arXiv subjects

Linsey K. Rodenbach

Publications and source records attributed to Linsey K. Rodenbach.

7 recordsLinked to original sources

arXiv2025

A unified realization of electrical quantities from the quantum International System of Units

In the revised International System of Units (SI), the ohm and the volt are realized from the von Klitzing constant and the Josephson constant, and a practical realization of the ampere is possible by applying Ohm's law directly to the quantum Hall and Josephson effects. As a result, it is possible to create an instrument capable of realizing all three primary electrical units, but the development of such a system remains challenging. Here we report a unified realization of the volt, ohm, and ampere by integrating a quantum anomalous Hall resistor (QAHR) and a programmable Josephson voltage standard (PJVS) in a single cryostat. Our system has a quantum voltage output that ranges from 0.24 mV to 6.5 mV with combined relative uncertainties down to 3 $μ$V/V. The QAHR provides a realization of the ohm at zero magnetic field with uncertainties near 1 $μΩ$/$Ω$. We use the QAHR to convert a longitudinal current to a quantized Hall voltage and then directly compare that against the PJVS to realize the ampere. We determine currents in the range of 9.33 nA to 252 nA, and our lowest uncertainty is 4.3 $μ$A/A at 83.9 nA. For other current values, a systematic error that ranges from -10 $μ$A/A to -30 $μ$A/A is present due to the imperfect isolation of the PJVS microwave bias.

cond-mat.mes-hall↗

arXiv2025

Extended Fractional Chern Insulators Near Half Flux in Twisted Bilayer Graphene Above the Magic Angle

Fractional Chern insulators (FCIs) -- the lattice analog of fractional quantum Hall states -- form as fractionalized quasiparticles emerge in a partially-filled Chern band. This fractionalization is driven by the interplay of electronic interaction and quantum geometry of the underlying wavefunctions. Bilayer graphene with an interlayer twist near the magic angle of 1.1\textdegree\ hosts diverse correlated electronic states at zero magnetic field. When the twist angle exceeds 1.3\textdegree, the electronic bandwidth is sufficient to suppress the zero-field correlated states. Yet applying a magnetic field can restore the importance of electron-electron interactions. Here, we report strongly-correlated phases when a 1.37\textdegree\ twisted bilayer graphene sample is tuned to near half a magnetic flux quantum per moiré cell, deep into the Hofstadter regime. Most notably, well-quantized odd-denominator FCI states appear in multiple Hofstadter subbands over unusually large ranges of density. We also observe a bending and resetting of the Landau minifan reminiscent of behavior commonly seen in magic-angle samples near integer filling at low magnetic field.

cond-mat.mes-hall↗

arXiv2023

Low-damage electron beam lithography for nanostructures on Bi$_2$Te$_3$-class topological insulator thin films

Nanostructured topological insulators (TIs) have the potential to impact a wide array of condensed matter physics topics, ranging from Majorana physics to spintronics. However, the most common TI materials, the Bi$_2$Se$_3$ family, are easily damaged during nanofabrication of devices. In this paper, we show that electron beam lithography performed with a 30 or 50 kV accelerating voltage -- common for nanopatterning in academic facilities -- damages both nonmagnetic TIs and their magnetically-doped counterparts at unacceptable levels. We additionally demonstrate that electron beam lithography with a 10 kV accelerating voltage produces minimal damage detectable through low-temperature electronic transport. Although reduced accelerating voltages present challenges in creating fine features, we show that with careful choice of processing parameters, particularly the resist, 100 nm features are reliably achievable.

cond-mat.mes-hall↗

arXiv2022

Measured potential profile in a quantum anomalous Hall system suggests bulk-dominated current flow

Ideally, quantum anomalous Hall systems should display zero longitudinal resistance. Yet in experimental quantum anomalous Hall systems elevated temperature can make the longitudinal resistance finite, indicating dissipative flow of electrons. Here, we show that the measured potentials at multiple locations within a device at elevated temperature are well-described by solution of Laplace's equation, assuming spatially-uniform conductivity, suggesting non-equilibrium current flows through the two-dimensional bulk. Extrapolation suggests that at even lower temperatures current may still flow primarily through the bulk rather than, as had been assumed, through edge modes. An argument for bulk current flow previously applied to quantum Hall systems supports this picture.

cond-mat.mes-hall↗

arXiv2022

Unusual magnetotransport in twisted bilayer graphene from strain-induced open Fermi surfaces

Anisotropic hopping in a toy Hofstadter model was recently invoked to explain a rich and surprising Landau spectrum measured in twisted bilayer graphene away from the magic angle. Suspecting that such anisotropy could arise from unintended uniaxial strain, we extend the Bistritzer-MacDonald model to include uniaxial heterostrain. We find that such strain strongly influences band structure, shifting the three otherwise-degenerate van Hove points to different energies. Coupled to a Boltzmann magnetotransport calculation, this reproduces previously-unexplained non-saturating $B^2$ magnetoresistance over broad ranges of density near filling $ν=\pm 2$, and predicts subtler features that had not been noticed in the experimental data. In contrast to these distinctive signatures in longitudinal resistivity, the Hall coefficient is barely influenced by strain, to the extent that it still shows a single sign change on each side of the charge neutrality point -- surprisingly, this sign change no longer occurs at a van Hove point. The theory also predicts a marked rotation of the electrical transport principal axes as a function of filling even for fixed strain and for rigid bands. More careful examination of interaction-induced nematic order versus strain effects in twisted bilayer graphene could thus be in order.

cond-mat.mes-hall↗

arXiv2021

Nanoscale electronic transparency of wafer-scale hexagonal boron nitride

Monolayer hBN has attracted interest as a potentially weakly interacting 2D insulating layer in heterostructures. Recently, wafer-scale hBN growth on Cu(111) has been demonstrated for semiconductor chip fabrication processes and transistor action. For all these applications, the perturbation on the underlying electronically active layers is critical. For example, while hBN on Cu(111) has been shown to preserve the Cu(111) surface state 2D electron gas, it was previously unknown how this varies over the sample and how it is affected by local electronic corrugation. Here, we demonstrate that the Cu(111) surface state under wafer-scale hBN is robustly homogeneous in energy and spectral weight over nanometer length scales and over atomic terraces. We contrast this with a benchmark spectral feature associated with interaction between BN atoms and the Cu surface, which varies with the Moiré pattern of the hBN/Cu(111) sample and is dependent on atomic registry. This work demonstrates that fragile 2D electron systems and interface states are largely unperturbed by local variations created by the hBN due to atomic-scale interactions with the substrate, thus providing a remarkably transparent window on low-energy electronic structure below the hBN monolayer.

cond-mat.mtrl-sci↗

arXiv2021

Bulk dissipation in the quantum anomalous Hall effect

Even at the lowest accessible temperatures, measurements of the quantum anomalous Hall (QAH) effect have indicated the presence of parasitic dissipative conduction channels. There is no consensus whether parasitic conduction is related to processes in the bulk or along the edges. Here, we approach this problem by comparing transport measurements of Hall bar and Corbino geometry devices fabricated from Cr-doped (BiSb)$_2$Te$_3$. We identify bulk conduction as the dominant source of dissipation at all values of temperature and in-plane electric field. Furthermore, we observe identical breakdown phenomenology in both geometries, indicating that breakdown of the QAH phase is a bulk process. The methodology developed in this study could be used to identify dissipative conduction mechanisms in new QAH materials, ultimately guiding material development towards realization of the QAH effect at higher temperatures.

cond-mat.mes-hall↗