arXiv subjects

Marcel Tencé

Publications and source records attributed to Marcel Tencé.

11 recordsLinked to original sources

arXiv2023

Excitation's lifetime extracted from electron-photon (EELS-CL) nanosecond-scale temporal coincidences

Electron-photon temporal correlations in electron energy loss (EELS) and cathodoluminescence (CL) spectroscopies have recently been used to measure the relative quantum efficiency of materials. This combined spectroscopy, named Cathodoluminescence excitation spectroscopy (CLE), allows the identification of excitation and decay channels which are hidden in average measurements. Here, we demonstrate that CLE can also be used to measure excitation's decay time. In addition, the decay time as a function of the excitation energy is accessed, as the energy for each electron-photon pair is probed. We used two well-known insulating materials to characterize this technique, nanodiamonds with \textit{NV$^0$} defect emission and h-BN with a \textit{4.1 eV} defect emission. Both also exhibit marked transition radiations, whose extremely short decay times can be used to characterize the instrumental response function. It is found to be typically 2 ns, in agreement with the expected limit of the EELS detector temporal resolution. The measured lifetimes of \textit{NV$^0$} centers in diamond nanoparticles (20 to 40 ns) and \textit{4.1 eV} defect in h-BN flakes ($<$ 2 ns) matches those reported for those materials previously.

cond-mat.mtrl-sci↗

arXiv2023

Time calibration studies for the Timepix3 hybrid pixel detector in electron microscopy

Direct electron detection is currently revolutionizing many fields of electron microscopy due to its lower noise, its reduced point-spread function, and its increased quantum efficiency. More specifically to this work, Timepix3 is a hybrid-pixel direct electron detector capable of outputting temporal information of individual hits in its pixel array. Its architecture results in a data-driven detector, also called event-based, in which individual hits trigger the data off the chip for readout as fast as possible. The presence of a pixel threshold value results in an almost readout-noise-free detector while also defining the hit time of arrival and the time the signal stays over the pixel threshold. In this work, we have performed various experiments to calibrate and correct the Timepix3 temporal information, specifically in the context of electron microscopy. These include the energy calibration, and the time-walk and pixel delay corrections, reaching an average temporal resolution throughout the entire pixel matrix of $1.37 \pm 0.04$ ns. Additionally, we have also studied cosmic rays tracks to characterize the charge dynamics along the volume of the sensor layer, allowing us to estimate the limits of the detector's temporal response depending on different bias voltages, sensor thickness, and the electron beam ionization volume. We have estimated the uncertainty due to the ionization volume ranging from about 0.8 ns for 60 keV electrons to 8.8 ns for 300 keV electrons.

physics.ins-det↗

arXiv2022

$μ$eV electron spectromicroscopy using free-space light

The synergy between free electrons and light has recently been leveraged to reach an impressive degree of simultaneous spatial and spectral resolution, enabling applications in microscopy and quantum optics. However, the required combination of electron optics and light injection into the spectrally narrow modes of arbitrary specimens remains a challenge. Here, we demonstrate microelectronvolt spectral resolution in the nanoscale mapping of photonic modes with quality factors as high as 10$^4$. We rely on mode-matching of a tightly focused laser beam to whispering gallery modes to achieve a 10$^8$-fold increase in light-electron coupling efficiency. By adapting the shape and size of free-space optical beams to address specific physical questions, our approach allows us to interrogate any type of photonic structure with unprecedented spectral and spatial detail

cond-mat.mes-hall↗

arXiv2022

Cathodoluminescence excitation spectroscopy: nanoscale imaging of excitation pathways

Following the lifespan of optical excitations from their creation to decay into photons is crucial in understanding materials optical properties. Macroscopically, techniques such as the photoluminescence excitation spectroscopy provide unique information on the photophysics of materials with applications as diverse as quantum optics or photovoltaics. Materials excitation and emission pathways are affected by nanometer scale variations directly impacting devices performances. However, they cannot be directly accessed, despite techniques, such as optical spectroscopies with free electrons, having the relevant spatial, spectral or time resolution. Here, we explore optical excitation creation and decay in two representative optical devices: plasmonic nanoparticles and luminescent 2D layers. The analysis of the energy lost by an exciting electron that is coincident in time with a visible-UV photon unveils the decay pathways from excitation towards light emission. This is demonstrated for phase-locked interactions, such as in localized surface plasmons, and non-phase-locked ones, such as the light emission by individual point defects. This newly developed cathodoluminescence excitation spectroscopy images energy transfer pathways at the nanometer scale. It widens the toolset available to explore nanoscale materials.

cond-mat.mes-hall↗

arXiv2022

Event-based hyperspectral EELS: towards nanosecond temporal resolution

The acquisition of a hyperspectral image is nowadays a standard technique used in the scanning transmission electron microscope. It relates the spatial position of the electron probe to the spectral data associated with it. In the case of electron energy loss spectroscopy (EELS), frame-based hyperspectral acquisition is much slower than the achievable rastering time of the scan unit (SU), which sometimes leads to undesirable effects in the sample, such as electron irradiation damage, that goes unperceived during frame acquisition. In this work, we have developed an event-based hyperspectral EELS by using a Timepix3 application-specific integrated circuit detector with two supplementary time-to-digital (TDC) lines embedded. In such a system, electron events are characterized by their positional and temporal coordinates, but TDC events only by temporal ones. By sending reference signals from the SU to the TDC line, it is possible to reconstruct the entire spectral image with SU-limited scanning pixel dwell time and thus acquire, with no additional cost, a hyperspectral image at the same rate as that of a single channel detector, such as annular dark-field. To exemplify the possibilities behind event-based hyperspectral EELS, we have studied the decomposition of calcite (CaCO$_3$) into calcium oxide (CaO) and carbon dioxide (CO$_2$) under the electron beam irradiation.

physics.ins-det↗

arXiv2022

Unveiling the coupling of single metallic nanoparticles to whispering-gallery microcavities

Whispering-gallery mode resonators host multiple trapped narrowband circulating optical resonances that find applications in quantum electrodynamics, optomechanics, and sensing. However, the spherical symmetry and low field leakage of dielectric microspheres make it difficult to probe their high-quality optical modes using far-field radiation. Even so, local field enhancement from metallic nanoparticles (MNPs) coupled to the resonators can interface the optical far-field and the bounded cavity modes. In this work, we study the interaction between whispering-gallery modes and MNP surface plasmons with nanometric spatial resolution by using electron-beam spectroscopies in a scanning transmission electron microscope. We show that gallery modes are induced over a selective spectral range of the nanoparticle plasmons, and additionally, their polarization can be controlled by the induced dipole moment of the MNP. Our study demonstrates a viable mechanism to effectively excite high-quality-factor whispering-gallery modes and holds potential for applications in optical sensing and light manipulation.

physics.optics↗

arXiv2020

Fast reconstruction of atomic-scale STEM-EELS images from sparse sampling

This paper discusses the reconstruction of partially sampled spectrum-images to accelerate the acquisition in scanning transmission electron microscopy (STEM). The problem of image reconstruction has been widely considered in the literature for many imaging modalities, but only a few attempts handled 3D data such as spectral images acquired by STEM electron energy loss spectroscopy (EELS). Besides, among the methods proposed in the microscopy literature, some are fast but inaccurate while others provide accurate reconstruction but at the price of a high computation burden. Thus none of the proposed reconstruction methods fulfills our expectations in terms of accuracy and computation complexity. In this paper, we propose a fast and accurate reconstruction method suited for atomic-scale EELS. This method is compared to popular solutions such as beta process factor analysis (BPFA) which is used for the first time on STEM-EELS images. Experiments based on real as synthetic data will be conducted.

eess.IV↗

arXiv2019

Spatial and spectral dynamics in STEM hyperspectral imaging using random scan patterns

The evolution of the scanning modules for scanning transmission electron microscopes (STEM) has realized the possibility to generate arbitrary scan pathways, an approach currently explored to improve acquisition speed and to reduce electron dose effects. In this work, we present the implementation of a random scan operating mode in STEM achieved at the hardware level via a custom scan control module. A pre-defined pattern with fully shuffled raster order is used to sample the entire region of interest. Subsampled random sparse images can then be extracted at successive time frames, to which suitable image reconstruction techniques can be applied. With respect to the conventional raster scan mode, this method permits to limit dose accumulation effects, but also to decouple the spatial and temporal information in hyperspectral images. We provide some proofs of concept of the flexibility of the random scan operating mode, presenting examples of its applications in different spectro-microscopy contexts: atomically-resolved elemental maps with electron energy loss spectroscopy and nanoscale-cathodoluminescence spectrum images. By employing adapted post-processing tools, it is demonstrated that the method allows to precisely track and correct for sample instabilities and to follow spectral diffusion with a high spatial localization.

physics.app-ph↗

arXiv2019

Tailored nanoscale plasmon-enhanced vibrational electron spectroscopy

Vibrational optical spectroscopies can be enhanced by surface plasmons to reach molecular-sized limits of detection and characterization. The level of enhancement strongly depends on microscopic details of the sample that are generally missed by macroscopic techniques. Here we investigate phonons in h-BN by coupling them to silver-nanowire plasmons, whose energy is tuned by modifying the nanowire length. Specifically, we use electron beam milling to accurately and iteratively change the nanowire length, followed by electron energy-loss spectroscopy to reveal the plasmon-enhanced vibrational features of h-BN. This allows us to investigate otherwise hidden bulk phonons and observe strong plasmon-phonon coupling. The new milling-and-spectroscopy technique holds great potential for resolving vibrational features in material nanostructures.

cond-mat.mes-hall↗

arXiv2018

Reconstruction of partially sampled multi-band images - Application to STEM-EELS imaging

Electron microscopy has shown to be a very powerful tool to map the chemical nature of samples at various scales down to atomic resolution. However, many samples can not be analyzed with an acceptable signal-to-noise ratio because of the radiation damage induced by the electron beam. This is particularly crucial for electron energy loss spectroscopy (EELS) which acquires spectral-spatial data and requires high beam intensity. Since scanning transmission electron microscopes (STEM) are able to acquire data cubes by scanning the electron probe over the sample and recording a spectrum for each spatial position, it is possible to design the scan pattern and to sample only specific pixels. As a consequence, partial acquisition schemes are now conceivable, provided a reconstruction of the full data cube is conducted as a post-processing step. This paper proposes two reconstruction algorithms for multi-band images acquired by STEM-EELS which exploits the spectral structure and the spatial smoothness of the image. The performance of the proposed schemes is illustrated thanks to experiments conducted on a realistic phantom dataset as well as real EELS spectrum-images.

eess.IV↗

arXiv2012

Nanometer Scale Spectral Imaging of Quantum Emitters in Nanowires and Its Correlation to Their Atomically Resolved Structure

We report the spectral imaging in the UV to visible range with nanometer scale resolution of closely packed GaN/AlN quantum disks in individual nanowires using an improved custom-made cathodoluminescence system. We demonstrate the possibility to measure full spectral features of individual quantum emitters as small as 1 nm and separated from each other by only a few nanometers and the ability to correlate their optical properties to their size, measured with atomic resolution. The direct correlation between the quantum disk size and emission wavelength provides evidence of the quantum confined Stark effect leading to an emission below the bulk GaN band gap for disks thicker than 2.6 nm. With the help of simulations, we show that the internal electric field in the studied quantum disks is smaller than what is expected in the quantum well case. We show evidence of a clear dispersion of the emission wavelengths of different quantum disks of identical size but different positions along the wire. This dispersion is systematically correlated to a change of the diameter of the AlN shell coating the wire and is thus attributed to the related strain variations along the wire. The present work opens the way both to fundamental studies of quantum confinement in closely packed quantum emitters and to characterizations of optoelectronic devices presenting carrier localization on the nanometer scale.

cond-mat.mtrl-sci↗