SearcharxivSearch

arXiv subjects

M. Poot

Publications and source records attributed to M. Poot.

10 recordsLinked to original sources

Growth of Aluminum Nitride on a Silicon Nitride Substrate for Hybrid Photonic Circuits

Aluminum nitride (AlN) is an emerging material for integrated quantum photonics with its excellent linear and nonlinear optical properties. In particular, its second-order nonlinear susceptibility $\chi^{(2)}$ allows single-photon generation. We have grown AlN thin films on silicon nitride via reactive DC magnetron sputtering. The thin films have been characterized using X-ray diffraction, optical reflectometry, atomic force microscopy, and scanning electron microscopy. The crystalline properties of the thin films have been improved by optimizing the nitrogen to argon ratio and the magnetron DC power of the deposition process. X-ray diffraction measurements confirm the fabrication of high-quality c-axis oriented thin films with a full width at half maximum of the rocking curves of 3.9 deg. for 300-nm-thick films. Atomic force microscopy measurements reveal a root mean square surface roughness below 1 nm. The AlN deposition on SiN allows us to fabricate hybrid photonic circuits with a new approach that avoids the challenging patterning of AlN.

cond-mat.mtrl-sci

Direct and parametric synchronization of a graphene self-oscillator

We explore the dynamics of a graphene nanomechanical oscillator coupled to a reference oscillator. Circular graphene drums are forced into self-oscillation, at a frequency fosc, by means of photothermal feedback induced by illuminating the drum with a continuous-wave red laser beam. Synchronization to a reference signal, at a frequency fsync, is achieved by shining a power-modulated blue laser onto the structure. We investigate two regimes of synchronization as a function of both detuning and signal strength for direct (fsync = fosc) and parametric locking (fsync = 2fosc). We detect a regime of phase resonance, where the phase of the oscillator behaves as an underdamped second-order system, with the natural frequency of the phase resonance showing a clear power-law dependence on the locking signal strength. The phase resonance is qualitatively reproduced using a forced van der Pol-Duffing-Mathieu equation.

cond-mat.mes-hall

Backaction limits on self-sustained optomechanical oscillations

The maximum amplitude of mechanical oscillators coupled to optical cavities are studied both analytically and numerically. The optical backaction on the resonator enables self-sustained oscillations whose limit cycle is set by the dynamic range of the cavity. The maximum attainable amplitude and the phonon generation quantum efficiency of the backaction process are studied for both unresolved and resolved cavities. Quantum efficiencies far exceeding one are found in the resolved sideband regime where the amplitude is low. On the other hand the maximum amplitude is found in the unresolved system. Finally, the role of mechanical nonlinearities is addressed.

physics.optics

Discrete-time quadrature feedback cooling of a radio-frequency mechanical resonator

We have employed a feedback cooling scheme, which combines high-frequency mixing with digital signal processing. The frequency and damping rate of a 2 MHz micromechanical resonator embedded in a dc SQUID are adjusted with the feedback, and active cooling to a temperature of 14.3 mK is demonstrated. This technique can be applied to GHz resonators and allows for flexible control strategies.

cond-mat.mes-hall

Tunable backaction of a dc SQUID on an integrated micromechanical resonator

We have measured the backaction of a dc superconducting quantum interference device (SQUID) position detector on an integrated 1 MHz flexural resonator. The frequency and quality factor of the micromechanical resonator can be tuned with bias current and applied magnetic flux. The backaction is caused by the Lorentz force due to the change in circulating current when the resonator displaces. The experimental features are reproduced by numerical calculations using the resistively and capacitively shunted junction (RCSJ) model.

cond-mat.mes-hall

Nonlinear modal interactions in clamped-clamped mechanical resonators

A theoretical and experimental investigation is presented on the intermodal coupling between the flexural vibration modes of a single clamped-clamped beam. Nonlinear coupling allows an arbitrary flexural mode to be used as a self-detector for the amplitude of another mode, presenting a method to measure the energy stored in a specific resonance mode. Experimentally observed complex nonlinear dynamics of the coupled modes are quantitatively captured by a model which couples the modes via the beam extension; the same mechanism is responsible for the well-known Duffing nonlinearity in clamped-clamped beams.

cond-mat.mes-hall

Single electron tunneling through high-Q single-wall carbon nanotube NEMS resonators

By first lithographically fabricating contact electrodes and then as last step growing carbon nanotubes with chemical vapour deposition across the ready-made chip, many potential contamination mechanisms for nanotube devices can be avoided. Combining this with pre-defined trenches on the chip, such that the nanotubes are freely suspended above the substrate, enables the formation of highly regular electronic systems. We show that, in addition, such suspended ultra-clean nanotubes provide excellent high-frequency and low-dissipation mechanical resonators. The motion detection mechanism of our experiment is discussed, and we measure the effect of Coulomb blockade and the back-action of single electron tunneling on the mechanical motion. In addition data on the mechanical higher modes is presented.

cond-mat.mes-hall

Strong coupling between single-electron tunneling and nano-mechanical motion

Nanoscale resonators that oscillate at high frequencies are useful in many measurement applications. We studied a high-quality mechanical resonator made from a suspended carbon nanotube driven into motion by applying a periodic radio frequency potential using a nearby antenna. Single-electron charge fluctuations created periodic modulations of the mechanical resonance frequency. A quality factor exceeding 10^5 allows the detection of a shift in resonance frequency caused by the addition of a single-electron charge on the nanotube. Additional evidence for the strong coupling of mechanical motion and electron tunneling is provided by an energy transfer to the electrons causing mechanical damping and unusual nonlinear behavior. We also discovered that a direct current through the nanotube spontaneously drives the mechanical resonator, exerting a force that is coherent with the high-frequency resonant mechanical motion.

cond-mat.mes-hall

Carbon nanotubes as ultra-high quality factor mechanical resonators

We have observed the transversal vibration mode of suspended carbon nanotubes at millikelvin temperatures by measuring the single-electron tunneling current. The suspended nanotubes are actuated contact-free by the radio frequency electric field of a nearby antenna; the mechanical resonance is detected in the time-averaged current through the nanotube. Sharp, gate-tuneable resonances due to the bending mode of the nanotube are observed, combining resonance frequencies of up to ν_0 = 350 MHz with quality factors above Q = 10^5, much higher than previously reported results on suspended carbon nanotube resonators. The measured magnitude and temperature dependence of the Q-factor shows a remarkable agreement with the intrinsic damping predicted for a suspended carbon nanotube. By adjusting the RF power on the antenna, we find that the nanotube resonator can easily be driven into the non-linear regime.

cond-mat.mes-hall

Self-detecting gate-tunable nanotube paddle resonators

We have fabricated suspended metal paddle resonators with carbon nanotubes functioning as self-detecting torsional springs. We observe gate-tunable resonances, that either tune to higher or to lower frequencies when increasing the dc voltage on the back-gate. We attribute the former modes to flexural vibrations of the paddle resonator, while the latter ones are identified as torsional vibrations. Compared to top-down silicon fabricated paddle resonators, nanotube springs have smaller torsional spring constants and provide a larger frequency tunability.

cond-mat.mes-hall