Searcharxiv⌕ Search

arXiv subjects

L. J. Wang

Publications and source records attributed to L. J. Wang.

At least 73 records · Page 4Linked to original sources

A Unified Energy-Reservoir Model Containing Contributions from $^{56}$Ni and Neutron Stars and Its Implication to Luminous Type Ic Supernovae

Most type-Ic core-collapse supernovae (CCSNe) produce $^{56}$Ni and neutron stars (NSs) or black holes (BHs). The dipole radiation of nascent NSs has usually been neglected in explaining supernovae (SNe) with peak absolute magnitude $M_{\rm peak}$ in any band are $\gtrsim -19.5$~mag, while the $^{56}$Ni can be neglected in fitting most type-Ic superluminous supernovae (SLSNe Ic) whose $M_{\rm peak}$ in any band are $\lesssim -21$~mag, since the luminosity from a magnetar (highly magnetized NS) can outshine that from a moderate amount of $^{56}$Ni. For luminous SNe Ic with $-21 \lesssim M_{\rm peak}\lesssim -19.5$~mag, however, both contributions from $^{56}$Ni and NSs cannot be neglected without serious modeling, since they are not SLSNe and the $^{56}$Ni mass could be up to $\sim 0.5 M_{\odot}$. In this paper we propose a unified model that contain contributions from both $^{56}$Ni and a nascent NS. We select three luminous SNe Ic-BL, SN~2010ay, SN~2006nx, and SN~14475, and show that, if these SNe are powered by $^{56}$Ni, the ratio of $M_{\rm Ni}$ to $M_{\rm ej}$ are unrealistic. Alternatively, we invoke the magnetar model and the hybrid ($^{56}$Ni + NS) model and find that they can fit the observations, indicating that our models are valid and necessary for luminous SNe Ic. Owing to the lack of late-time photometric data, we cannot break the parameter degeneracy and thus distinguish among the model parameters, but we can expect that future multi-epoch observations of luminous SNe can provide stringent constraints on $^{56}$Ni yields and the parameters of putative magnetars.

astro-ph.HE↗

Fiber-based Radio Frequency Dissemination for Branching Networks with Passive Phase Noise Cancellation

We demonstrate a new fiber-based radio frequency dissemination scheme for branching networks. Without any phase controls on RF signals or usages of active feedback locking components, the highly stable reference frequency signal can be delivered to several remote sites simultaneously and independently. Relative frequency stability of 6E-15/s and 7E-17/1E4s is obtained for 10km dissemination. The proposed low cost and scalable method can be applied to some large-scale frequency synchronization networks.

physics.optics↗

Superluminous Supernovae Powered by Magnetars: Late-time Light Curves and Hard Emission Leakage

Recently, researches performed by two groups have revealed that the magnetar spin-down energy injection model with full energy trapping can explain the early-time light curves of SN 2010gx, SN 2013dg, LSQ12dlf, SSS120810 and CSS121015, but fails to fit the late-time light curves of these Superluminous Supernovae (SLSNe). These results imply that the original magnetar-powered model is challenged in explaining these SLSNe. Our paper aims to simultaneously explain both the early- and late-time data/upper limits by considering the leakage of hard emissions. We incorporate quantitatively the leakage effect into the original magnetar-powered model and derive a new semi-analytical equation. Comparing the light curves reproduced by our revised magnetar-powered model to the observed data and/or upper limits of these five SLSNe, we found that the late-time light curves reproduced by our semi-analytical equation are in good agreement with the late-time observed data and/or upper limits of SN 2010gx, CSS121015, SN 2013dg and LSQ12dlf and the late-time excess of SSS120810, indicating that the magnetar-powered model might be responsible for these SLSNe and that the gamma ray and X-ray leakage are unavoidable when the hard photons were down-Comptonized to softer photons. To determine the details of the leakage effect and unveil the nature of SLSNe, more high quality bolometric light curves and spectra of SLSNe are required.

astro-ph.HE↗

Generation of correlated photon pairs in micro/nano-fibers

We study the generation of correlated photon pairs via spontaneous four wave mixing in a 15 cm long micro/nano-fiber (MNF). The MNF is properly fabricated to satisfy the phase matching condition for generating the signal and idler photon pairs at the wavelengths of about 1310 and 851 nm, respectively. Photon counting measurements yield a coincidence-to-accidental ratio of 530 for a photon production rate of about 0.002 (0.0005) per pulse in the signal (idler) band. We also analyze the spectral information of the signal photons originated from the spontaneous four wave mixing and Raman scattering. In addition to discovering some unique feature of Raman scattering, we find the bandwidth of the individual signal photons is much greater than the calculated value for the MNF with homogeneous structure. Our investigations indicate the MNF is a promising candidate for developing the sources of nonclassical light and the spectral property of photon pairs can be used to non-invasively test the diameter and homogeneity of the MNF.

quant-ph↗

PTF11agg as the First Evidence for Reverse Shock Emission from a Postmerger Millisecond Magnetar

Based on the stiff equations of state of neutron stars (NS) and the discovery of high-mass NSs, a NS-NS merger will leave behind, with high probabilities, a rapidly rotating massive magnetar. The central magnetar will dissipate its rotational energy to the outflow by injecting Poynting flux, which will become lepton-dominated so that a long-lasting reverse shock (RS) is developed. We calculate the emission of the RS as well as the emission of forward shock (FS) and find that in most cases the RS emission is stronger than FS emission. It is found that the recently discovered transient, PTF11agg, can be neatly accounted for by the RS emission powered by a millisecond magnetar. Other alternative models have been considered and cannot explain the observed light curves well. We therefore suggest that PTF11agg be the first evidence for RS emission from a postmerger millisecond magnetar.

astro-ph.HE↗

Fiber Based Multiple-Access Optical Frequency Dissemination

We demonstrate a fiber based multiple-access optical frequency dissemination scheme. Without using any additional laser sources, we reproduce the stable disseminated frequency at an arbitrary point of fiber link. Relative frequency stability of 3E10^{-16}/s and 4E10^{-18}/10^4s is obtained. A branching fiber network for highly-precision synchronization of optical frequency is made possible by this method and its applications are discussed.

physics.optics↗

Sub-kHz lasing of a CaF_2 Whispering Gallery Mode Resonator Stabilized Fiber Ring Laser

We utilize a high quality calcium fluoride whispering-gallery-mode resonator to stabilize a simple erbium doped fiber ring laser with an emission frequency of 196 THz (wavelenght 1530 nm) to a linewidth below 650 Hz. This corresponds to a relative stability of 3.3 x 10^(-12) over 16 \mus. In order to characterize the linewidth we use two identical self-built lasers and a commercial laser to determine the individual lasing linewidth via the three-cornered hat method.

physics.optics↗

Whispering Gallery Mode Resonator Stabilized Narrow Linewidth Fiber Loop Laser

We demonstrate a narrow line, fiber loop laser using Erbium-doped fiber as the gain material, stabilized by using a microsphere as a transmissive frequency selective element. Stable lasing with a linewidth of 170 kHz is observed, limited by the experimental spectral resolution. A linear increase in output power and a red-shift of the lasing mode were also observed with increasing pump power. Its potential application is also discussed.

physics.optics↗

CaF2 Whispering-Gallery-Mode Resonator Stabilized Narrow Linewidth Laser

A fiber laser is stabilized using a Calcium Fluoride (CaF2) whispering-gallery-mode resonator. It is set up using a semiconductor optical amplifier as a gain medium. The resonator is critically coupled through prisms, and used as a filtering element to suppress the laser linewidth. Using the self-heterodyne beat technique the linewidth is determined to be 13 kHz. This implies an enhancement factor of 10^3 with respect to the passive cavity linewidth. The three-cornered hat method shows a stability of 10^(-11) after 10 μs.

physics.optics↗

Coherent versus Incoherent Light Scattering from a Quantum Dot

We analyze the light scattered by a single InAs quantum dot interacting with a resonant continuous-wave laser. High resolution spectra reveal clear distinctions between coherent and incoherent scattering, with the laser intensity spanning over four orders of magnitude. We find that the fraction of coherently scattered photons can approach unity under sufficiently weak or detuned excitation, ruling out pure dephasing as a relevant decoherence mechanism. We show how spectral diffusion shapes spectra, correlation functions, and phase-coherence, concealing the ideal radiatively-broadened two-level system described by Mollow.

cond-mat.mes-hall↗

Determination of Intrinsic Ferroelectric Polarization in Orthorhombic Manganites with E-type Spin Order

By directly measuring electrical hysteresis loops using the Positive-Up Negative-Down (PUND) method, we accurately determined the remanent ferroelectric polarization Pr of orthorhombic RMnO3 (R = Ho, Tm, Yb, and Lu) compounds below their E-type spin ordering temperatures. We found that LuMnO3 has the largest Pr of 0.17 uC/cm^2 at 6 K in the series, indicating that its single-crystal form can produce a Pr of at least 0.6 \muuC/cm^2 at 0 K. Furthermore, at a fixed temperature, Pr decreases systematically with increasing rare earth ion radius from R = Lu to Ho, exhibiting a strong correlation with the variations in the in-plane Mn-O-Mn bond angle and Mn-O distances. Our experimental results suggest that the contribution of the Mn t2g orbitals dominates the ferroelectric polarization.

cond-mat.mtrl-sci↗

Molecule States in a Gate Tunable Graphene Double Quantum Dot

We have measured a graphene double quantum dot device with multiple electrostatic gates that are used to enhance control to investigate it. At low temperatures the transport measurements reveal honeycomb charge stability diagrams which can be tuned from weak to strong interdot tunnel coupling regimes. We precisely extract a large interdot tunnel coupling strength for this system allowing for the observation of tunnel-coupled molecular states extending over the whole double dot. This clean, highly controllable system serves as an essential building block for quantum devices in a nuclear-spin-free world.

cond-mat.mes-hall↗

Microwave whispering gallery resonator for efficient optical up-conversion

Conversion of microwave radiation into the optical range has been predicted to reach unity quantum efficiency in whispering gallery resonators made from an optically nonlinear crystal and supporting microwave and optical modes simultaneously. In this work we theoretically explore and experimentally demonstrate a resonator geometry that can provide the required phase matching for such a conversion at any desired frequency in the sub-THz range. We show that such a ring-shaped resonator not only allows for the phase matching, but also maximizes the overlap of the interacting fields. As a result, unity-efficient conversion is expected in a resonator with feasible parameters.

quant-ph↗

Sub-hertz frequency stabilization of a commercial diode laser

We report ultra-stable locking of a commercially available extended cavity diode laser to a vibration-insensitive high finesse Fabry-Perot cavity. A servo bandwidth of 2 MHz is demonstrated. The absolute stability of the diode laser after locking is measured with a three-cornered-hat method. The resulting Allan deviation reaches a level of $2.95\times10^{-15}$ at 1 s, corresponding to only 0.93 Hz linewidth, even without vibration isolation of the reference cavity.

physics.optics↗

A vibration-insensitive optical cavity and absolute determination of its ultrahigh stability

We use the three-cornered-hat method to evaluate the absolute frequency stabilities of three different ultrastable reference cavities, one of which has a vibration-insensitive design that does not even require vibration isolation. An Nd:YAG laser and a diode laser are implemented as light sources. We observe $\sim1$ Hz beat note linewidths between all three cavities. The measurement demonstrates that the vibration-insensitive cavity has a good frequency stability over the entire measurement time from 100 $μ$s to 200 s. An absolute, correlation-removed Allan deviation of $1.4\times10^{-15}$ at 1 s of this cavity is obtained, giving a frequency uncertainty of only 0.44 Hz.

physics.optics↗

An Optical Clock Based on Coherent Population Trapping of Alkaline-earth Ions

An ultra-stable optical clock based on coherent population trapping effect of alkaline-earth ions, such as Ca$^+$, Sr$^+$, Ba$^+$, is analyzed here. The proposed transitions use the odd isotopes, so that the frequency shift is insensitive to the applied magnetic field. To enhance the signal, a large number of ions are trapped in a linear Paul trap, and laser cooled to crystallize such that the ions are in the Lamb-Dicke regime to avoid first order Doppler shift. Other relevant frequency shifts are also analyzed. Further techniques to improve the stability of the clock signal are discussed.

physics.optics↗

Characterization of the absolute frequency stability of an individual reference cavity

We demonstrated for the first time the characterization of absolute frequency stability of three reference cavities by cross beating three laser beams which are independently locked to these reference cavities. This method shows the individual feature of each reference cavity, while conventional beatnote measurement between two cavities can only provide an upper bound. This method allows for numerous applications such as optimizing the performance of the reference cavity for optical clockwork.

physics.atom-ph↗

Optomechanical Stochastic Resonance in a Macroscopic Torsion Oscillator

Linear mechanical oscillators have been applied to measure very small forces, mostly with the help of noise suppression. In contrast, adding noise to non-linear oscillators can improve the measurement conditions. Here, this effect of stochastic resonance is demonstrated in a macroscopic torsion oscillator, for an optomechanical non-linear potential. The signal output is enhanced for a sub-threshold electronic signal. This non-linear oscillator serves as a model system for the enhancement of signal-to-noise ratio in high precision optomechanical experiments.

physics.optics↗