SearcharxivSearch

arXiv subjects

L. Huder

Publications and source records attributed to L. Huder.

3 recordsLinked to original sources

Heterostrain rules the flat-bands in magic-angle twisted graphene layers

The moiré of twisted graphene bilayers can generate flat bands in which charge carriers do not posses enough kinetic energy to escape Coulomb interactions with each other leading to the formation of novel strongly correlated electronic states. This exceptionally rich physics relies on the precise arrangement between the layers.We survey published Scanning Tunnelling Microscope (STM) measurements to prove that near the magic angle, native heterostrain, the relative deformations between the layers, dominates twist in determining the flat bands. This is demonstrated at large doping where electronic correlations have a weak effect and where we also show that tip-induced strain can have a strong influence. In the opposite situation of low doping, we find that electronic correlation further normalize the flat bands in a way that strongly depends on experimental details.

cond-mat.mes-hall

Electronic spectrum of twisted graphene layers under heterostrain

We demonstrate that stacking layered materials allows a novel type of strain engineering where each layer is strained independently, which we call heterostrain. We combine detailed structural and spectroscopic measurements with tight-binding calculations to show that small uniaxial heterostrain suppresses Dirac cones and leads to the emergence of flat bands in twisted graphene layers (TGLs). Moreover, we demonstrate that heterostrain reconstructs much more severely the energy spectrum of TGLs than homostrain for which both layers are strained identically ; a result which should apply to virtually all van der Waals structure opening exciting possibilities for straintronics with 2D materials.

cond-mat.mes-hall

Epitaxial electrical contact to graphene on SiC

Establishing good electrical contacts to nanoscale devices is a major issue for modern technology and contacting 2D materials is no exception to the rule. One-dimensional edge-contacts to graphene were recently shown to outperform surface contacts but the method remains difficult to scale up. We report a resist-free and scalable method to fabricate few graphene layers with electrical contacts in a single growth step. This method derives from the discovery reported here of the growth of few graphene layers on a metallic carbide by thermal annealing of a carbide forming metallic film on SiC in high vacuum. We exploit the combined effect of edge-contact and partially-covalent surface epitaxy between graphene and the metallic carbide to fabricate devices in which low contact-resistance and Josephson effect are observed. Implementing this approach could significantly simplify the realization of large-scale graphene circuits.

physics.app-ph