arXiv subjects

Mahdi Chegnizadeh

Publications and source records attributed to Mahdi Chegnizadeh.

7 recordsLinked to original sources

arXiv2026

Thermalization of neighboring nanomechanical resonators below 1 mK

The position noise spectra of six drums on a single chip were measured on a single cooldown below 1.3 kelvin. Cryostat temperatures as low as 0.7 mK were achieved. The temperature dependence of the resonance frequency and linewidth of the drum modes was analyzed in the framework of the tunneling two level system (TLS) model. Departures of the resonance frequency and the position noise power from the expected logarithmic and linear temperature dependences, respectively, were interpreted as indications of thermal decoupling from the cryostat. This previously unexplored measurement configuration revealed that similar neighboring drums on a single chip may be at different temperatures. At the lowest temperatures, some drums exhibited excess damping that decreased with temperature. The magnitude of the excess damping of the drums was correlated with the thermal coupling of their TLS to the cryostat. In the case of one drum, a temporary increase in its damping coincided with a decrease in its mode temperature. The thermalization of the TLS to the cold finger was independent of pump power, pulse tube state and temperature of the pre-cooling stages of the cryostat. These results reveal an interplay between TLS damping and thermalization of nanomechanics that motivates further theoretical work and may impact efforts to extend the coherence of mechanical resonators.

cond-mat.mes-hall↗

arXiv2025

Compact superconducting vacuum-gap capacitors with low microwave loss and high mechanical coherence for scalable quantum circuits

Vacuum-gap capacitors have recently attracted significant interest in superconducting circuit platforms due to their compact design and exceptionally low dielectric losses in the microwave regime. Their intrinsic ability to support mechanical vibrational modes makes them well-suited for circuit optomechanics. However, precise control over the gap size and the realization of high-coherence mechanical modes remain longstanding challenges. Here, we present a detailed and scalable fabrication process for vacuum-gap capacitors that support ultra-high-coherence mechanical motion, exhibit low microwave loss, and occupy a significantly smaller footprint compared to conventional planar geometries. By employing a planarized $\mathrm{SiO}_2$ sacrificial layer, we achieve vacuum gaps on the order of 150 nm. Using this platform, we have recently demonstrated ground-state cooling and motion squeezing of a mechanical oscillator with a quality factor of 40 million, a 100-fold improvement compared to prior works, as well as a single-photon optomechanical coupling rate of approximately 15Hz. Additional achievements include the realization of an optomechanical topological lattice with 24 sites and the observation of quantum collective dynamics in a mechanical hexamer. Collectively, these results underscore the potential of vacuum-gap capacitors as a platform for coupling superconducting qubits to mechanical systems, enabling quantum storage, and probing gravitational effects in quantum mechanics.

quant-ph↗

arXiv2024

Quantum collective motion of macroscopic mechanical oscillators

Collective phenomena arise from interactions within complex systems, leading to behaviors absent in individual components. Observing quantum collective phenomena with macroscopic mechanical oscillators has been impeded by the stringent requirement that oscillators be identical. Here, we demonstrate the quantum regime for collective motion of $N=6$ mechanical oscillators, a hexamer, in a superconducting circuit optomechanical platform. By increasing the optomechanical couplings, the system transitions from individual to collective motion, characterized by a $\sqrt{N}$ enhancement of cavity-collective mode coupling, akin to super-radiance of atomic ensembles. Using sideband cooling, we prepare the collective mode in the quantum ground state and measure its quantum sideband asymmetry, with zero-point motion distributed across distant oscillators. This regime of optomechanics opens avenues for studying multi-partite entanglement, with potential advances in quantum metrology.

quant-ph↗

arXiv2023

Mechanically Induced Correlated Errors on Superconducting Qubits with Relaxation Times Exceeding 0.4 Milliseconds

Superconducting qubits are one of the most advanced candidates to realize scalable and fault-tolerant quantum computing. Despite recent significant advancements in the qubit lifetimes, the origin of the loss mechanism for state-of-the-art qubits is still subject to investigation. Moreover, successful implementation of quantum error correction requires negligible correlated errors among qubits. Here, we realize ultra-coherent superconducting transmon qubits based on niobium capacitor electrodes, with lifetimes exceeding 0.4 ms. By employing a nearly quantum-limited readout chain based on a Josephson traveling wave parametric amplifier, we are able to simultaneously record bit-flip errors occurring in a multiple-qubit device, revealing that the bit-flip errors in two highly coherent qubits are strongly correlated. By introducing a novel time-resolved analysis synchronized with the operation of the pulse tube cooler in a dilution refrigerator, we find that a pulse tube mechanical shock causes nonequilibrium dynamics of the qubits, leading to correlated bit-flip errors as well as transitions outside of the computational state space. Our observations confirm that coherence improvements are still attainable in transmon qubits based on the superconducting material that has been commonly used in the field. In addition, our findings are consistent with qubit dynamics induced by two-level systems and quasiparticles, deepening our understanding of the qubit error mechanisms. Finally, these results inform possible new error-mitigation strategies by decoupling superconducting qubits from their mechanical environments.

quant-ph↗

arXiv2023

A squeezed mechanical oscillator with milli-second quantum decoherence

An enduring challenge in constructing mechanical oscillator-based hybrid quantum systems is to ensure engineered coupling to an auxiliary degree of freedom while maintaining good mechanical isolation from the environment, that is, low quantum decoherence, consisting of thermal decoherence and dephasing. Here, we overcome this challenge by introducing a superconducting circuit optomechanical platform which exhibits a low quantum decoherence while having a large optomechanical coupling, which allows us to prepare the quantum ground and squeezed states of motion with high fidelity. We directly measure a thermal decoherence rate of 20.5 Hz (corresponding to T_1 = 7.7 ms) as well as a pure dephasing rate of 0.09 Hz, resulted in a 100-fold improvement of quantum-state lifetime compared to the prior optomechanical systems. This enables us to reach to 0.07 quanta motional ground state occupation (93% fidelity) and realize mechanical squeezing of -2.7 dB below zero-point-fluctuation. Furthermore, we observe the free evolution of mechanical squeezed state, preserving its non-classical nature over milli-second timescales. Such ultra-low quantum decoherence not only increases the fidelity of quantum control and measurement of macroscopic mechanical systems, but may also benefit interfacing with qubits, and places the system in a parameter regime suitable for tests of quantum gravity. (Keywords: Quantum optomechanics, Superconducting circuit electromechanics, Quantum squeezing, Quantum memory, Quantum coherence)

quant-ph↗

arXiv2022

Topological lattices realized in superconducting circuit optomechanics

Cavity optomechanics enables controlling mechanical motion via radiation pressure interaction, and has contributed to the quantum control of engineered mechanical systems ranging from kg scale LIGO mirrors to nano-mechanical systems, enabling ground-state preparation, entanglement, squeezing of mechanical objects, position measurements at the standard quantum limit and quantum transduction. Yet, nearly all prior schemes have employed single- or few-mode optomechanical systems. In contrast, novel dynamics and applications are expected when utilizing optomechanical lattices, which enable to synthesize non-trivial band structures, and have been actively studied in the field of circuit QED. Superconducting microwave optomechanical circuits are a promising platform to implement such lattices, but have been compounded by strict scaling limitations. Here, we overcome this challenge and demonstrate topological microwave modes in 1D circuit optomechanical chains realizing the Su-Schrieffer-Heeger (SSH) model. Furthermore, we realize the strained graphene model in a 2D optomechanical honeycomb lattice. Exploiting the embedded optomechanical interaction, we show that it is possible to directly measure the mode functions of the hybridized modes without using any local probe. This enables us to reconstruct the full underlying lattice Hamiltonian and directly measure the existing residual disorder. Such optomechanical lattices, accompanied by the measurement techniques introduced, offers an avenue to explore collective, quantum many-body, and quench dynamics, topological properties and more broadly, emergent nonlinear dynamics in complex optomechanical systems with a large number of degrees of freedoms. (Keywords: Quantum Optomechanics, Superconducting Circuit Electromecahnics)

quant-ph↗

arXiv2019

Non-reciprocity using quadrature-phase time-varying slab resonators

In this paper, it is shown that non-reciprocity can be observed in time-varying media without employing spatio-temporal modulated permittivities. We show that by using only two one dimensional Fabry-Perot slabs with time-periodic permittivities having quadrature phase difference, it is possible to achieve considerable non-reciprocity in transmission at the incidence frequency. To analyze such scenario,generalized transfer matrices are introduced to find the wave amplitudes of all harmonics in all space. The results are verified by in-house FDTD simulations. Moreover, in order to have a simple model of such time-varying slab resonators, a time-perturbed coupled mode theory is developed for multiple resonances, and it is shown that the results obtained by this method and the analytical method are in excellent agreement.

physics.optics↗