Searcharxiv⌕ Search

arXiv subjects

M. Vansteenkiste

Publications and source records attributed to M. Vansteenkiste.

3 recordsLinked to original sources

Evaluation of Performance of the p-stop fabrication process variations in ATLAS18 strip sensors, Pre- and Post-Irradiation

The High-Luminosity upgrade of the Large Hadron Collider (HL-LHC) requires the replacement of the ATLAS Inner Detector with a new all-silicon Inner Tracker (ITk). Radiation-hard n-in-p micro-strip sensors were developed for use in the ITk. During quality control (QC) and quality assurance (QA) procedures performed on ATLAS18 production sensors and test chips, ATLAS ITk strip sensor institutes identified instances of low p-stop density in certain production batches. To investigate the origin of these issues and to try some technological improvements, two dedicated sample batches with four variations of the p-stop fabrication process were produced. These process types (1-4) were systematically evaluated to determine their effectiveness and uniformity. In total, 56 full-size sensors, along with numerous miniature sensors and test chips, were tested. A number of samples were used in the irradiation campaign reaching the maximum expected levels for the HL-LHC operation after 10 years - with neutrons up to 1.6E15 neq/cm2, and with gamma rays from a 60Co source up to 66 Mrad. The goal of this evaluation program is to assess the impact of of p-stop fabrication process variations on interstrip isolation performance and to provide feedback for future sensor development. This paper describes the applied test procedures and presents the corresponding results, which demonstrate good sensor performance for all investigated p-stop types. The findings confirm the reliability of the evaluated designs and identify specific advantages that can inform further optimization of strip sensor fabrication.

physics.ins-det↗

Convergence on the Proton Drip-Line in Thulium

Direct observation of proton emission for very small Q-values is often unfeasible due to the long partial half-lives of the proton emission channel associated with tunneling through the Coulomb barrier. Therefore, proton emitters with very small decay energies may require the masses of both parent and daughter nuclei in order to establish them as proton unbound. Nuclear mass models have been used to predict the proton drip-line of the thulium (Tm) isotopic chain ($Z=69$), but until now the proton separation energy has not been experimentally tested. Mass measurements were performed using a Multiple Reflection Time-Of-Flight Mass Spectrometer (MR-TOF-MS) at TRIUMF's TITAN facility to conclusively map the limit of proton-bound Tm. The masses of neutron-deficient, $^{149}$Tm and $^{150}$Tm, combined with measurements of $^{149m,g}$Er (which were found to deviate from literature by $\approx$150 keV), provide the first experimental confirmation that $^{149}$Tm is the first proton-unbound nuclide in the Tm chain. Our measurements also enable the strength of the $N=82$ neutron shell gap to be determined at the Tm proton drip-line, providing evidence supporting its continued existence.

nucl-ex↗

Exploring the Onset of Collectivity Approaching N=40 through Manganese Masses

Isotopes in the region of the nuclear chart below $^{68}\mathrm{Ni}$ have been the subject of intense experimental and theoretical effort due to the potential onset of a new ``island of inversion'' when crossing the harmonic oscillator subshell closure at $N = 40$. We have measured the masses of $^{64-68}\textrm{Mn}$ using TITAN's multiple-reflection time-of-flight mass spectrometer, resulting in the first precision mass measurements of $^{67}\mathrm{Mn}$ and $^{68}\mathrm{Mn}$. These results are compared to \textit{ab initio} calculations and modern shell model calculations and show an increase in collectivity approaching $N=40$.

nucl-ex↗