Searcharxiv⌕ Search

arXiv subjects

L. Guy

Publications and source records attributed to L. Guy.

10 recordsLinked to original sources
arXiv2021

Gaia Early Data Release 3: Updated radial velocities from Gaia DR2

Gaia's Early Third Data Release (EDR3) does not contain new radial velocities because these will be published in Gaia's full third data release (DR3), expected in the first half of 2022. To maximise the usefulness of EDR3, Gaia's second data release (DR2) sources (with radial velocities) are matched to EDR3 sources to allow their DR2 radial velocities to also be included in EDR3. This presents two considerations: (i) arXiv:1901.10460 (hereafter B19) published a list of 70,365 sources with potentially contaminated DR2 radial velocities; and (ii) EDR3 is based on a new astrometric solution and a new source list, which means sources in DR2 may not be in EDR3. EDR3 contains 7,209,831 sources with a DR2 radial velocity, which is 99.8% of sources with a radial velocity in DR2. 14,800 radial velocities from DR2 are not propagated to any EDR3 sources because (i) 3871 from the B19 list are found to either not have an unpublished, preliminary DR3 radial velocity or it differs significantly from its DR2 value, and 5 high-velocity stars not in the B19 list are confirmed to have contaminated radial velocities; and (ii) 10,924 DR2 sources could not be satisfactorily matched to any EDR3 sources, so their DR2 radial velocities are also missing from EDR3. The reliability of radial velocities in EDR3 has improved compared to DR2 because the update removes a small fraction of erroneous radial velocities (0.05% of DR2 radial velocities and 5.5% of the B19 list). Lessons learnt from EDR3 (e.g. bright star contamination) will improve the radial velocities in future Gaia data releases. The main reason for radial velocities from DR2 not propagating to EDR3 is not related to DR2 radial velocity quality. It is because the DR2 astrometry is based on one component of close binary pairs, while EDR3 astrometry is based on the other component, which prevents these sources from being unambiguously matched. (Abridged)

astro-ph.GA↗
arXiv2018

Gaia Data Release 2. Short-timescale variability processing and analysis

The Gaia DR2 sample of short-timescale variable candidates results from the investigation of the first 22 months of Gaia photometry for a subsample of sources at the Gaia faint end. For this exercise, we limited ourselves to the case of suspected rapid periodic variability. Our study combines fast-variability detection through variogram analysis, high-frequency search by means of least-squares periodograms, and empirical selection based on the investigation of specific sources seen through the Gaia eyes (e.g. known variables or visually identified objects with peculiar features in their light curves). The progressive definition and validation of this selection criterion also benefited from supplementary ground-based photometric monitoring of a few preliminary candidates, performed at the Flemish Mercator telescope (Canary Islands, Spain) between August and November 2017. We publish a list of 3,018 short-timescale variable candidates, spread throughout the sky, with a false-positive rate up to 10-20% in the Magellanic Clouds, and a more significant but justifiable contamination from longer-period variables between 19% and 50%, depending on the area of the sky. Although its completeness is limited to about 0.05%, this first sample of Gaia short-timescale variables recovers some very interesting known short-period variables, such as post-common envelope binaries or cataclysmic variables, and brings to light some fascinating, newly discovered variable sources. In the perspective of future Gaia data releases, several improvements of the short-timescale variability processing are considered, by enhancing the existing variogram and period-search algorithms or by classifying the identified candidates. Nonetheless, the encouraging outcome of our Gaia DR2 analysis demonstrates the power of this mission for such fast-variability studies, and opens great perspectives for this domain of astrophysics.

astro-ph.IM↗
arXiv2017

Gaia eclipsing binary and multiple systems. Two-Gaussian models applied to OGLE-III eclipsing binary light curves in the Large Magellanic Cloud

The advent of large scale multi-epoch surveys raises the need for automated light curve (LC) processing. This is particularly true for eclipsing binaries (EBs), which form one of the most populated types of variable objects. The Gaia mission, launched at the end of 2013, is expected to detect of the order of few million EBs over a 5-year mission. We present an automated procedure to characterize EBs based on the geometric morphology of their LCs with two aims: first to study an ensemble of EBs on a statistical ground without the need to model the binary system, and second to enable the automated identification of EBs that display atypical LCs. We model the folded LC geometry of EBs using up to two Gaussian functions for the eclipses and a cosine function for any ellipsoidal-like variability that may be present between the eclipses. The procedure is applied to the OGLE-III data set of EBs in the Large Magellanic Cloud (LMC) as a proof of concept. The bayesian information criterion is used to select the best model among models containing various combinations of those components, as well as to estimate the significance of the components. Based on the two-Gaussian models, EBs with atypical LC geometries are successfully identified in two diagrams, using the Abbe values of the original and residual folded LCs, and the reduced $χ^2$. Cleaning the data set from the atypical cases and further filtering out LCs that contain non-significant eclipse candidates, the ensemble of EBs can be studied on a statistical ground using the two-Gaussian model parameters. For illustration purposes, we present the distribution of projected eccentricities as a function of orbital period for the OGLE-III set of EBs in the LMC, as well as the distribution of their primary versus secondary eclipse widths.

astro-ph.IM↗
arXiv2014

The LOFT Ground Segment

LOFT, the Large Observatory For X-ray Timing, was one of the ESA M3 mission candidates that completed their assessment phase at the end of 2013. LOFT is equipped with two instruments, the Large Area Detector (LAD) and the Wide Field Monitor (WFM). The LAD performs pointed observations of several targets per orbit (~90 minutes), providing roughly ~80 GB of proprietary data per day (the proprietary period will be 12 months). The WFM continuously monitors about 1/3 of the sky at a time and provides data for about ~100 sources a day, resulting in a total of ~20 GB of additional telemetry. The LOFT Burst alert System additionally identifies on-board bright impulsive events (e.g., Gamma-ray Bursts, GRBs) and broadcasts the corresponding position and trigger time to the ground using a dedicated system of ~15 VHF receivers. All WFM data are planned to be made public immediately. In this contribution we summarize the planned organization of the LOFT ground segment (GS), as established in the mission Yellow Book 1 . We describe the expected GS contributions from ESA and the LOFT consortium. A review is provided of the planned LOFT data products and the details of the data flow, archiving and distribution. Despite LOFT was not selected for launch within the M3 call, its long assessment phase (> 2 years) led to a very solid mission design and an efficient planning of its ground operations.

astro-ph.IM↗
arXiv2013

Automated classification of Hipparcos unsolved variables

We present an automated classification of stars exhibiting periodic, non-periodic and irregular light variations. The Hipparcos catalogue of unsolved variables is employed to complement the training set of periodic variables of Dubath et al. with irregular and non-periodic representatives, leading to 3881 sources in total which describe 24 variability types. The attributes employed to characterize light-curve features are selected according to their relevance for classification. Classifier models are produced with random forests and a multistage methodology based on Bayesian networks, achieving overall misclassification rates under 12 per cent. Both classifiers are applied to predict variability types for 6051 Hipparcos variables associated with uncertain or missing types in the literature.

astro-ph.SR↗
arXiv2012

The impact of Gaia and LSST on binary stars and exo-planets

Two upcoming large scale surveys, the ESA Gaia and LSST projects, will bring a new era in astronomy. The number of binary systems that will be observed and detected by these projects is enormous, estimations range from millions for Gaia to several tens of millions for LSST. We review some tools that should be developed and also what can be gained from these missions on the subject of binaries and exoplanets from the astrometry, photometry, radial velocity and their alert systems.

astro-ph.IM↗
arXiv2011

Hipparcos Variable Star Detection and Classification Efficiency

A complete periodic star extraction and classification scheme is set up and tested with the Hipparcos catalogue. The efficiency of each step is derived by comparing the results with prior knowledge coming from the catalogue or from the literature. A combination of two variability criteria is applied in the first step to select 17 006 variability candidates from a complete sample of 115 152 stars. Our candidate sample turns out to include 10 406 known variables (i.e., 90% of the total of 11 597) and 6600 contaminating constant stars. A random forest classification is used in the second step to extract 1881 (82%) of the known periodic objects while removing entirely constant stars from the sample and limiting the contamination of non-periodic variables to 152 stars (7.5%). The confusion introduced by these 152 non-periodic variables is evaluated in the third step using the results of the Hipparcos periodic star classification presented in a previous study (Dubath et al. [1]).

astro-ph.SR↗
arXiv2011

Random forest automated supervised classification of Hipparcos periodic variable stars

We present an evaluation of the performance of an automated classification of the Hipparcos periodic variable stars into 26 types. The sub-sample with the most reliable variability types available in the literature is used to train supervised algorithms to characterize the type dependencies on a number of attributes. The most useful attributes evaluated with the random forest methodology include, in decreasing order of importance, the period, the amplitude, the V-I colour index, the absolute magnitude, the residual around the folded light-curve model, the magnitude distribution skewness and the amplitude of the second harmonic of the Fourier series model relative to that of the fundamental frequency. Random forests and a multi-stage scheme involving Bayesian network and Gaussian mixture methods lead to statistically equivalent results. In standard 10-fold cross-validation experiments, the rate of correct classification is between 90 and 100%, depending on the variability type. The main mis-classification cases, up to a rate of about 10%, arise due to confusion between SPB and ACV blue variables and between eclipsing binaries, ellipsoidal variables and other variability types. Our training set and the predicted types for the other Hipparcos periodic stars are available online.

astro-ph.SR↗
arXiv2001

Bottom Production

We review the prospects for bottom production physics at the LHC.

hep-ph↗