arXiv subjects

Marco Mezzavilla

Publications and source records attributed to Marco Mezzavilla.

62 records · Page 4Linked to original sources

arXiv2016

Understanding Noise and Interference Regimes in 5G Millimeter-Wave Cellular Networks

With the severe spectrum shortage in conventional cellular bands, millimeter-wave (mmWave) frequencies have been attracting growing attention for next-generation micro- and picocellular wireless networks. A fundamental and open question is whether mmWave cellular networks are likely to be noise- or interference-limited. Identifying in which regime a network is operating is critical for the design of MAC and physical-layer procedures and to provide insights on how transmissions across cells should be coordinated to cope with interference. This work uses the latest measurement-based statistical channel models to accurately assess the Interference-to-Noise Ratio (INR) in a wide range of deployment scenarios. In addition to cell density, we also study antenna array size and antenna patterns, whose effects are critical in the mmWave regime. The channel models also account for blockage, line-of-sight and non-line-of-sight regimes as well as local scattering, that significantly affect the level of spatial isolation.

cs.NI↗

arXiv2016

Channel Dynamics and SNR Tracking in Millimeter Wave Cellular Systems

The millimeter wave (mmWave) frequencies are likely to play a significant role in fifth-generation (5G) cellular systems. A key challenge in developing systems in these bands is the potential for rapid channel dynamics: since mmWave signals are blocked by many materials, small changes in the position or orientation of the handset relative to objects in the environment can cause large swings in the channel quality. This paper addresses the issue of tracking the signal to noise ratio (SNR), which is an essential procedure for rate prediction, handover and radio link failure detection. A simple method for estimating the SNR from periodic synchronization signals is considered. The method is then evaluated using real experiments in common blockage scenarios combined with outdoor statistical models.

cs.NI↗

arXiv2016

Transport Layer Performance in 5G mmWave Cellular

The millimeter wave (mmWave) bands are likely to play a significant role in next generation cellular systems due to the possibility of very high throughput thanks to the availability of massive bandwidth and high-dimensional antennas. Especially in Non-Line-of-Sight conditions, significant variations in the received RF power can occur as a result of the scattering from nearby building and terrain surfaces. Scattering objects come and go as the user moves through the local environment. At the higher end of the mmWave band, rough surface scatter generates cluster-based small-scale fading, where signal levels can vary by more than 20 dB over just a few wavelengths. This high level of channel variability may present significant challenges for congestion control. Using our recently developed end-to-end mmWave ns3-based framework, this paper presents the first performance evaluation of TCP congestion control in next-generation mmWave networks. Importantly, the framework can incorporate detailed models of the mmWave channel, beam- forming and tracking algorithms, and builds on statistical channel models derived from real measurements in New York City, as well as detailed ray traces.

cs.IT↗

arXiv2016

Resource Sharing in 5G mmWave Cellular Networks

In this paper, we discuss resource sharing, a key dimension in mmWave network design in which spectrum, access and/or network infrastructure resources can be shared by multiple operators. It is argued that this sharing paradigm will be essential to fully exploit the tremendous amounts of bandwidth and the large number of antenna degrees of freedom available in these bands, and to provide statistical multiplexing to accommodate the highly variable nature of the traffic. In this paper, we investigate and compare various sharing configurations in order to capture the enhanced potential of mmWave communications. Our results reflect both the technical and the economical aspects of the various sharing paradigms. We deliver a number of key insights, corroborated by detailed simulations, which include an analysis of the effects of the distinctive propagation characteristics of the mmWave channel, along with a rigorous multi-antenna characterization. Key findings of this study include (i) the strong dependence of the comparative results on channel propagation and antenna characteristics, and therefore the need to accurately model them, and (ii) the desirability of a full spectrum and infrastructure sharing configuration, which may result in increased user rate as well as in economical advantages for both service provider.

cs.IT↗

arXiv2016

The Potential of Resource Sharing in 5G Millimeter-Wave Bands

With the severe spectrum shortage in conventional cellular bands, the millimeter (mmWave) frequencies, roughly above 10~GHz, have been attracting growing attention for next-generation micro- and pico- cellular wireless networks. A fundamental and open question is how these bands should be used by cellular operators. Cellular spectrum has been traditionally allocated following an exclusive ownership model. However, in this paper we argue that the distinct nature of mmWave communication -- the massive bandwidth degrees of freedom, directional isolation and high susceptibility to blockage -- suggest that spectrum and infrastructure sharing between multiple operators may be necessary to exploit the full potential of these bands. High-level capacity analyses are presented that reveal significant possible gains under spectrum and infrastructure sharing, even under minimal coordination between operators. Moreover, we discuss how network technologies including software defined networks (SDNs) and network function virtualization (NFV) can easily enable resource sharing by having a programmable core entity provide transparent inter-operator access to the end user.

cs.NI↗

arXiv2016

Achieving Ultra-Low Latency in 5G Millimeter Wave Cellular Networks

The IMT 2020 requirements of 20 Gbps peak data rate and 1 millisecond latency present significant engineering challenges for the design of 5G cellular systems. Use of the millimeter wave (mmWave) bands above 10 GHz --- where vast quantities of spectrum are available --- is a promising 5G candidate that may be able to rise to the occasion. However, while the mmWave bands can support massive peak data rates, delivering these data rates on end-to-end service while maintaining reliability and ultra-low latency performance will require rethinking all layers of the protocol stack. This papers surveys some of the challenges and possible solutions for delivering end-to-end, reliable, ultra-low latency services in mmWave cellular systems in terms of the Medium Access Control (MAC) layer, congestion control and core network architecture.

cs.NI↗

arXiv2015

5G mmWave Module for ns-3 Network Simulator

The increasing demand of data, along with the spectrum scarcity, are motivating a urgent shift towards exploiting new bands. This is the main reason behind identifying mmWaves as the key disruptive enabling technology for 5G cellular networks. Indeed, utilizing new bands means facing new challenges; in this context, they are mainly related to the radio propagation, which is shorter in range and more sensitive to obstacles. The resulting key aspects that need to be taken into account when designing mmWave cellular systems are directionality and link intermittency. The lack of network level results motivated this work, which aims at providing the first of a kind open source mmWave framework, based on the network simulator ns-3. The main focus of this work is the modeling of customizable channel, physical (PHY) and medium access control (MAC) layers for mmWave systems. The overall design and architecture of the model are discussed in details. Finally, the validity of our proposed framework is corroborated through the simulation of a simple scenario.

cs.NI↗

arXiv2015

Dynamic Time-domain Duplexing for Self-backhauled Millimeter Wave Cellular Networks

Millimeter wave (mmW) bands between 30 and 300 GHz have attracted considerable attention for next-generation cellular networks due to vast quantities of available spectrum and the possibility of very high-dimensional antenna ar-rays. However, a key issue in these systems is range: mmW signals are extremely vulnerable to shadowing and poor high-frequency propagation. Multi-hop relaying is therefore a natural technology for such systems to improve cell range and cell edge rates without the addition of wired access points. This paper studies the problem of scheduling for a simple infrastructure cellular relay system where communication between wired base stations and User Equipment follow a hierarchical tree structure through fixed relay nodes. Such a systems builds naturally on existing cellular mmW backhaul by adding mmW in the access links. A key feature of the proposed system is that TDD duplexing selections can be made on a link-by-link basis due to directional isolation from other links. We devise an efficient, greedy algorithm for centralized scheduling that maximizes network utility by jointly optimizing the duplexing schedule and resources allocation for dense, relay-enhanced OFDMA/TDD mmW networks. The proposed algorithm can dynamically adapt to loading, channel conditions and traffic demands. Significant throughput gains and improved resource utilization offered by our algorithm over the static, globally-synchronized TDD patterns are demonstrated through simulations based on empirically-derived channel models at 28 GHz.

cs.NI↗