Searcharxiv⌕ Search

arXiv subjects

L. Zawiejski

Publications and source records attributed to L. Zawiejski.

11 recordsLinked to original sources
arXiv2019

Performance and Moli`ere radius measurements using a compact prototype of LumiCal in an electron test beam

A new design of a detector plane of sub-millimetre thickness for an electromagnetic sampling calorimeter is presented. It is intended to be used in the luminometers LumiCal and BeamCal in future linear $e^+e^-$ collider experiments. The detector planes were produced utilising novel connectivity scheme technologies. They were installed in a compact prototype of the calorimeter and tested at DESY with an electron beam of energy 1-5 GeV. The performance of a prototype of a compact LumiCal comprising eight detector planes was studied. The effective Moli`ere radius at 5 GeV was determined to be (8.1 +/- 0.1 (stat) +/- 0.3 (syst)) mm, a value well reproduced by the Monte Carlo (MC) simulation (8.4 +/- 0.1) mm. The dependence of the effective Moli`ere radius on the electron energy in the range 1-5 GeV was also studied. Good agreement was obtained between data and MC simulation.

physics.ins-det↗
arXiv2019

Charm production in charged current deep inelastic scattering at HERA

Charm production in charged current deep inelastic scattering has been measured for the first time in $e^{\pm}p$ collisions, using data collected with the ZEUS detector at HERA, corresponding to an integrated luminosity of $358 pb^{-1}$. Results are presented separately for $e^{+}p$ and $e^{-}p$ scattering at a centre-of-mass energy of $\sqrt{s} = 318 GeV$ within a kinematic phase-space region of $200 GeV^{2}<Q^{2}<60000 GeV^{2}$ and $y<0.9$, where $Q^{2}$ is the squared four-momentum transfer and $y$ is the inelasticity. The measured cross sections of electroweak charm production are consistent with expectations from the Standard Model within the large statistical uncertainties.

hep-ex↗
arXiv2018

Measurement of shower development and its Molière radius with a four-plane LumiCal test set-up

A prototype of a luminometer, designed for a future e+e- collider detector, and consisting at present of a four-plane module, was tested in the CERN PS accelerator T9 beam. The objective of this beam test was to demonstrate a multi-plane tungsten/silicon operation, to study the development of the electromagnetic shower and to compare it with MC simulations. The Molière radius has been determined to be 24.0 +/- 0.6 (stat.) +/- 1.5 (syst.) mm using a parametrization of the shower shape. Very good agreement was found between data and a detailed Geant4 simulation.

physics.ins-det↗
arXiv2015

Performance of fully instrumented detector planes of the forward calorimeter of a Linear Collider detector

Detector-plane prototypes of the very forward calorimetry of a future detector at an e+e- collider have been built and their performance was measured in an electron beam. The detector plane comprises silicon or GaAs pad sensors, dedicated front-end and ADC ASICs, and an FPGA for data concentration. Measurements of the signal-to-noise ratio and the response as a function of the position of the sensor are presented. A deconvolution method is successfully applied, and a comparison of the measured shower shape as a function of the absorber depth with a Monte-Carlo simulation is given.

physics.ins-det↗
arXiv2015

The study of the photon structure function at the ILC energy range

At the future $e^{+}e^{-}$ linear collider ILC/CLIC it will be able to measure the photon structure functions in a wider range of kinematic variables x and $Q^{2}$ in comparison to the previous results of experiments at LEP. The classical way to measure the photon structure functions is the study of $e^{+}e^{-} \rightarrow e^{+}e^{-} γγ \rightarrow e^{+}e^{-}$ X process, where X is the leptonic or hadronic final state. For the study of the QED and hadronic photon structure functions the simulations of two-photon processes were performed at the ILC center-of-mass energy equal to 500 GeV using the PYTHIA and the ILCSoft package. The analysis used information related to the forward detectors, tracking detectors and calorimeters which are parts of the ILD detector concept.

hep-ex↗
arXiv2014

ECFA Detector R&D Panel, Review Report

Two special calorimeters are foreseen for the instrumentation of the very forward region of an ILC or CLIC detector; a luminometer (LumiCal) designed to measure the rate of low angle Bhabha scattering events with a precision better than 10$^{-3}$ at the ILC and 10$^{-2}$ at CLIC, and a low polar-angle calorimeter (BeamCal). The latter will be hit by a large amount of beamstrahlung remnants. The intensity and the spatial shape of these depositions will provide a fast luminosity estimate, as well as determination of beam parameters. The sensors of this calorimeter must be radiation-hard. Both devices will improve the e.m. hermeticity of the detector in the search for new particles. Finely segmented and very compact electromagnetic calorimeters will match these requirements. Due to the high occupancy, fast front-end electronics will be needed. Monte Carlo studies were performed to investigate the impact of beam-beam interactions and physics background processes on the luminosity measurement, and of beamstrahlung on the performance of BeamCal, as well as to optimise the design of both calorimeters. Dedicated sensors, front-end and ADC ASICs have been designed for the ILC and prototypes are available. Prototypes of sensor planes fully assembled with readout electronics have been studied in electron beams.

physics.ins-det↗
arXiv2013

Measurement of the Luminosity in the ZEUS Experiment at HERA II

The luminosity in the ZEUS detector was measured using photons from electron bremsstrahlung. In 2001 the HERA collider was upgraded for operation at higher luminosity. At the same time the luminosity-measuring system of the ZEUS experiment was modified to tackle the expected higher photon rate and synchrotron radiation. The existing lead-scintillator calorimeter was equipped with radiation hard scintillator tiles and shielded against synchrotron radiation. In addition, a magnetic spectrometer was installed to measure the luminosity independently using photons converted in the beam-pipe exit window. The redundancy provided a reliable and robust luminosity determination with a systematic uncertainty of 1.7%. The experimental setup, the techniques used for luminosity determination and the estimate of the systematic uncertainty are reported.

physics.ins-det↗
arXiv2011

Luminometer for the future International Linear Collider - simulation and beam test results

LumiCal will be the luminosity calorimeter for the proposed International Large Detector of the International Linear Collider (ILC). The ILC physics program requires the integrated luminosity to be measured with a relative precision on the order of 10e-3, or 10e-4 when running in GigaZ mode. Luminosity will be determined by counting Bhabha scattering events coincident in the two calorimeter modules placed symmetrically on opposite sides of the interaction point. To meet these goals, the energy resolution of the calorimeter must be better than 1.5% at high energies. LumiCal has been designed as a 30-layer sampling calorimeter with tungsten as the passive material and silicon as the active material. Monte Carlo simulation using the Geant4 software framework has been used to identify design elements which adversely impact energy resolution and correct for them without loss of statistics. BeamCal, covering polar angles smaller than LumiCal, will serve for beam tuning, luminosity optimisation and high energy electron detection. Secondly, prototypes of the sensors and electronics for both detectors have been evaluated during beam tests, the results of which are also presented here.

physics.ins-det↗
arXiv2001

Multiplicity Fluctuations in DIS

The charged multiplicity fluctuations in deep-inelastic scattering (DIS) are investigated to test perturbative QCD and local parton hadron duality (LPHD). The fluctuations were measured with the ZEUS detector at HERA in restricted phase space domains in the current Breit frame region. The measurements are compared to analytic pQCD + LPHD predictions and QCD-based Monte Carlo models.

hep-ex↗
arXiv1999

Short-Range and Long-Range Correlations in DIS at HERA

Correlations in deep-inelastic scattering at HERA are investigated in order to test perturbative QCD and quark fragmentation universality. Two-particle correlations at small angular separations are measured in the Breit frame and compared to e+e- collisions. Also presented are the correlations between the current and target regions of the Breit frame.

hep-ex↗