arXiv subjects

Mahmoud Abdelaziz

Publications and source records attributed to Mahmoud Abdelaziz.

8 recordsLinked to original sources

arXiv2020

Digital Predistortion for Multiuser Hybrid MIMO at mmWaves

Efficient mitigation of power amplifier (PA) nonlinear distortion in multi-user hybrid precoding based broadband mmWave systems is an open research problem. In this article, we first carry out detailed signal and distortion modeling in broadband multi-user hybrid MIMO systems, with a bank of nonlinear PAs in each subarray, while also take the inevitable crosstalk between the antenna/PA branches into account. Building on the derived models, we then propose an efficient closed-loop (CL) digital predistortion (DPD) solution that requires only a single-input DPD unit per transmit chain or subarray, despite crosstalk, providing substantial complexity-benefit compared to the state-of-the art multi-dimensional DPD solutions. We show that under spatially correlated multipath propagation, each DPD unit can provide linearization towards every intended user, or more generally, towards all spatial directions where coherent propagation is taking place, and that the proposed CL DPD system is robust against crosstalk}. Extensive numerical results building on practical measurement-based mmWave PA models are provided, demonstrating and verifying the excellent linearization performance of the proposed DPD system in different evaluation scenarios.

eess.SP↗

arXiv2020

Piecewise Digital Predistortion fo mmWave Active Antenna Arrays: Algorithms and Measurements

In this paper, we describe a novel framework for digital predistortion (DPD) based linearization of strongly nonlinear millimeter-wave active antenna arrays. Specifically, we formulate a piecewise (PW) closed-loop (CL) DPD solution and low-complexity gradient-adaptive parameter learning algorithms, together with a region partitioning method, that can efficiently handle deep compression of the PA units. The impact of beamsteering on the DPD performance is studied, showing strong beam-dependence, thus necessitating frequent updating of the DPD. In order to facilitate fast adaptation, an inexpensive, non-iterative, pruning algorithm is introduced, which allows to significantly reduce the amount of model coefficients. The proposed methods are validated with extensive over-the-air RF measurements on a 64-element active antenna array transmitter operating at 28 GHz carrier frequency and transmitting a 400 MHz 5G New Radio (NR) standard-compliant orthogonal frequency division multiplexing waveform. The obtained results demonstrate the excellent linearization capabilities of the proposed solution, conforming to the new 5G NR requirements for frequency range 2 (FR2) in terms of both inband waveform quality and out-of-band emissions. The proposed PW-CL DPD is shown to outperform the state-of-the-art PW DPD based on the indirect learning architecture, as well as the classical single-polynomial based DPD solutions in terms of linearization performance and computational complexity by a clear margin.

eess.SP↗

arXiv2019

Linearizing Active Antenna Arrays: Method and Measurements

In this paper, we provide a novel framework for efficient digital predistortion (DPD) based linearization of active antenna arrays with multiple and mutually different nonlinear power amplifiers. The proposed method builds on the use of a combined feedback signal essentially characterizing the observable nonlinear distortion at the receiving end. The proposed method is validated with extensive over-the-air RF measurements on a 64-element active antenna array transmitter operating at 28 GHz carrier frequency and transmitting a 200 MHz wide 5G New Radio (NR) waveform. The obtained results demonstrate the excellent linearization capabilities of the proposed solution, which allows for a very efficient implementation in practical systems.

eess.SP↗

arXiv2018

Digital Predistortion in Large-Array Digital Beamforming Transmitters

In this article, we propose a novel digital predistortion (DPD) solution that allows to considerably reduce the complexity resulting from linearizing a set of power amplifiers (PAs) in single-user large-scale digital beamforming transmitters. In contrast to current state-of-the art solutions that assume a dedicated DPD per power amplifier, which is unfeasible in the context of large antenna arrays, the proposed solution only requires a single DPD in order to linearize an arbitrary number of power amplifiers. To this end, the proposed DPD predistorts the signal at the input of the digital precoder based on minimizing the nonlinear distortion of the combined signal at the intended receiver direction. This is a desirable feature, since the resulting emissions in other directions get partially diluted due to less coherent superposition. With this approach, only a single DPD is required, yielding great complexity and energy savings.

eess.SP↗

arXiv2018

Digital Predistortion for Hybrid MIMO Transmitters

This article investigates digital predistortion (DPD) linearization of hybrid beamforming large-scale antenna transmitters. We propose a novel DPD processing and learning technique for an antenna sub-array, which utilizes a combined signal of the individual power amplifier (PA) outputs in conjunction with a decorrelation-based learning rule. In effect, the proposed approach results in minimizing the nonlinear distortions in the direction of the intended receiver. This feature is highly desirable, since emissions in other directions are naturally weak due to beamforming. The proposed parameter learning technique requires only a single observation receiver, and therefore supports simple hardware implementation. It is also shown to clearly outperform the current state-of-the-art technique which utilizes only a single PA for learning. Analysis of the feedback network amplitude and phase imbalances reveals that the technique is robust even to high levels of such imbalances. Finally, we also show that the array system out-of-band emissions are well-behaving in all spatial directions, and essentially below those of the corresponding single-antenna transmitter, due to the combined effects of the DPD and beamforming.

eess.SP↗

arXiv2017

Adaptive Nonlinear RF Cancellation for Improved Isolation in Simultaneous Transmit-Receive Systems

This paper proposes an active radio frequency (RF) cancellation solution to suppress the transmitter (TX) passband leakage signal in radio transceivers supporting simultaneous transmission and reception. The proposed technique is based on creating an opposite-phase baseband equivalent replica of the TX leakage signal in the transceiver digital front-end through adaptive nonlinear filtering of the known transmit data, to facilitate highly accurate cancellation under a nonlinear TX power amplifier (PA). The active RF cancellation is then accomplished by employing an auxiliary transmitter chain, to generate the actual RF cancellation signal, and combining it with the received signal at the receiver (RX) low noise amplifier (LNA) input. A closed-loop parameter learning approach, based on the decorrelation principle, is also developed to efficiently estimate the coefficients of the nonlinear cancellation filter in the presence of a nonlinear TX PA with memory, finite passive isolation, and a nonlinear RX LNA. The performance of the proposed cancellation technique is evaluated through comprehensive RF measurements adopting commercial LTE-Advanced transceiver hardware components. The results show that the proposed technique can provide an additional suppression of up to 54 dB for the TX passband leakage signal at the RX LNA input, even at considerably high transmit power levels and with wide transmission bandwidths. Such novel cancellation solution can therefore substantially improve the TX-RX isolation, hence reducing the requirements on passive isolation and RF component linearity, as well as increasing the efficiency and flexibility of the RF spectrum use in the emerging 5G radio networks.

eess.SP↗

arXiv2016

Parallel Digital Predistortion Design on Mobile GPU and Embedded Multicore CPU for Mobile Transmitters

Digital predistortion (DPD) is a widely adopted baseband processing technique in current radio transmitters. While DPD can effectively suppress unwanted spurious spectrum emissions stemming from imperfections of analog RF and baseband electronics, it also introduces extra processing complexity and poses challenges on efficient and flexible implementations, especially for mobile cellular transmitters, considering their limited computing power compared to basestations. In this paper, we present high data rate implementations of broadband DPD on modern embedded processors, such as mobile GPU and multicore CPU, by taking advantage of emerging parallel computing techniques for exploiting their computing resources. We further verify the suppression effect of DPD experimentally on real radio hardware platforms. Performance evaluation results of our DPD design demonstrate the high efficacy of modern general purpose mobile processors on accelerating DPD processing for a mobile transmitter.

cs.DC↗

arXiv2016

Low-Complexity Sub-band Digital Predistortion for Spurious Emission Suppression in Noncontiguous Spectrum Access

Noncontiguous transmission schemes combined with high power-efficiency requirements pose big challenges for radio transmitter and power amplifier (PA) design and implementation. Due to the nonlinear nature of the PA, severe unwanted emissions can occur, which can potentially interfere with neighboring channel signals or even desensitize the own receiver in frequency division duplexing (FDD) transceivers. In this article, to suppress such unwanted emissions, a low-complexity sub-band DPD solution, specifically tailored for spectrally noncontiguous transmission schemes in low-cost devices, is proposed. The proposed technique aims at mitigating only the selected spurious intermodulation distortion components at the PA output, hence allowing for substantially reduced processing complexity compared to classical linearization solutions. Furthermore, novel decorrelation based parameter learning solutions are also proposed and formulated, which offer reduced computing complexity in parameter estimation as well as the ability to track time-varying features adaptively. Comprehensive simulation and RF measurement results are provided, using a commercial LTE-Advanced mobile PA, to evaluate and validate the effectiveness of the proposed solution in real world scenarios. The obtained results demonstrate that highly efficient spurious component suppression can be obtained using the proposed solutions.

cs.IT↗