Kumar Saumya | Searcharxiv

arXiv2026

Round-Robin Test of a Light-Emitting Electrochemical Cell: Establishing a Reference Protocol for Quality Research

Emerging technologies benefit from a jointly established reference protocol, which can lower the bar of entry for new researchers while serving as a calibration standard for established actors. The light-emitting electrochemical cell (LEC) combines electrochemistry and optoelectronics in an intricate manner, and it can by that enable sustainable and commercially relevant printing fabrication of emissive thin-film devices. However, LEC performance is sensitive to a range of material and processing parameters, which frequently results in inadequate, or even erroneous, device evaluation. With this in mind, we present herein a LEC reference protocol, which details the sourcing of materials and the procedures and parameters for robust device fabrication and operation. The protocol has been tested across nine international research groups, and the collected results from this interlaboratory round-robin test confirm that good LEC performance can be reproducibly obtained following our protocol. We also identify common pitfalls that can arise during LEC development, and present practical steps for attaining optimum LEC performance. We hope this reference protocol will improve the quality of future LEC research and serve as a guide for future researchers entering this vibrant field.

cond-mat.soft↗

arXiv2025

In-operando dipole orientation for bipolar injection from air-stable electrodes into organic semiconductors

Efficient charge-carrier injection from air-stable electrodes into organic semiconductors (OSCs) is essential for fabricating solution-processed organic optoelectronic devices under ambient conditions. Today, this is typically achieved by incorporating doped OSC interlayers, introducing self-assembled dipole monolayers, or adding mobile ions to the active material (AM). Here, we demonstrate an alternative approach that eliminates the need for additional injection layers or ionic additives. We achieve this by blending the dipolar compound TMPE-OH into the electroluminescent polymer Super Yellow (SY) and depositing this sole AM between two air-stable electrodes, forming a single-layer, dipole-doped OLED (D-OLED). By tracking its transient voltage-luminance response, performing impedance spectroscopy, and comparing these characteristics with two other single-layer device concepts, i.e. a neat-SY OLED without a dipolar compound and a light-emitting electrochemical cell (LEC) containing mobile ions, we can establish that the auxiliary dipoles in the D-OLED reorient under the applied driving voltage, enabling immediate luminance turn-on and lowering the injection barriers at both electrodes. Finally, we demonstrate that the D-OLED achieves current efficacies comparable to those of SY OLEDs incorporating dedicated injection layers or LECs. Our study establishes dipolar doping as a practical strategy for efficient bipolar charge injection from air-stable electrodes in solution-processed organic semiconductor devices.

cond-mat.mtrl-sci↗