SearcharxivSearch

arXiv subjects

Lino Marques

Publications and source records attributed to Lino Marques.

2 recordsLinked to original sources

Merging Reaction to Cognition: A Hybrid Cognitive Strategy for Odour Source Localisation in Natural Environments

Chemical pollutants released into the environment are transported by turbulent flows, generating complex, intermittent plume structures that threaten ecosystems and human health. Rapid localisation of emission sources is critical, and field robots equipped with chemical sensors provide a viable means to perform this task. However, inferring source location from sensor readings remains difficult due to sparse detections and the absence of reliable concentration gradients. Existing approaches fall into two paradigms. Bio-inspired strategies rely on reactive behaviours triggered by detections, such as surge-casting, offering efficiency but requiring scenario-specific tuning. Cognitive strategies integrate observations into a probabilistic belief over source location. While more robust, they suffer from excessive exploration and strong dependence on belief accuracy. The Fast-Cognitive algorithm reduced this computational burden but preserved the fundamental limitations. Previous Markov chain analysis revealed that source-directed motions occur roughly twice as often following odour detections, indicating that reactive behaviours naturally emerge within cognitive frameworks. This work proposes a hybrid strategy that explicitly incorporates bio-inspired reactivity into belief-dependent motion planning. It introduces a detection-triggered switching mechanism formalising transitions between crossflow exploration and source-directed motion, prioritising source proximity over information gain. Behavioural parameters are derived directly from belief metrics, enabling adaptive reactivity without manual tuning. The approach is validated through simulations under three turbulence conditions and field experiments with an autonomous surface vehicle in the Mondego River, Portugal. Results show up to 50% reduction in travelled distance, 86% success rate, and 3.2m average localisation error.

cs.RO

An in-Contact Robotic System for the Process of Desoldering PCB Components

The disposal and recycling of electronic waste (e-waste) is a global challenge. The disassembly of components is a crucial step towards an efficient recycling process, avoiding the destructive methods. Although most disassembly work is still done manually due to the diversity and complexity of components, there is a growing interest in developing automated methods to improve efficiency and reduce labor costs. This study aims to robotize the desoldering process and extracting components from printed circuit boards (PCBs), with the goal of automating the process as much as possible. The proposed strategy consists of several phases, including the controlled contact of the robotic tool with the PCB components. A specific tool was developed to apply a controlled force against the PCB component, removing it from the board. The results demonstrate that it is feasible to remove the PCB components with a high success rate (approximately 100% for the bigger PCB components).

cs.RO