SearcharxivSearch

arXiv subjects

M. Liebsch

Publications and source records attributed to M. Liebsch.

3 recordsLinked to original sources

Measurement of the muon neutrino charged-current cross section with SND@LHC

We report a measurement of the muon neutrino charged-current (CC) interaction cross section on tungsten using the electronic detectors of the SND@LHC experiment at the CERN Large Hadron Collider. The analysis uses proton--proton collision data at a centre-of-mass energy of $\sqrt{s} = 13.6$ TeV, corresponding to an integrated luminosity of $68.6 ~\text{fb}^{-1}$ collected during LHC Run 3 in 2022 and 2023. A total of 31 $\nu_\mu$ CC candidates are selected against an expected background of $5.0 \pm 1.1$ events, consistent with a signal expectation of $24^{+10}_{-9}$ events. The signal strength is measured to be $\hat{\mu} = 1.09^{+0.72}_{-0.37}$, and the combined muon neutrino and anti-neutrino CC cross section on tungsten is determined to be $\sigma(\nu_\mu + \bar{\nu}_\mu) = (37^{+24}_{-12})\times 10^{-35}~\text{cm}^2$ at a median energy of $228$ GeV. In addition, a calorimetric measurement of the hadronic energies of the neutrino candidate events is performed, making use of calibration data from dedicated test-beam campaigns.

hep-ex

The first superconducting final focus quadrupole prototype of the FCC-ee study

A single aperture Canted-Cosine-Theta (CCT) quadrupole magnet, made of NbTi superconductors, has been developed for the final focus region of the FCC-ee study. The conductor layout is optimised to mitigate edge effects on one of the two sides of the magnet that typically lead to undesired higher-order multipoles. Experimental results of a prototype, including paraffin wax impregnation and cryogenic temperature measurements, are presented. The magnet exhibits no training behaviour, surpassing the nominal current during the initial ramp. Field quality is excellent, with higher-order multipoles below $1\times 10^{-4}$ units, consistent with simulations and room temperature tests. These findings confirm the potential of superconducting CCT magnets to offer compact solutions for applications demanding stringent field quality.

physics.acc-ph

Magnetic Measurements at Warm of the First FCC-ee Final Focus Quadrupole Prototype

The first FCC-ee final focus quadrupole prototype has been designed, manufactured, assembled and tested at warm. The prototype is a single aperture quadrupole magnet of the CCT type. One edge of the magnet was designed with local multipole cancellation, whereas the other was left with the conventional design. An optimized rotating induction-coil sensor was used. A technique was developed to take into account field distortions due to the environment of the test and distinguish them from magnet effects, demonstrating an excellent field quality for the prototype.

physics.acc-ph