arXiv subjects

Konrad Briggl

Publications and source records attributed to Konrad Briggl.

3 recordsLinked to original sources

arXiv2026

High-Resolution Timing for Vertex-Reconstructed Muon-Spin Spectroscopy Using Plastic Scintillators and MuTRiG

Vertex-reconstructed muon-spin spectroscopy (vx-{\mu}SR) based on silicon pixel detectors has recently demonstrated unprecedented lateral resolution and operation at muon stop rates exceeding 400 kHz. However, the intrinsic timing resolution of current silicon pixel detector technology limits the accessible frequency range and restricts {\mu}SR measurements with fast relaxation rates. In this work, we report on the integration of plastic scintillator detectors (PSD) read out with the MuTRiG ASIC into the MuSiP vx-{\mu}SR spectrometer. This complements the spatial resolution achieved by using silicon pixel detectors with high-precision timing information for incoming muons and decay positrons. We demonstrate stable operation of MuTRiG in vacuum and achieve sub-300 ps time resolution after time-walk correction. Standard transverse-field {\mu}SR measurements on a SiO$_2$ sample confirm that the combined MuTRiG-PSD system resolves precession frequencies beyond 50 MHz, far exceeding the capabilities of silicon pixel detectors alone. These results establish a viable and scalable path towards high-rate, high-resolution {\mu}SR with both excellent spatial and temporal performance.

physics.ins-det↗

arXiv2021

The Mu3e Data Acquisition

The Mu3e experiment aims to find or exclude the lepton flavour violating decay $μ^+\to e^+e^-e^+$ with a sensitivity of one in 10$^{16}$ muon decays. The first phase of the experiment is currently under construction at the Paul Scherrer Institute (PSI, Switzerland), where beams with up to 10$^8$ muons per second are available. The detector will consist of an ultra-thin pixel tracker made from High-Voltage Monolithic Active Pixel Sensors (HV-MAPS), complemented by scintillating tiles and fibres for precise timing measurements. The experiment produces about 100 Gbit/s of zero-suppressed data which are transported to a filter farm using a network of FPGAs and fast optical links. On the filter farm, tracks and three-particle vertices are reconstructed using highly parallel algorithms running on graphics processing units, leading to a reduction of the data to 100 Mbyte/s for mass storage and offline analysis. The paper introduces the system design and hardware implementation of the Mu3e data acquisition and filter farm.

physics.ins-det↗

arXiv2020

Evaluation of the KLauS ASIC at low temperature

The Taishan Antineutrino Observatory (TAO) is proposed to first use a cold liquid scintillator detector (-50~$^\circ$C) equipped with large-area silicon photomultipliers (SiPMs) ($\sim$10~m$^2$) to precisely measure the reactor antineutrino spectrum with a record energy resolution of < 2\% at 1 MeV. The KLauS ASIC shows excellent performance at room temperature and is a potential readout solution for TAO. In this work, we report evaluations of the fifth version of the KLauS ASIC (KLauS5) from room temperature to -50~$^\circ$C with inputs of injected charge or SiPMs. Our results show that KLauS5 has good performance at the tested temperatures with no significant degradation of the charge noise, charge linearity, gain uniformity or recovery time. Meanwhile, we also observe that several key parameters degrade when the chip operates in cold conditions, including the dynamic range and power consumption. However, even with this degradation, a good signal-to-noise ratio and good resolution of a single photoelectron can still be achieved for the tested SiPM with a gain of greater than 1.5$\times$10$^6$ and even an area of SiPM up to 1~cm$^2$ in one channel, corresponding to an input capacitance of approximately 5~nF. Thus, we conclude that KLauS5 can fulfill the TAO requirements for precise charge measurement.

physics.ins-det↗