arXiv subjects

M. Rubio-Roy

Publications and source records attributed to M. Rubio-Roy.

9 recordsLinked to original sources

arXiv2021

Penetration depth of Cooper pairs in the IrMn antiferromagnet

Suppression of superconductivity due to the proximity effect between a superconductor and a ferromagnet can be partially alleviated when a Cooper pair simultaneously samples different directions of the short-range exchange field. The superconductor's critical temperature, TC, is therefore expected to partially recover when the ferromagnet is in a multi-domain state, as opposed to a single-domain state. Here, we discuss series of experiments performed with ferromagnet(Pt/Co)/spacer(IrMn and Pt)/superconductor(NbN) heterostructures. By tuning the various parameters in play, e.g., superconducting coherence length-to-thicknesses ratio, and domain sizes, we obtained up to 10 percent recovery of the superconducting critical temperature ΔTC/TC. This large-scale recovery made novel investigations possible. In particular, from the spacer thickness-dependence of ΔTC/TC, it was possible to deduce the characteristic length for Cooper pair penetration in an IrMn antiferromagnet. This information is crucial for electronic transport, and up to now has been difficult to access experimentally for antiferromagnets.

cond-mat.mtrl-sci↗

arXiv2019

Beam test performance of the highly granular SiW-ECAL technological prototype for the ILC

The technological prototype of the CALICE highly granular silicon-tungsten electromagnetic calorimeter (SiW-ECAL) was tested in a beam at DESY in 2017. The setup comprised seven layers of silicon sensors. Each layer comprised four sensors, with each sensor containing an array of 256 $5.5\times5.5$ mm$^2$ silicon PIN diodes. The four sensors covered a total area of $18\times18$ cm$^2$, and comprised a total of 1024 channels. The readout was split into a trigger line and a charge signal line. Key performance results for signal over noise for the two output lines are presented, together with a study of the uniformity of the detector response. Measurements of the response to electrons for the tungsten loaded version of the detector are also presented.

physics.ins-det↗

arXiv2019

Self-induced inverse spin Hall effect in ferromagnets: demonstration through non-monotonous temperature-dependence in permalloy

We investigated the self-induced inverse spin Hall effect in ferromagnets. Temperature (T), thickness (t) and angular-dependent measurements of transverse voltage in spin pumping experiments were performed with permalloy films. Results revealed non-monotonous T-dependence of the self-induced transverse voltage. Qualitative agreement was found with first-principle calculations unravelling the skew scattering, side-jump, and intrinsic contributions to the T-dependent spin Hall conductivity. Experimental data were similar whatever the material in contact with permalloy (oxides or metals), and revealed an increase of produced current with t, demonstrating a bulk origin of the effect.

cond-mat.mes-hall↗

arXiv2019

Commissioning of the highly granular SiW-ECAL technological prototype

In this article we describe the commissioning and a first analysis of the the beam test performance of a small prototype of a highly granular silicon tungsten calorimeter. The prototype features detector elements with a channel number similar to that envisaged for e.g. the ILD Detector of the International Linear Collider (ILC). The analysis demonstrates the capability of the detector to record signals as low as 0.5 MIP. Further, no loss of performance has been observed when operating the detector in a high magnetic field.

physics.ins-det↗

arXiv2019

Spin pumping as a generic probe for linear spin fluctuations: demonstration with ferromagnetic and antiferromagnetic orders, metallic and insulating electrical states

We investigated spin injection by spin pumping from a spin-injector(NiFe) into a spin-sink to detect spin fluctuations in the spin-sink. By scanning the ordering-temperature of several magnetic transitions, we found that enhanced spin pumping due to spin fluctuations applies with several ordering states: ferromagnetic(Tb) and antiferromagnetic(NiO, NiFeOx, BiFeO3, exchange-biased and unbiased IrMn). Results also represent systematic experimental investigation supporting that the effect is independent of the metallic and insulating nature of the spin-sink, and is observed whether the spin current probe involves electronic or magnonic transport, facilitating advances in material characterization and engineering for spintronic applications.

cond-mat.mtrl-sci↗

arXiv2018

Unraveling the influence of electronic and magnonic spin current injection near the magnetic ordering transition of IrMn metallic antiferromagnets

Although spin injection at room temperature in an IrMn metallic antiferromagnet strongly depends on the transport regime, and is more efficient in the case of magnonic transport, in this article, we present experimental data demonstrating that the enhanced efficiency of spin injection caused by spin fluctuations near the ordering temperature can be as efficient for the electronic and magnonic transport regimes. By selecting representative interacting environments, we also demonstrated that the amplification of spin injection near the ordering temperature of the IrMn antiferromagnet is independent of exchange coupling with an adjacent NiFe ferromagnet. In addition, our findings confirm that the spin current carried by magnons penetrates deeper than that transported by conduction electrons in IrMn. Finally, our data indicates that the value of the ordering temperature for the IrMn antiferromagnet is not significantly affected by either the electronic or magnonic nature of the spin current probe, or by exchange coupling.

cond-mat.mtrl-sci↗

arXiv2018

Hadronic Energy Resolution of a Combined High Granularity Scintillator Calorimeter System

This paper presents results obtained with the combined CALICE Scintillator Electromagnetic Calorimeter, Analogue Hadronic Calorimeter and Tail Catcher & Muon Tracker, three high granularity scintillator-SiPM calorimeter prototypes. The response of the system to pions with momenta between 4 GeV/c and 32 GeV/c is analysed, including the energy response, resolution, and longitudinal shower profiles. The results of a software compensation technique based on weighting according to hit energy are compared to those of a standard linear energy reconstruction. The results are compared to predictions of the GEANT4 physics lists QGSP_BERT_HP and FTFP_BERT_HP.

physics.ins-det↗

arXiv2017

SiW ECAL for future $e^+e^-$ collider

Calorimeters with silicon detectors have many unique features and are proposed for several world-leading experiments. We discuss the tests of the first three 18x18 cm$^2$ layers segmented into 1024 pixels of the technological prototype of the silicon-tungsten electromagnetic calorimeter for a future $e^+e^-$ collider. The tests have beem performed in November 2015 at CERN SPS beam line.

physics.ins-det↗

arXiv2010

Directed self-organization of graphene nanoribbons on SiC

Realization of post-CMOS graphene electronics requires production of semiconducting graphene, which has been a labor-intensive process. We present tailoring of silicon carbide crystals via conventional photolithography and microelectronics processing to enable templated graphene growth on 4H-SiC{1-10n} (n = 8) crystal facets rather than the customary {0001} planes. This allows self-organized growth of graphene nanoribbons with dimensions defined by those of the facet. Preferential growth is confirmed by Raman spectroscopy and high-resolution transmission electron microscopy (HRTEM) measurements, and electrical characterization of prototypic graphene devices is presented. Fabrication of > 10,000 top-gated graphene transistors on a 0.24 cm2 SiC chip demonstrates scalability of this process and represents the highest density of graphene devices reported to date.

cond-mat.mtrl-sci↗