Searcharxiv⌕ Search

arXiv subjects

Luis González-Fernández

Publications and source records attributed to Luis González-Fernández.

3 recordsLinked to original sources

Spectral emissivity of copper and nickel in the mid-infrared range between 250 and 900 $^{\circ}$C

A study on the radiative properties of two pure metals, copper and nickel, using a high accuracy radiometer is carried out. Their spectral emissivity between 3 and 21 μm and its dependence on emission angle and temperature between 250 and 900 $^{\circ}$C is measured. An evolution of the samples emissivity associated to the surface stress relaxation is observed, which is relieved after two or three heating cycles. Spectral emissivity of metals usually decreases as wavelength increases, but in the case of copper an irregular behaviour has been found. Its spectral emissivity shows a broad plateau around 10 μm, which can be due to the anomalous skin effect. On the other hand, the emissivity usually increases with temperature, but in the case of nickel the emissivity changes little and even slightly decreases for T > 700 $^{\circ}$C. The exper-imental directional emissivity of both metals shows the dependence on the emission angle predicted by the electromagnetic theory for metallic samples. By increasing the emission angle, the emissivity dependence on the wavelength strongly decreases. Furthermore, in the case of nickel, an emissivity increase with wavelength is observed for k > 20 μm. The electrical resistivity for both metals is obtained by fitting the experimental emissivity curves with the Hagen Rubens equation. The results agree fairly well with direct electrical resistivity measurements for copper but show a poor agreement in the case of nickel.

physics.app-ph↗

Thermal emissivity spectra and structural phase transitions of the eutectic Mg-51%Zn alloy: A candidate for thermal energy storage

The thermal emissivity spectrum in the mid infrared range (3 to 21 $μ$m) as well as its dependence on temperature between 225 and 320 $^{\circ}$C has been obtained for the Mg-51%Zn (weight %) eutectic alloy, a candidate for thermal storage. The spectral curves show the typical behaviour of metals and alloys, with emissivity values between 0.05 and 0.2. It was also found that the emissivity spectrum shows variations in each heating cycle during the first few cycles. These changes are associated with the presence of metastable phases in the solid solid phase transition, present in the alloy below the melting point. The absence of signs of oxidation in air is very favourable for the use of this alloy in thermal energy storage systems. Moreover, the total normal emissivity curves obtained from dynamic spectral measurements have allowed analysing the behaviour phase transition sequence present in this alloy. These experimental results indicate that accurate emissivity measurements can be sensitive enough to account for the structural phase transitions in metals and alloys.

cond-mat.mtrl-sci↗

First spectral emissivity study of a solar selective coating in the 150 to 600 C temperature range

A complete experimental study of temperature dependence of the total spectral emissivity has been performed, for the first time, for absorber reflector selective coatings used in concentrated solar power (CSP) systems for energy harvesting. The coating consist of double cermet layers of silicon oxide with different amounts of molybdenum over a silver infrared mirror layer. The experimental measurements were carried out by a high accurate radiometer (HAIRL) with controlled atmosphere in the mid-infrared and for temperatures between 150 and 600 C. The spectral emissivity is nearly constant in this temperature range. Therefore, the temperature dependence of the total emissivity is given by Planck function. These results were compared with those obtained with the usual calculus using room temperature reflectance spectrum. Finally, the performance of the coating was analyzed by comparison of coated respect to non-coated stainless steel.

physics.app-ph↗