis functions (OBFs). The nonlinearity is modeled by a multivariate polynomial. In general, an infinite number of OBFs is needed for an exact representation of the system. This paper considers the approximation of a Wiener system with finite-order infinite impulse response dynamics and a polynomial nonlinearity. We propose to use a limited number of generalized OBFs (GOBFs). The pole locations, needed to construct the GOBFs, are estimated via the best linear approximation of the system. The coefficients of the multivariate polynomial are determined with a linear regression. This paper provides a convergence analysis for the proposed identification scheme. It is shown that the estimated output converges in probability to the exact output. Fast convergence rates, in the order $O_p({N_F}^{-n_{rep}/2})$, can be achieved, with $N_F$ the number of excited frequencies and $n_{rep}$ the number of repetitions of the GOBFs.

eess.SY↗

arXiv2016

Initial estimates for Wiener-Hammerstein models using phase-coupled multisines

Block-oriented models are often used to model nonlinear systems. These models consist of linear dynamic (L) and nonlinear static (N) sub-blocks. This paper addresses the generation of initial estimates for a Wiener-Hammerstein model (LNL cascade). While it is easy to measure the product of the two linear blocks using a Gaussian excitation and linear identification methods, it is difficult to split the global dynamics over the individual blocks. This paper first proposes a well-designed multisine excitation with pairwise coupled random phases. Next, a modified best linear approximation is estimated on a shifted frequency grid. It is shown that this procedure creates a shift of the input dynamics with a known frequency offset, while the output dynamics do not shift. The resulting transfer function, which has complex coefficients due to the frequency shift, is estimated with a modified frequency domain estimation method. The identified poles and zeros can be assigned to either the input or output dynamics. Once this is done, it is shown in the literature that the remaining initialization problem can be solved much easier than the original one. The method is illustrated on experimental data obtained from the Wiener-Hammerstein benchmark system.

eess.SY↗