Laurent Nony — Page 2

arXiv2005

Stability of an oscillating tip in Non-Contact Atomic Force Microscopy: theoretical and numerical investigations

This paper is a theoretical and a numerical investigation of the stability of a tip-cantilever system used in Non-Contact Atomic Force Microscopy (NC-AFM) when it oscillates close to a surface. No additional dissipative force is considered. The theoretical approach is based on a variationnal method exploiting a coarse grained operation that gives the temporal dependence of the nonlinear coupled equations of motion in amplitude and phase of the oscillator. Stability criterions for the resonance peak are deduced and predict a stable behavior of the oscillator in the vicinity of the resonance. The numerical approach is based on results obtained with a virtual NC-AFM developped in our group. The effect of the size of the stable domain in phase is investigated. These results are in particularly good agreement with the theoretical predictions. Also they show the influence of the phase shifter in the feedback loop and the way it can affect the damping signal.

physics.atm-clus↗

arXiv2005

Nonlinear dynamical properties of an oscillating tip-cantilever system in the tapping mode

The dynamical properties of an oscillating tip-cantilever system are now widely used in the field of scanning force microscopy. The aim of the present work is to get analytical expressions describing the nonlinear dynamical properties of the oscillator in noncontact and intermittent contact situations in the tapping mode. Three situations are investigated: the pure attractive interaction, the pure repulsive interaction, and a mixing of the two. The analytical solutions obtained allow general trends to be extracted: the noncontact and the intermittent contact show a very discriminate variation of the phase. Therefore the measurement of the phase becomes a simple way to identify whether or not the tip touches the surface during the oscillating period. It is also found that the key parameter governing the structure of the dynamical properties is the product of the quality factor by a reduced stiffness. In the attractive regime, the reduced stiffness is the ratio of an attractive effective stiffness and the cantilever one. In the repulsive regime, the reduced stiffness is the ratio between the contact stiffness and the cantilever one. The quality factor plays an important role. For large values of the quality factor; it is predicted that a pure topography can be obtained whatever the value of the contact stiffness. For a smaller quality factor, the oscillator becomes more sensitive to change of the local mechanical properties. As a direct consequence, varying the quality factor, for example with a vacuum chamber, would be a very interesting way to investigate soft materials either to access topographic information or nanomechanical properties.

physics.atm-clus↗