SearcharxivSearch

arXiv subjects

L. Raux

Publications and source records attributed to L. Raux.

10 recordsLinked to original sources

Measurement of $\Lambda$ Polarization in the $\pi^{-}p \to K^{0} \Lambda$ Reaction at $p_{\pi^{-}}=1.33$ GeV/$c$ toward a New $\Lambda p$ Scattering Experiment

This paper presents high-precision experimental data of the polarization of the $\Lambda$ hyperon in the $\pi^{-}p \to K^{0} \Lambda$ reaction, measured in the angular range $0.6<\cos \theta ^{CM}_{K0}<1.0$ with a fine bin width of $d\cos \theta ^{CM}_{K0}=0.05$. The data were obtained from the J-PARC E40 experiment at the K1.8 beamline in the J-PARC Hadron Experimental Facility. The observed average polarization of $\Lambda$ in the range $0.60<\cos \theta ^{CM}_{K0}<0.85$ was $0.932 \pm 0.058 \,(\text{stat}) \pm 0.028 \,(\text{syst})$, demonstrating the successful extraction of precise polarization observables. This result provides essential experimental input for partial wave analysis (PWA) of dynamical coupled-channel (DCC) models, which aim to uncover the underlying mechanisms of $N^{*}$ resonances that emerge in intermediate states of $\pi N$ and $\gamma N$ interactions. Besides, it indicates the feasibility of a strongly polarized $\Lambda$ beam suitable for future $\Lambda p$ scattering experiments (e.g., J-PARC E86).

nucl-ex

Measurement of differential cross sections for $Σ^+p$ elastic scattering in the momentum range 0.44-0.80 GeV/c

We performed a novel $Σ^+ p$ scattering experiment at the J-PARC Hadron Experimental Facility. Approximately 2400 $Σ^+ p$ elastic scattering events were identified from $4.9 \times 10^7$ tagged $Σ^+$ particles in the $Σ^+$ momentum range 0.44 -- 0.80 GeV/$c$. The differential cross sections of the $Σ^+ p$ elastic scattering were derived with much better precision than in previous experiments. The obtained differential cross sections were approximately 2 mb/sr or less, which were not as large as those predicted by the fss2 and FSS models based on the quark cluster model in the short-range region. By performing phase-shift analyses for the obtained differential cross sections, we experimentally derived the phase shifts of the $^3 S_1$ and $^1 P_1$ channels for the first time. The phase shift of the $^3 S_1$ channel, where a large repulsive core was predicted owing to the Pauli effect between quarks, was evaluated as $20^\circ<|δ_{^3S_1}|<35^\circ$. If the sign of $δ_{^3S_1}$ is assumed to be negative, the interaction in this channel is moderately repulsive, as the Nijmegen extended-sort-core models predicted.

nucl-ex

Precise measurement of differential cross sections of the Σ-p --> Λ n reaction in momentum range 470-650 MeV/c

The differential cross sections of the Σ-p --> Λ n reaction were measured accurately for the Σ- momentum (p_{Σ}) ranging from 470 to 650 MeV/c at the J-PARC Hadron Experimental Facility. Precise angular information about the Σ-p --> Λ n reaction was obtained for the first time by detecting approximately 100 reaction events at each angular step of Δcosθ = 0.1. The obtained differential cross sections show slightly forward-peaking structure in the measured momentum regions.The cross sections integrated for -0.7 < cosθ < 1.0 were obtained as 22.5 +- 0.68 (stat.) +- 0.65 (syst.) mb and 15.8 +-0.83(stat.) +- 0.52 (syst.) mb for 470<p_{Σ}(MeV/c)<550 and 550<p_{Σ}(MeV/c)<650, respectively. These results show a drastic improvement compared to past measurements of the hyperon-proton scattering experiments. They will play essential roles in updating the theoretical models of the baryon-baryon interactions.

nucl-ex

Measurement of the differential cross sections of the Sigma-p elastic scattering in momentum range of 470 to 850 MeV/c

A high statistics $Σp$ scattering experiment has been performed at the J-PARC Hadron Experimental Facility. Data for momentum-tagged $Σ^{-}$ running in a liquid hydrogen target were accumulated by detecting the $π^{-}p \to K^{+}Σ^{-}$ reaction with a high intensity $π^{-}$ beam of 20 M/spill. Differential cross sections of the $Σ^{-}p$ elastic scattering were derived with a drastically improved accuracy by identifying the largest statistics of about 4,500 events from 1.72 $\times$ $10^{7}$ $Σ^{-}$. The derived differential cross section shows a clear forward-peaking angular distribution for a $Σ^{-}$ momentum range from 470 to 850 MeV/$c$. The accurate data will impose a strong constraint on the theoretical models of the baryon-baryon interactions.

nucl-ex

Particle Identification Using Boosted Decision Trees in the Semi-Digital Hadronic Calorimeter Prototype

The CALICE Semi-Digital Hadronic CALorimeter (SDHCAL) prototype using Glass Resistive Plate Chambers as a sensitive medium is the first technological prototype of a family of high-granularity calorimeters developed by the CALICE collaboration to equip the experiments of future leptonic colliders. It was exposed to beams of hadrons, electrons and muons several times in the CERN PS and SPS beamlines between 2012 and 2018. We present here a new method of particle identification within the SDHCAL using the Boosted Decision Trees (BDT) method applied to the data collected in 2015. The performance of the method is tested first with Geant4-based simulated events and then on the data collected by the SDHCAL in the energy range between 10 and 80~GeV with 10~GeV energy steps. The BDT method is then used to reject the electrons and muons that contaminate the SPS hadron beams.

physics.ins-det

Characterisation of different stages of hadronic showers using the CALICE Si-W ECAL physics prototype

A detailed investigation of hadronic interactions is performed using $π^-$-mesons with energies in the range 2--10 GeV incident on a high granularity silicon-tungsten electromagnetic calorimeter. The data were recorded at FNAL in 2008. The region in which the $π^-$-mesons interact with the detector material and the produced secondary particles are characterised using a novel track-finding algorithm that reconstructs tracks within hadronic showers in a calorimeter in the absence of a magnetic field. The principle of carrying out detector monitoring and calibration using secondary tracks is also demonstrated.

physics.ins-det

First results of the CALICE SDHCAL technological prototype

The CALICE Semi-Digital Hadronic Calorimeter (SDHCAL) prototype, built in 2011, was exposed to beams of hadrons, electrons and muons in two short periods in 2012 on two different beam lines of the CERN SPS. The prototype with its 48 active layers, made of Glass Resistive Plate Chambers and their embedded readout electronics, was run in triggerless and power-pulsing mode. The performance of the SDHCAL during the test beam was found to be very satisfactory with an efficiency exceeding 90% for almost all of the 48 active layers. A linear response (within 5%) and a good energy resolution are obtained for a large range of hadronic energies (5-80GeV) by applying appropriate calibration coefficients to the collected data for both the Digital (Binary) and the Semi-Digital (Multi-threshold) modes of the SDHCAL prototype. The Semi-Digital mode shows better performance at energies exceeding 30GeV

physics.ins-det

Infrastructure for Detector Research and Development towards the International Linear Collider

The EUDET-project was launched to create an infrastructure for developing and testing new and advanced detector technologies to be used at a future linear collider. The aim was to make possible experimentation and analysis of data for institutes, which otherwise could not be realized due to lack of resources. The infrastructure comprised an analysis and software network, and instrumentation infrastructures for tracking detectors as well as for calorimetry.

physics.ins-det

PMm2: large photomultipliers and innovative electronics for the next-generation neutrino experiments

The next generation of proton decay and neutrino experiments, the post-SuperKamiokande detectors as those that will take place in megaton size water tanks, will require very large surfaces of photodetection and a large volume of data. Even with large hemispherical photomultiplier tubes, the expected number of channels should reach hundreds of thousands. A funded R&D program to implement a solution is presented here. The very large surface of photodetection is segmented in macro pixels made of 16 hemispherical (12 inches) photomultiplier tubes connected to an autonomous front-end which works on a triggerless data acquisition mode. The expected data transmission rate is 5 Mb/s per cable, which can be achieved with existing techniques. This architecture allows to reduce considerably the cost and facilitate the industrialization. This document presents the simulations and measurements which define the requirements for the photomultipliers and the electronics. A proto-type of front-end electronics was successfully tested with 16 photomultiplier tubes supplied by a single high voltage, validating the built-in gain adjustment and the calibration principle. The first tests and calculations on the photomultiplier glass led to the study of a new package optimized for a 10 bar pressure in order to sustain the high underwater pressure.

physics.ins-det

Design and Electronics Commissioning of the Physics Prototype of a Si-W Electromagnetic Calorimeter for the International Linear Collider

The CALICE collaboration is studying the design of high performance electromagnetic and hadronic calorimeters for future International Linear Collider detectors. For the electromagnetic calorimeter, the current baseline choice is a high granularity sampling calorimeter with tungsten as absorber and silicon detectors as sensitive material. A ``physics prototype'' has been constructed, consisting of thirty sensitive layers. Each layer has an active area of 18x18 cm2 and a pad size of 1x1 cm2. The absorber thickness totals 24 radiation lengths. It has been exposed in 2006 and 2007 to electron and hadron beams at the DESY and CERN beam test facilities, using a wide range of beam energies and incidence angles. In this paper, the prototype and the data acquisition chain are described and a summary of the data taken in the 2006 beam tests is presented. The methods used to subtract the pedestals and calibrate the detector are detailed. The signal-over-noise ratio has been measured at 7.63 +/- 0.01. Some electronics features have been observed; these lead to coherent noise and crosstalk between pads, and also crosstalk between sensitive and passive areas. The performance achieved in terms of uniformity and stability is presented.

physics.ins-det