Searcharxiv⌕ Search

arXiv subjects

Margaret Wooldridge

Publications and source records attributed to Margaret Wooldridge.

2 recordsLinked to original sources

Comparison of the flamelet progress variable and thickened flame models for LES of turbulent combustion

Large-eddy simulation (LES) of turbulent combustion requires closure models for unresolved flame structures and chemical processes. Two widely used but fundamentally different approaches are the flamelet/progress-variable approach (FPVA) and the dynamically thickened-flame model (TFM). Here, both are applied to methane-air combustion within a common numerical framework and evaluated for the Sandia D flame and a jet-in-crossflow representative of a non-assist waste-gas flare across a range of crosswind-to-jet velocity ratios. For the predominantly diffusion-controlled Sandia-D flame, FPVA and TFM exhibit similar accuracy, while FPVA is substantially less computationally expensive and converges faster under mesh refinement. More detailed chemical kinetics improve agreement with experimental measurements, with little additional cost for FPVA but a substantial increase for TFM. For the jet-in-crossflow, both approaches reproduce the experimentally observed reduction in combustion efficiency with increasing crosswind, but their predictions progressively diverge as the crosswind strength increases. This divergence coincides with the emergence of a locally premixed reaction branch captured by TFM but not represented by FPVA, whereas predictions in diffusion-dominated regions remain broadly similar. In TFM, the locally premixed branch is associated with elevated scalar dissipation and greater residual methane downstream, indicating that highly strained premixed combustion contributes to differences in predicted flare performance. These results show that FPVA and TFM can provide similar predictions in diffusion-dominated flames but differ substantially when crossflow induces locally premixed, highly strained combustion near the nozzle.

physics.flu-dyn↗

Effect of Nozzle Geometry on the Performance of Non-Assist Flares

This study employs large-eddy simulations with a flamelet progress variable approach to systematically quantify the influence of nozzle geometry on combustion efficiency, mixing, and blowout resistance in non-assist methane flares. Five canonical nozzle shapes-circle, low aspect ratio ellipse, high aspect ratio ellipse, diamond, and square-were evaluated under relevant industrial flare conditions. Results demonstrate that cornered geometries enhance near-field recirculation, promote mixing, and sustain flame attachment, resulting in up to a 5% improvement in combustion efficiency compared with streamlined nozzles. The square nozzle performed best irrespective of the wind direction (orientation) and maintained a combustion efficiency greater than 96.5% even at the highest tested crosswind velocities, while other streamlined designs exhibited early flame lift-off, reduced recirculation, and efficiency losses. Analysis of mixing and vorticity reveals that sharp-edged nozzles accelerate scalar homogenization and buffer flames against crosswind-induced strain, directly translating to increased blowout resistance.

physics.flu-dyn↗