arXiv subjects

L. Litov

Publications and source records attributed to L. Litov.

28 records · Page 2Linked to original sources

arXiv2013

Simulation of the CMS Resistive Plate Chambers

The Resistive Plate Chamber (RPC) muon subsystem contributes significantly to the formation of the trigger decision and reconstruction of the muon trajectory parameters. Simulation of the RPC response is a crucial part of the entire CMS Monte Carlo software and directly influences the final physical results. An algorithm based on the parametrization of RPC efficiency, noise, cluster size and timing for every strip has been developed. Experimental data obtained from cosmic and proton-proton collisions at $\sqrt{s}=7$ TeV have been used for determination of the parameters. A dedicated validation procedure has been developed. A good agreement between the simulated and experimental data has been achieved.

physics.ins-det↗

arXiv2013

Measurement of the branching ratio of the decay $Ξ^{0}\rightarrow Σ^{+} μ^{-} \barν_μ$

From the 2002 data taking with a neutral kaon beam extracted from the CERN-SPS, the NA48/1 experiment observed 97 $Ξ^{0}\rightarrow Σ^{+} μ^{-} \barν_μ$ candidates with a background contamination of $30.8 \pm 4.2$ events. From this sample, the BR($Ξ^{0}\rightarrow Σ^{+} μ^{-} \barν_μ$) is measured to be $(2.17 \pm 0.32_{\mathrm{stat}}\pm 0.17_{\mathrm{syst}})\times10^{-6}$.

hep-ex↗

arXiv2012

Uniformity and Stability of the CMS RPC Detector at the LHC

The Resistive Plate Chambers (RPCs) are employed in the CMS experiment at the LHC as dedicated trigger system both in the barrel and in the endcap. This note presents results of the RPC detector uniformity and stability during the 2011 data taking period, and preliminary results obtained with 2012 data. The detector uniformity has been ensured with a dedicated High Voltage scan with LHC collisions, in order to determine the optimal operating working voltage of each individual RPC chamber installed in CMS. Emphasis is given on the procedures and results of the High Voltage calibration. Moreover, an increased detector stability has been obtained by automatically taking into account temperature and atmospheric pressure variations in the CMS cavern.

physics.ins-det↗

arXiv2012

CMS Resistive Plate Chamber overview, from the present system to the upgrade phase I

University of Sofia, Faculty of Physics, Atomic Physics Department, 5, James Bourchier Boulevard, BG-1164 Sofia, Bulgaria Ghent University, Department of Physics and Astronomy, Proeftuinstraat 86, BE-9000 Ghent, Belgium Bulgarian Academy of Sciences, Inst. for Nucl. Res. and Nucl. Energy, Tzarigradsko shaussee Boulevard 72, BG-1784 Sofia, Bulgaria Peking University, Department of Technical Physics, CN-100 871 Beijing, China Universidad de Los Andes, Apartado Aéreo 4976, Carrera 1E, no. 18A 10, CO-Bogotá, Colombia Academy of Scientific Research and Technology of the Arab Republic of Egypt, 101 Sharia Kasr El-Ain, Cairo, Egypt Panjab University, Department of Physics, Chandigarh Mandir 160 014, India Universita e INFN, Sezione di Bari, Via Orabona 4, IT-70126 Bari, Italy INFN, Laboratori Nazionali di Frascati, PO Box 13, Via Enrico Fermi 40, IT-00044 Frascati, Italy Universita e INFN, Sezione di Napoli, Complesso Univ. Monte S. Angelo, Via Cintia, IT-80126 Napoli, Italy Universita e INFN, Sezione di Pavia, Via Bassi 6, IT-Pavia, Italy Department of Physics and Korea Detector Laboratory, Korea University, Aman-dong 5-ga, Sungbuk-gu, Seou,l Republic of Korea Sungkyunkwan University, Department of Physics 2066, Seobu-ro, Jangan-gu, Suwon, Gyeonggi-Do, Republic of Korea

physics.ins-det↗

arXiv2010

Empirical parameterization of the K+- -> pi+- pi0 pi0 decay Dalitz plot

As first observed by the NA48/2 experiment at the CERN SPS, the $\p0p0$ invariant mass (M00) distribution from $\kcnn$ decay shows a cusp-like anomaly at M00=2m+, where m+ is the charged pion mass. An analysis to extract the pi pi scattering lengths in the isospin I=0 and I=2 states, a0 and a2, respectively, has been recently reported. In the present work the Dalitz plot of this decay is fitted to a new empirical parameterization suitable for practical purposes, such as Monte Carlo simulations of K+- -> pi+- pi0 pi0 decays.

hep-ex↗

arXiv2008

Energy dependence of phi meson production in central Pb+Pb collisions at sqrt(s_nn) = 6 to 17 GeV

Phi meson production is studied by the NA49 Collaboration in central Pb+Pb collisions at 20A, 30A, 40A, 80A and 158A GeV beam energy. The data are compared with measurements at lower and higher energies and to microscopic and thermal models. The energy dependence of yields and spectral distributions is compatible with the assumption that partonic degrees of freedom set in at low SPS energies.

nucl-ex↗

arXiv2008

Event-by-event transverse momentum fluctuations in nuclear collisions at CERN SPS

The latest NA49 results on event-by-event transverse momentum fluctuations are presented for central Pb+Pb interactions over the whole SPS energy range (20A - 158A GeV). Two different methods are applied: evaluating the $Φ_{p_{T}}$ fluctuation measure and studying two-particle transverse momentum correlations. The obtained results are compared to predictions of the UrQMD model. The results on the energy dependence are compared to the NA49 data on the system size dependence. The NA61 (SHINE, NA49-future) strategy of searching of the QCD critical end-point is also discussed.

nucl-ex↗

arXiv2005

Recent NA48 results on semileptonic and rare kaon decays. Measurement of Vus

The new results of investigation of K^0_Le3 and K^{\pm}e3 decays performed by NA48 Collaboration are presented. The measured branching fractions are used to extract Vus. The values of Ke3 form-factors and radiative K^0_Le3γbranching ratio are reported. A list of recent NA48 results concerning some rare neutral kaon decays is given.

hep-ex↗

arXiv2000

Application of Neural Networks for Energy Reconstruction

The possibility to use Neural Networks for reconstruction of the energy deposited in the calorimetry system of the CMS detector is investigated. It is shown that using feed - forward neural network, good linearity, Gaussian energy distribution and good energy resolution can be achieved. Significant improvement of the energy resolution and linearity is reached in comparison with other weighting methods for energy reconstruction.

hep-ex↗

arXiv1999

Application of avalanche photodiodes as a readout for scintillator tile-fiber systems

The application of reach-through avalanche photodiodes (R'APD) as a photodetector for scintillator tiles has been investigated. The light collected by WLS fibers (0.84mm and 1mm diameter) embedded in the scintillator has been transmited to the 0.5mm2 active surface of APD by clear optical fibers and optical connectors. A low noise charge sensitive preamplifier (approximately 400 electrons equivalent noise charge) has been used to gain the photodiode signal. Various configurations of tile-fibre systems, suitable for CMS and LHCb experiments at LHC have been studied using cosmic muons and muon beam at SPS at CERN. In order to optimize the performance of APD, measurments in the temperature range from -10C to +25C have been done. The MIP detection efficiency and electron/MIP separation have been estimated in order to determine applicability of the readout for LHCb preshower.

physics.ins-det↗