Searcharxiv⌕ Search

arXiv subjects

M. Bianco

Publications and source records attributed to M. Bianco.

13 recordsLinked to original sources
arXiv2026

Efficiency measurements of GEM GE1/1 chambers in the upgraded CMS Endcap Muon System using 2023 collision data at $\sqrt{s}=13.6$ TeV

The CMS experiment at the Large Hadron Collider employs Gas Electron Multiplier (GEM) detectors, a technology based on gaseous ionization, as one of the muon detectors. The muon spectrometer is being upgraded to handle the increased muon flux in the forward region. This study analyzes muon detection efficiency in the GE1/1 triple-GEM detector, using 2023 proton-proton collision data at $\sqrt{s}=13.6$ TeV. A dataset enriched with muons from Z boson decay, with a total recorded luminosity of 17.8 fb$^{-1}$ has been used for this study. The detection efficiency of 137 GEM detectors are measured using muon trajectories established using other detectors in the tracking and muon systems, without use of the GEM detectors. The average efficiency of 137 GEM detectors is $\sim$93.3$\%$. A subset of 108 detectors that had no shorts were operated at the nominal HV working point with average efficiency of $\sim$96$\%$. Efficiency is found to be unaffected by the number of p-p interactions per bunch crossing (pile-up).

hep-ex↗
arXiv2025

Square Kilometre Array Science Data Challenge 3a: foreground removal for an EoR experiment

We present and analyse the results of the Science data challenge 3a (SDC3a, https://sdc3.skao.int/challenges/foregrounds), an EoR foreground-removal community-wide exercise organised by the Square Kilometre Array Observatory (SKAO). The challenge ran for 8 months, from March to October 2023. Participants were provided with realistic simulations of SKA-Low data between 106 MHz and 196 MHz, including foreground contamination from extragalactic as well as Galactic emission, instrumental and systematic effects. They were asked to deliver cylindrical power spectra of the EoR signal, cleaned from all corruptions, and the corresponding confidence levels. Here we describe the approaches taken by the 17 teams that completed the challenge, and we assess their performance using different metrics. The challenge results provide a positive outlook on the capabilities of current foreground-mitigation approaches to recover the faint EoR signal from SKA-Low observations. The median error committed in the EoR power spectrum recovery is below the true signal for seven teams, although in some cases there are some significant outliers. The smallest residual overall is $4.2_{-4.2}^{+20} \times 10^{-4}\,\rm{K}^2h^{-3}$cMpc$^{3}$ across all considered scales and frequencies. The estimation of confidence levels provided by the teams is overall less accurate, with the true error being typically under-estimated, sometimes very significantly. The most accurate error bars account for $60 \pm 20$\% of the true errors committed. The challenge results provide a means for all teams to understand and improve their performance. This challenge indicates that the comparison between independent pipelines could be a powerful tool to assess residual biases and improve error estimation.

astro-ph.IM↗
arXiv2024

Interim report for the International Muon Collider Collaboration (IMCC)

The International Muon Collider Collaboration (IMCC) [1] was established in 2020 following the recommendations of the European Strategy for Particle Physics (ESPP) and the implementation of the European Strategy for Particle Physics-Accelerator R&D Roadmap by the Laboratory Directors Group [2], hereinafter referred to as the the European LDG roadmap. The Muon Collider Study (MuC) covers the accelerator complex, detectors and physics for a future muon collider. In 2023, European Commission support was obtained for a design study of a muon collider (MuCol) [3]. This project started on 1st March 2023, with work-packages aligned with the overall muon collider studies. In preparation of and during the 2021-22 U.S. Snowmass process, the muon collider project parameters, technical studies and physics performance studies were performed and presented in great detail. Recently, the P5 panel [4] in the U.S. recommended a muon collider R&D, proposed to join the IMCC and envisages that the U.S. should prepare to host a muon collider, calling this their "muon shot". In the past, the U.S. Muon Accelerator Programme (MAP) [5] has been instrumental in studies of concepts and technologies for a muon collider.

physics.acc-ph↗
arXiv2024

Heart Rate Variability Series is the Output of a non-Chaotic System driven by Dynamical Noise

Heart rate variability (HRV) series reflects the dynamical variation of heartbeat-to-heartbeat intervals in time and is one of the outputs of the cardiovascular system. Over the years, this system has been recognized for generating nonlinear and complex heartbeat dynamics, with the latter referring to a high sensitivity to small -- theoretically infinitesimal -- input changes. While early research associated chaotic behavior with the cardiovascular system, evidence of stochastic inputs to the system, i.e., a physiological noise, invalidated those conclusions. To date, a comprehensive characterization of the cardiovascular system dynamics, accounting for dynamical noise input, has not been undertaken. In this study, we propose a novel methodological framework for evaluating the presence of regular or chaotic dynamics in noisy dynamical systems. The method relies on the estimation of asymptotic growth rate of noisy mean square displacement series in a two-dimensional phase space. We validated the proposed method using synthetic series comprising well-known regular and chaotic maps. We applied the method to real HRV series from healthy subjects, as well as patients with atrial fibrillation and congestive heart failure, during unstructured long-term activity. Results indicate that HRV series are consistently generated by a regular system driven by dynamical noise.

eess.SP↗
arXiv2023

The stability of deep learning for 21cm foreground removal across various sky models and frequency-dependent systematics

Deep learning (DL) has recently been proposed as a novel approach for 21cm foreground removal. Before applying DL to real observations, it is essential to assess its consistency with established methods, its performance across various simulation models and its robustness against instrumental systematics. This study develops a commonly used U-Net and evaluates its performance for post-reionisation foreground removal across three distinct sky simulation models based on pure Gaussian realisations, the Lagrangian perturbation theory, and the Planck sky model. Stable outcomes across the models are achieved provided that training and testing data align with the same model. On average, the residual foreground in the U-Net reconstructed data is $\sim$10% of the signal across angular scales at the considered redshift range. Comparable results are found with traditional approaches. However, blindly using a network trained on one model for data from another model yields inaccurate reconstructions, emphasising the need for consistent training data. The study then introduces frequency-dependent Gaussian beams and gain drifts to the test data. The network struggles to denoise data affected by "unexpected" systematics without prior information. However, after re-training consistently with systematics-contaminated data, the network effectively restores its reconstruction accuracy. This highlights the importance of incorporating prior systematics knowledge during training for successful denoising. Our work provides critical guidelines for using DL for 21cm foreground removal, tailored to specific data attributes. Notably, it is the first time that DL has been applied to the Planck sky model being most realistic foregrounds at present.

astro-ph.CO↗
arXiv2022

Quality Control of Mass-Produced GEM Detectors for the CMS GE1/1 Muon Upgrade

The series of upgrades to the Large Hadron Collider, culminating in the High Luminosity Large Hadron Collider, will enable a significant expansion of the physics program of the CMS experiment. However, the accelerator upgrades will also make the experimental conditions more challenging, with implications for detector operations, triggering, and data analysis. The luminosity of the proton-proton collisions is expected to exceed $2-3\times10^{34}$~cm$^{-2}$s$^{-1}$ for Run 3 (starting in 2022), and it will be at least $5\times10^{34}$~cm$^{-2}$s$^{-1}$ when the High Luminosity Large Hadron Collider is completed for Run 4. These conditions will affect muon triggering, identification, and measurement, which are critical capabilities of the experiment. To address these challenges, additional muon detectors are being installed in the CMS endcaps, based on Gas Electron Multiplier technology. For this purpose, 161 large triple-Gas Electron Multiplier detectors have been constructed and tested. Installation of these devices began in 2019 with the GE1/1 station and will be followed by two additional stations, GE2/1 and ME0, to be installed in 2023 and 2026, respectively. The assembly and quality control of the GE1/1 detectors were distributed across several production sites around the world. We motivate and discuss the quality control procedures that were developed to standardize the performance of the detectors, and we present the final results of the production. Out of 161 detectors produced, 156 detectors passed all tests, and 144 detectors are now installed in the CMS experiment. The various visual inspections, gas tightness tests, intrinsic noise rate characterizations, and effective gas gain and response uniformity tests allowed the project to achieve this high success rate.

physics.ins-det↗
arXiv2022

MPGDs for tracking and Muon detection at future high energy physics colliders

In the next years, the energy and intensity frontiers of the experimental Particle Physics will be pushed forward with the upgrade of existing accelerators (LHC at CERN) and the envisaged construction of new machines at energy scales up to hundreds TeV or with unprecedented intensity (FCC-hh, FCC-ee, ILC, Muon Collider). Large size, cost-effective, high-efficiency detection systems in high background environments are required in order to accomplish the physics program. MPGDs offer a diversity of technologies that allow them to meet the required performance challenges at future facilities thanks to the specific advantages that each technology provides. MPGDs allow stable operation, with environmentally friendly gas mixtures, at very high background particle flux with high detection efficiency and excellent spatial resolution. These features make MPGD one of the primary choices as precise muon tracking and trigger system in general-purpose detectors at future HEP colliders. In addition, the low material budget and the flexibility of the base material make MPGDs suitable for the development of very light, full cylindrical fine tracking inner trackers at lepton colliders. On-going R&Ds aim at pushing the detector performance at the limits of each technology. We are working in continuing to consolidate the construction and stable operation of large-size detectors, able to cope with large particle fluxes. In this white paper, we describe some of the most prominent MPGD technologies, their performance measurements, the challenges faced in the most recent applications, and the areas of improvement towards efficient tracking and Muon detection at future high energy physics colliders.

physics.ins-det↗
arXiv2021

Performance of a Triple-GEM Demonstrator in $pp$ Collisions at the CMS Detector

After the Phase-2 high-luminosity upgrade to the Large Hadron Collider (LHC), the collision rate and therefore the background rate will significantly increase, particularly in the high $η$ region. To improve both the tracking and triggering of muons, the Compact Muon Solenoid (CMS) Collaboration plans to install triple-layer Gas Electron Multiplier (GEM) detectors in the CMS muon endcaps. Demonstrator GEM detectors were installed in CMS during 2017 to gain operational experience and perform a preliminary investigation of detector performance. We present the results of triple-GEM detector performance studies performed in situ during normal CMS and LHC operations in 2018. The distribution of cluster size and the efficiency to reconstruct high $p_T$ muons in proton--proton collisions are presented as well as the measurement of the environmental background rate to produce hits in the GEM detector.

physics.ins-det↗
arXiv2021

Modeling the triple-GEM detector response to background particles for the CMS Experiment

An estimate of environmental background hit rate on triple-GEM chambers is performed using Monte Carlo (MC) simulation and compared to data taken by test chambers installed in the CMS experiment (GE1/1) during Run-2 at the Large Hadron Collider (LHC). The hit rate is measured using data collected with proton-proton collisions at 13 TeV and a luminosity of 1.5$\times10^{34}$ cm$^{-2}$ s$^{-1}$. The simulation framework uses a combination of the FLUKA and Geant4 packages to obtain the hit rate. FLUKA provides the radiation environment around the GE1/1 chambers, which is comprised of the particle flux with momentum direction and energy spectra ranging from $10^{-11}$ to $10^{4}$ MeV for neutrons, $10^{-3}$ to $10^{4}$ MeV for $γ$'s, $10^{-2}$ to $10^{4}$ MeV for $e^{\pm}$, and $10^{-1}$ to $10^{4}$ MeV for charged hadrons. Geant4 provides an estimate of detector response (sensitivity) based on an accurate description of detector geometry, material composition and interaction of particles with the various detector layers. The MC simulated hit rate is estimated as a function of the perpendicular distance from the beam line and agrees with data within the assigned uncertainties of 10-14.5%. This simulation framework can be used to obtain a reliable estimate of background rates expected at the High Luminosity LHC.

physics.ins-det↗
arXiv2020

Interstrip Capacitances of the Readout Board used in Large Triple-GEM Detectors for the CMS Muon Upgrade

We present analytical calculations, Finite Element Analysis modeling, and physical measurements of the interstrip capacitances for different potential strip geometries and dimensions of the readout boards for the GE2/1 triple-Gas Electron Multiplier detector in the CMS muon system upgrade. The main goal of the study is to find configurations that minimize the interstrip capacitances and consequently maximize the signal-to-noise ratio for the detector. We find agreement at the 1.5--4.8% level between the two methods of calculations and on the average at the 17% level between calculations and measurements. A configuration with halved strip lengths and doubled strip widths results in a measured 27--29% reduction over the original configuration while leaving the total number of strips unchanged. We have now adopted this design modification for all eight module types of the GE2/1 detector and will produce the final detector with this new strip design.

physics.ins-det↗
arXiv2009

ATLAS RPC offline monitoring and data quality assessment

In this work several aspects of ATLAS RPC offline monitoring and data quality assessment are illustrated with cosmics data selected by RPC trigger. These correspond to trigger selection, front-end mapping, detection efficiency and occupancy, which are studied in terms of low level quantities such as: RPC off-line hits and standalone tracks. The tools and techniques presented are also extended to the forthcoming LHC p-p beam collisions.

physics.ins-det↗
arXiv2006

ATLAS RPC Quality Assurance results at INFN Lecce

The main results of the quality assurance tests performed on the Resistive Plate Chamber used by the ATLAS experiment at LHC as muon trigger chambers are reported and discussed. Since July 2004, about 270 RPC units has been certified at INFN Lecce site and delivered to CERN, for being integrated in the final muon station of the ATLAS barrel region. We show the key RPC characteristics which qualify the performance of this detector technology as muon trigger chamber in the harsh LHC enviroments. These are dark current, chamber efficiency, noise rate, gas volume tomography, and gas leakage.

physics.ins-det↗