arXiv subjects

M. Billiani

Publications and source records attributed to M. Billiani.

3 recordsLinked to original sources

arXiv2025

ExoClock Project IV: A homogeneous catalogue of 620 updated exoplanet ephemerides

The ExoClock project is an open platform aiming to monitor exoplanets by integrating observations from space and ground based telescopes. This study presents an updated catalogue of 620 exoplanet ephemerides, integrating 30000 measurements from ground-based telescopes (the ExoClock network), literature, and space telescopes (Kepler, K2 and TESS). The updated catalogue includes 277 planets from TESS which require special observing strategies due to their shallow transits or bright host stars. This study demonstrates that data from larger telescopes and the employment of new methodologies such as synchronous observations with small telescopes, are capable of monitoring special cases of planets. The new ephemerides show that 45% of the planets required an update while the results show an improvement of one order of magnitude in prediction uncertainty. The collective analysis also enabled the identification of new planets showing TTVs, highlighting the importance of extensive observing coverage. Developed in the context of the ESA's Ariel space mission, with the goal of delivering a catalogue with reliable ephemerides to increase the mission efficiency, ExoClock's scope and service have grown well beyond the remit of Ariel. The ExoClock project has been operating in the framework of open science, and all tools and products are accessible to everyone within academia and beyond, to support efficient scheduling of future exoplanet observations, especially from larger telescopes where the pressure for time allocation efficiency is higher (Ariel, JWST, VLT, ELT, Subaru etc). The inclusion of diverse audiences in the process and the collaborative mode not only foster democratisation of science but also enhance the quality of the results.

astro-ph.EP↗

arXiv2023

Scaling slowly rotating asteroids by stellar occultations

As evidenced by recent survey results, majority of asteroids are slow rotators (P>12 h), but lack spin and shape models due to selection bias. This bias is skewing our overall understanding of the spins, shapes, and sizes of asteroids, as well as of their other properties. Also, diameter determinations for large (>60km) and medium-sized asteroids (between 30 and 60 km) often vary by over 30% for multiple reasons. Our long-term project is focused on a few tens of slow rotators with periods of up to 60 hours. We aim to obtain their full light curves and reconstruct their spins and shapes. We also precisely scale the models, typically with an accuracy of a few percent. We used wide sets of dense light curves for spin and shape reconstructions via light-curve inversion. Precisely scaling them with thermal data was not possible here because of poor infrared data: large bodies are too bright for WISE mission. Therefore, we recently launched a campaign among stellar occultation observers, to scale these models and to verify the shape solutions, often allowing us to break the mirror pole ambiguity. The presented scheme resulted in shape models for 16 slow rotators, most of them for the first time. Fitting them to stellar occultations resolved previous inconsistencies in size determinations. For around half of the targets, this fitting also allowed us to identify a clearly preferred pole solution, thus removing the ambiguity inherent to light-curve inversion. We also address the influence of the uncertainty of the shape models on the derived diameters. Overall, our project has already provided reliable models for around 50 slow rotators. Such well-determined and scaled asteroid shapes will, e.g. constitute a solid basis for density determinations when coupled with mass information. Spin and shape models continue to fill the gaps caused by various biases.

astro-ph.EP↗

arXiv2022

Citizen Science Astronomy with a Network of Small Telescope: The Launch and Deployment of JWST

We present a coordinated campaign of observations to monitor the brightness of the James Webb Space Telescope (JWST) as it travels toward the second Earth-Sun Lagrange point and unfolds using the network ofUnistellar digital telescopes. Those observations collected by citizen astronomers across the world allowed us to detect specific phases such as the separation from the booster, glare due to a change of orientation after a maneuver, the unfurling of the sunshield, and deployment of the primary mirror. After deployment of the sunshield on January 6 2022, the 6-h lightcurve has a significant amplitude and shows small variations due to the artificial rotation of the space telescope during commissionning. These variations could be due to the deployment of the primary mirror or some changes in orientation of the space telescope. This work illustrates the power of a worldwide array of small telescopes, operated by citizen astronomers, to conduct large scientific campaigns over a long timeframe. In the future, our network and others will continue to monitor JWST to detect potential degradations to the space environment by comparing the evolution of the lightcurve.

astro-ph.IM↗