SearcharxivSearch

arXiv subjects

M. Z. Wang

Publications and source records attributed to M. Z. Wang.

9 recordsLinked to original sources

$^{197}$Au($γ,\,xn;\,x\,=\,1\thicksim9$) Reaction Cross Section Measurements using Laser-Driven Ultra-Intense $γ$-Ray Source

We present a new method for the measurements of photonuclear reaction flux-weighted average cross sections and isomeric ratios using a laser-driven bremsstrahlung $γ$-ray source. An ultra-bright ultra-fast 60$\,\thicksim\,$250 MeV bremsstrahlung $γ$-ray source was established using the 200 TW laser facility in the Compact Laser Plasma Accelerator Laboratory, Peking University, which could cover the energy range from knocking out neutrons to producing pions. Stable quasi-monoenergetic electron beams were generated via laser wakefield acceleration with a charge of 300$\,\thicksim\,$600 pC per shot. The averaged $γ$-ray intensities ($\geqslant$8 MeV) were higher than 10$^{8}$ per shot and the instantaneous intensities can reach above 10$^{19}$ s$^{-1}$ with a duration time about 6.7 ps. $^{65}$Cu($γ,\,n$)$^{64}$Cu and $^{27}$Al($γ,\,x$)$^{24}$Na reactions were used as $γ$-ray flux monitors in the experiments. The flux-weighted average cross sections and isomeric ratios of $^{197}$Au($γ,\,xn;\,x\,=\,1\thicksim9$) reactions were analyzed through activation measurements. The results showed good agreement with previous works and proved this method to be accurate. The $^{197}$Au($γ,\,xn;\,x\,=\,7\thicksim\,9$) reaction cross sections were first achieved with the highest threshold energy of 71.410 MeV. Theoretical cross sections of TALYS 1.9 were calculated to compare with experiment results. This method offered a unique way of gaining insight into photonuclear reaction research, especially for short-lived isomers which extremely lack experimental data.

nucl-ex

Calibration and Physics with ARA Station 1: A Unique Askaryan Radio Array Detector

The Askaryan Radio Array Station 1 (A1), the first among five autonomous stations deployed for the ARA experiment at the South Pole, is a unique ultra-high energy neutrino (UHEN) detector based on the Askaryan effect that uses Antarctic ice as the detector medium. Its 16 radio antennas (distributed across 4 strings, each with 2 Vertically Polarized (VPol), 2 Horizontally Polarized (HPol) receivers), and 2 strings of transmitting antennas (calibration pulsers, CPs), each with 1 VPol and 1 HPol channel, are deployed at depths less than 100 m within the shallow firn zone of the 2.8 km thick South Pole (SP) ice. We apply different methods to calibrate its Ice Ray Sampler second generation (IRS2) chip for timing offset and ADC-to-Voltage conversion factors using a known continuous wave input signal to the digitizer, and achieve a precision of sub-nanoseconds. We achieve better calibration for odd, compared to even samples, and also find that the HPols under-perform relative to the VPol channels. Our timing calibrated data is subsequently used to calibrate the ADC-to-Voltage conversion as well as precise antenna locations, as a precursor to vertex reconstruction. The calibrated data will then be analyzed for UHEN signals in the final step of data compression. The ability of A1 to scan the firn region of SP ice sheet will contribute greatly towards a 5-station analysis and will inform the design of the planned IceCube Gen-2 radio array.

astro-ph.IM

Long-baseline horizontal radio-frequency transmission through polar ice

We report on analysis of englacial radio-frequency (RF) pulser data received over horizontal baselines of 1--5 km, based on broadcasts from two sets of transmitters deployed to depths of up to 1500 meters at the South Pole. First, we analyze data collected usingtwo RF bicone transmitters 1400 meters below the ice surface, and frozen into boreholes drilled for the IceCube experiment in 2011. Additionally, in Dec., 2018, a fat-dipole antenna, fed by one of three high-voltage (~1 kV), fast (~(1-5 ns)) signal generators was lowered into the 1700-m deep icehole drilled for the South Pole Ice Core Experiment (SPICE), approximately 3 km from the geographic South Pole. Signals from transmitters were recorded on the five englacial multi-receiver ARA stations, with receiver depths between 60--200 m. We confirm the long, >1 km RF electric field attenuation length, test our observed signal arrival timing distributions against models, and measure birefringent asymmetries at the 0.15% level.

astro-ph.IM

First Measurements of Beam Backgrounds at SuperKEKB

The high design luminosity of the SuperKEKB electron-positron collider is expected to result in challenging levels of beam-induced backgrounds in the interaction region. Properly simulating and mitigating these backgrounds is critical to the success of the Belle~II experiment. We report on measurements performed with a suite of dedicated beam background detectors, collectively known as BEAST II, during the so-called Phase 1 commissioning run of SuperKEKB in 2016, which involved operation of both the high energy ring (HER) of 7 GeV electrons as well as the low energy ring (LER) of 4 GeV positrons. We describe the BEAST II detector systems, the simulation of beam backgrounds, and the measurements performed. The measurements include standard ones of dose rates versus accelerator conditions, and more novel investigations, such as bunch-by-bunch measurements of injection backgrounds and measurements sensitive to the energy spectrum and angular distribution of fast neutrons. We observe beam-gas, Touschek, beam-dust, and injection backgrounds. We do not observe significant synchrotron radiation, as expected. Measured LER beam-gas backgrounds and Touschek backgrounds in both rings are slightly elevated, on average three times larger than the levels predicted by simulation. HER beam-gas backgrounds are on on average two orders of magnitude larger than predicted. Systematic uncertainties and channel-to-channel variations are large, so that these excesses constitute only 1-2 sigma level effects. Neutron background rates are higher than predicted and should be studied further. We will measure the remaining beam background processes, due to colliding beams, in the imminent commissioning Phase 2. These backgrounds are expected to be the most critical for Belle II, to the point of necessitating replacement of detector components during the Phase 3 (full-luminosity) operation of SuperKEB.

physics.ins-det

Calibration and Irradiation Study of the BGO Background Monitor for the BEAST II Experiment

Beam commissioning of the SuperKEKB collider began in 2016. The Beam Exorcism for A STable experiment II (BEAST II) project is particularly designed to measure the beam backgrounds around the interaction point of the SuperKEKB collider for the Belle II experiment. We develop a system using bismuth germanium oxide (BGO) crystals with optical fibers connecting to a multianode photomultiplier tube (MAPMT) and a field-programmable gate array (FPGA) embedded readout board for monitoring the real-time beam backgrounds in BEAST II. The overall radiation sensitivity of this system is estimated to be $(2.20\pm0.26)\times10^{-12}$ Gy/ADU (analog-to-digital unit) with the standard 10 m fibers for transmission and the MAPMT operating at 700 V. Our $γ$-ray irradiation study of the BGO system shows that the exposure of BGO crystals to $^{60}$Co $γ$-ray doses of 1 krad has led to immediate light output reductions of 25--40%, and the light outputs further drop by 30--45% after the crystals receive doses of 2--4 krad. Our findings agree with those of the previous studies on the radiation hard (RH) BGO crystals grown by the low thermal gradient Czochralski (LTG Cz) technology. The absolute dose from the BGO system is also consistent with the simulation, and is estimated to be about 1.18 times the equivalent dose. These results prove that the BGO system is able to monitor the background dose rate in real time under extreme high radiation conditions. This study concludes that the BGO system is reliable for the beam background study in BEAST II.

physics.ins-det

The Physics of the B Factories

This work is on the Physics of the B Factories. Part A of this book contains a brief description of the SLAC and KEK B Factories as well as their detectors, BaBar and Belle, and data taking related issues. Part B discusses tools and methods used by the experiments in order to obtain results. The results themselves can be found in Part C. Please note that version 3 on the archive is the auxiliary version of the Physics of the B Factories book. This uses the notation alpha, beta, gamma for the angles of the Unitarity Triangle. The nominal version uses the notation phi_1, phi_2 and phi_3. Please cite this work as Eur. Phys. J. C74 (2014) 3026.

hep-ex

Baryonic B Meson Decays

Recent results on baryonic B decays from the two b-factories, BABAR and Belle, are presented. These include studies of B+ to p pbar pi+, B+ to p Lambdabar gamma and B0 to p Lambdabar pi-; observations of B+ to p Lambdabar pi0, B to Lambda_c+ Lambda_c- K, and B+ to Xibar0_c Lambda_c+; and study of the inclusive B decays to Lambda_c.

hep-ex

Measurement of Baryonic B Decays

Recent results of baryonic B decays from Belle are reported. This study is done by a 78 fb$^{-1}$ data sample, consisting of $85.0 \pm 0.5$ million $B\bar{B}$ pairs, collected by the Belle detector at the KEKB asymmetric energy $e^+e^-$ (3.5 on 8 GeV) collider. The results reported here include the first observation of the two-body decay $B^0 \to p\barΛ_c$, the first hyperonic decay $B^0 \to p\barΛπ^-$, and first observations of $B^+ \to p\bar{p}π^+$, $B^0 \to p\bar{p}K_S^0$, and $B^+ \to p\bar{p}K^{\star +}$.

hep-ex

Nuclear Recoil Measurement in CsI(Tl) Crystal for Cold Dark Matter Detection

There are recent interests with CsI(Tl) scintillating crystals for Dark Matter experiments. The scattering signatures by neutrons on a CsI(Tl) detector were studied using a neutron beam generated by a 13 MV Tandem accelerator. The energy spectra of nuclear recoils from 7 keV to 132 keV were measured, and their quenching factors for scintillating light yield were derived. The data represents the first confirmation of the Optical Model predictions on neutron elastic scatterings with a direct measurement on the nuclear recoils of heavy nuclei. The pulse shape discrimination techniques to differentiate nuclear recoils from $γ$-background were studied. Internal consistencies were obtained among the different methods of light yield measurements. The projected capabilities for Cold Dark Matter searches with CsI(Tl) crystals are presented.

nucl-ex