arXiv subjects

Lakshminarayana Polavarapu

Publications and source records attributed to Lakshminarayana Polavarapu.

11 recordsLinked to original sources

arXiv2024

Absence of Anomalous Electron-Phonon Coupling in the Temperature Renormalization of the Gap of CsPbBr$_3$ Nanocrystals

Metal halide perovskites exhibit a fairly linear increase of the bandgap with increasing temperature, when crystallized in a tetragonal or cubic phase. In general, both thermal expansion and electron-phonon interaction effects contribute equally to this variation of the gap with temperature. Herein, we have disentangled both contributions in the case of colloidal CsPbBr$_3$ nanocrystals (NCs) by means of photoluminescence (PL) measurements as a function of temperature (from 80 K to ambient) and hydrostatic pressure (from atmospheric to ca. 1 GPa). At around room temperature, CsPbBr$_3$ NCs also show a linear increase of the bandgap with temperature with a slope similar to that of the archetypal methylammonium lead iodide (MAPbI$_3$) perovskite. This is somehow unexpected in view of the recent observations in mixed-cation Cs$_x$MA$_{1-x}$PbI$_3$ single crystals with low Cs content, for which Cs incorporation caused a reduction by a factor of two in the temperature slope of the gap. This effect was ascribed to an anomalous electron-phonon interaction induced by the coupling with vibrational modes admixed with the Cs translational dynamics inside the cage voids. Thus, no trace of anomalous coupling is found in CsPbBr$_3$ NCs. In fact, we show that the linear temperature renormalization exhibited by the gap of CsPbBr$_3$ NCs is shared with most metal halide perovskites, due to a common bonding/antibonding and atomic orbital character of the electronic band-edge states. In this way, we provide a deeper understanding of the gap temperature dependence in the general case when the A-site cation dynamics is not involved in the electron-phonon interaction.

cond-mat.mtrl-sci↗

arXiv2024

Ultrasmall CsPbBr3 Blue Emissive Perovskite Quantum Dots using K-alloyed Cs4PbBr6 Nanocrystals as Precursors

We report a colloidal synthesis of blue emissive, stable cube-shaped CsPbBr3 quantum dots (QDs) in the strong quantum confinement regime via a dissolution-recrystallization starting from pre-synthesized (KxCs1-x)4PbBr6 nanocrystals which are then reacted with PbBr2. This is markedly different from the known case of Cs4PbBr6 nanocrystals that react within seconds with PbBr2 and get transformed into much larger, green emitting CsPbBr3 nanocrystals. Here, instead, the conversion of (KxCs1-x)4PbBr6 nanocrystals to CsPbBr3 QDs occurs in a time span of hours, and tuning of the QDs size is achieved by adjusting the concentration of precursors. The QDs exhibit excitonic features in optical absorption that are tunable in the 420 - 452 nm range, accompanied by blue photoluminescence with quantum yield around 60%. Detailed spectroscopic investigations in both the single and multi-exciton regime reveal the exciton fine structure and the effect of Auger recombination of these CsPbBr3 QDs, confirming theoretical predictions for this system.

physics.app-ph↗

arXiv2024

Extending the Defect Tolerance of Halide Perovskite Nanocrystals to Hot Carrier Cooling Dynamics

Defect tolerance is a critical enabling factor for efficient lead-halide perovskite materials, but the current understanding is primarily on band-edge (cold) carriers, with significant debate over whether hot carriers (HCs) can also exhibit defect tolerance. Here, this important gap in the field is addressed by investigating how internationally-introduced traps affect HC relaxation in CsPbX3 nanocrystals (X = Br, I, or mixture). Using femtosecond interband and intraband spectroscopy, along with energy-dependent photoluminescence measurements and kinetic modelling, it is found that HCs are not universally defect tolerant in CsPbX3, but are strongly correlated to the defect tolerance of cold carriers, requiring shallow traps to be present (as in CsPbI3). It is found that HCs are directly captured by traps, instead of going through an intermediate cold carrier, and deeper traps cause faster HC cooling, reducing the effects of the hot phonon bottleneck and Auger reheating. This work provides important insights into how defects influence HCs, which will be important for designing materials for hot carrier solar cells, multiexciton generation, and optical gain media.

physics.app-ph↗

arXiv2023

Roadmap on Perovskite Light-Emitting Diodes

In recent years, the field of metal-halide perovskite emitters has rapidly emerged as a new community in solid-state lighting. Their exceptional optoelectronic properties have contributed to the rapid rise in external quantum efficiencies (EQEs) in perovskite light-emitting diodes (PeLEDs) from <1% (in 2014) to approaching 30% (in 2023) across a wide range of wavelengths. However, several challenges still hinder their commercialization, including the relatively low EQEs of blue/white devices, limited EQEs in large-area devices, poor device stability, as well as the toxicity of the easily accessible lead components and the solvents used in the synthesis and processing of PeLEDs. This roadmap addresses the current and future challenges in PeLEDs across fundamental and applied research areas, by sharing the community's perspectives. This work will provide the field with practical guidelines to advance PeLED development and facilitate more rapid commercialization.

physics.optics↗

arXiv2023

Direct Linearly-Polarised Electroluminescence from Perovskite Nanoplatelet Superlattices

Polarised light is critical for a wide range of applications, but is usually generated by filtering unpolarised light, which leads to significant energy losses and requires additional optics. Herein, the direct emission of linearly-polarised light is achieved from light-emitting diodes (LEDs) made of CsPbI3 perovskite nanoplatelet superlattices. Through use of solvents with different vapour pressures, the self-assembly of perovskite nanoplatelets is achieved to enable fine control over the orientation (either face-up or edge-up) and therefore the transition dipole moment. As a result of the highly-uniform alignment of the nanoplatelets, as well as their strong quantum and dielectric confinement, large exciton fine-structure splitting is achieved at the film level, leading to pure-red LEDs exhibiting a high degree of linear polarisation of 74.4% without any photonic structures. This work unveils the possibilities of perovskite nanoplatelets as a highly promising source of linearly-polarised electroluminescence, opening up the development of next-generation 3D displays and optical communications from this highly versatile, solution-processable system.

physics.optics↗

arXiv2020

Thickness-Dependence of Exciton-Exciton Annihilation in Halide Perovskite Nanoplatelets

Exciton-exciton annihilation (EEA) and Auger recombination are detrimental processes occurring in semiconductor optoelectronic devices at high carrier densities. Despite constituting one of the main obstacles for realizing lasing in semiconductor nanocrystals (NCs), the dependencies on NC size are not fully understood, especially for those with both weakly and strongly confined dimensions. Here, we use differential transmission spectroscopy to investigate the dependence of EEA on the physical dimensions of thickness-controlled 2D halide perovskite nanoplatelets (NPls). We find the EEA lifetimes to be extremely short on the order of 7-60 ps. Moreover, they are strongly determined by the NPl thickness with a power-law dependence according to τ_2~d^5.3. Additional measurements show that the EEA lifetimes also increase for NPls with larger lateral dimensions. These results show that a precise control of the physical dimensions is critical for deciphering the fundamental laws governing the process especially in 1D and 2D NCs.

cond-mat.mes-hall↗

arXiv2020

Identifying and reducing interfacial losses to enhance color-pure electroluminescence in blue-emitting perovskite nanoplatelet light-emitting diodes

Perovskite nanoplatelets (NPls) hold great promise for light-emitting applications, having achieved high photoluminescence quantum efficiencies (PLQEs) approaching unity in the blue wavelength range, where other metal-halide perovskites have typically been ineffective. However, the external quantum efficiency (EQE) of blue-emitting NPl light-emitting diodes (LEDs) have only reached 0.12%, with typical values well below 0.1%. In this work, we show that the performance of NPl LEDs is primarily hindered by a poor electronic interface between the emitter and hole-injector. Through Kelvin Probe and X-ray photoemission spectroscopy measurements, we reveal that the NPls have remarkably deep ionization potentials (>=6.5 eV), leading to large barriers for hole injection, as well as substantial non-radiative decay at the interface between the emitter and hole-injector. We find that an effective way to reduce these non-radiative losses is by using poly(triarylamine) interlayers. This results in an increase in the EQE of our blue LEDs emitting at 464 nm wavelength to 0.3%. We find that our results can be generalized to thicker sky-blue-emitting NPls, where we increase the EQE to 0.55% using the poly(triarylamine) interlayer. Our work also identifies the key challenges for further efficiency increases.

physics.optics↗

arXiv2020

Boosting tunable blue luminescence of halide perovskite nanoplatelets through post-synthetic surface trap repair

The easily tunable emission of halide perovskite nanocrystals throughout the visible spectrum makes them an extremely promising material for light-emitting applications. Whereas high quantum yields and long-term colloidal stability have already been achieved for nanocrystals emitting in the red and green spectral range, the blue region currently lags behind, with low quantum yields, broad emission profiles and insufficient colloidal stability. In this work, we present a facile synthetic approach for obtaining two-dimensional CsPbBr3 nanoplatelets with monolayer-precise control over their thickness, resulting in sharp photoluminescence and electroluminescence peaks with a tunable emission wavelength between 432 and 497 nm due to quantum confinement. Subsequent addition of a PbBr2-ligand solution repairs surface defects likely stemming from bromide and lead vacancies in a sub-ensemble of weakly emissive nanoplatelets. The overall photoluminescence quantum yield of the blue-emissive colloidal dispersions is consequently enhanced up to a value of 73+-2 %. Transient optical spectroscopy measurements focusing on the excitonic resonances further confirm the proposed repair process. Additionally, the high stability of these nanoplatelets in films and to prolonged UV light exposure is shown.

cond-mat.mes-hall↗

arXiv2020

Accelerated Carrier Relaxation through Reduced Coulomb Screening in 2D Halide Perovskite Nanoplatelets

For high-speed optoelectronic applications relying on fast relaxation or energy transfer mechanisms, understanding of carrier relaxation and recombination dynamics is critical. Here, we compare the differences in photoexcited carrier dynamics in 2D and quasi-3D colloidal methylammonium lead iodide perovskite nanoplatelets via differential transmission spectroscopy. We find that the cooling of excited electron-hole pairs by phonon emission progresses much faster and is intensity-independent in the 2D-case. This is due to the low dielectric surrounding of the thin perovskite layers, for which the Fröhlich interaction is screened less efficiently leading to higher and less density dependent carrier-phonon scattering rates. In addition, rapid dissipation of heat into the surrounding occurs due to the high surface-to-volume ratio. Furthermore, we observe a sub-picosecond dissociation of resonantly excited 1s excitons in the quasi-3D case, an effect which is suppressed in the 2D nanoplatelets due to their large exciton binding energies. The results highlight the importance of the surrounding environment of the inorganic nanoplatelets on their relaxation dynamics. Moreover, this 2D material with relaxation times in the sub-picosecond regime shows great potential for realizing devices such as photodetectors or all-optical switches operating at THz frequencies.

cond-mat.mes-hall↗

arXiv2014

Monitoring Galvanic Replacement Through Three-Dimensional Morphological and Chemical Mapping

Galvanic replacement reactions on metal nanoparticles are often used for the preparation of hollow nanostructures with tunable porosity and chemical composition, leading to tailored optical and catalytic properties. However, the precise interplay between the three-dimensional (3D) morphology and chemical composition of nanostructures during Galvanic replacement is not always well understood as the 3D chemical imaging of nanoscale materials is still challenging. It is especially far from straightforward to obtain detailed information from the inside of hollow nanostructures using electron microscopy techniques such as SEM or TEM. We demonstrate here that a combination of state-of-the-art EDX mapping with electron tomography results in the unambiguous determination of both morphology transformation and elemental composition of nanostructures in 3D, during Galvanic replacement of Ag nanocubes. This work provides direct and unambiguous experimental evidence leading to new insights in the understanding of the galvanic replacement reaction. In addition, the powerful approach presented here can be applied to a wide range of nanoscale transformation processes, which will undoubtedly guide the development of novel nanostructures.

cond-mat.mtrl-sci↗

arXiv2010

Monolayer Graphene as Saturable Absorber in Mode-locked Laser

We demonstrate that the intrinsic properties of monolayer graphene allow it to act as a more effective saturable absorber for mode-locking fiber lasers compared to multilayer graphene. The absorption of monolayer graphene can be saturated at lower excitation intensity compared to multilayer graphene, graphene with wrinkle-like defects, and functionalized graphene. Monolayer graphene has a remarkable large modulation depth of 95.3%, whereas the modulation depth of multilayer graphene is greatly reduced due to nonsaturable absorption and scattering loss. Picoseconds ultrafast laser pulse (1.23 ps) can be generated using monolayer graphene as saturable absorber. Due to the ultrafast relaxation time, larger modulation depth and lower scattering loss of monolayer graphene, it performs better than multilayer graphene in terms of pulse shaping ability, pulse stability and output energy.

physics.optics↗