Searcharxiv⌕ Search

arXiv subjects

Maria Loukitcheva

Publications and source records attributed to Maria Loukitcheva.

11 recordsLinked to original sources

ALMA quiet Sun observations compared with a simulated MURaM-ChE chromosphere

Aims. We assess the ability of the MURaM-ChE enhanced network simulation to reproduce the chromospheric millimeter brightness observed with ALMA and investigate the properties of the simulated emission. Methods. We analyze synthetic brightness temperatures from the MURaM-ChE model in ALMA Bands 3 (3.2 mm) and 6 (1.3 mm) and compare them with ALMA observations of quiet-Sun, network, and enhanced network regions. We examine the statistical properties of the brightness distributions, their dependence on magnetic field strength, and their variation with wavelength, using results from Bifrost enhanced network snapshots as additional reference cases. Results. The MURaM-ChE model reproduces the range and variability of brightness temperatures observed in enhanced network regions, with particularly close agreement found for the 23 April 2017 data set. The reference Bifrost snapshots produce lower brightness temperatures in both bands, with values below even those measured by ALMA in the quiet Sun. The systematic offset between the models is present in both bands and is likely associated with differences in atmospheric density stratification and the resulting effective formation heights. Both the observations and simulations show an overall increase in brightness temperature with magnetic field strength and wavelength, although significant scatter is present. Conclusions. The results indicate that the MURaM-ChE model provides a physically consistent representation of chromospheric conditions in enhanced network regions and captures key properties of the observed millimeter emission. The comparison highlights the sensitivity of millimeter brightness to atmospheric stratification and magnetic structure and demonstrates the diagnostic potential of ALMA observations for constraining chromospheric models.

astro-ph.SR↗

The energetic atmosphere of the Sun

Understanding the mechanisms that heat the Sun's chromosphere and corona to temperatures far exceeding those of the solar photosphere below remains one of the central challenges in solar physics. Small-scale, rapidly evolving processes - including shocks, turbulence, magnetohydrodynamic waves, reconnection-driven jets, and nano-flares - are thought to contribute significantly to the heating budget. However, direct observational constraints on their spatial, temporal, and spectral signatures remain hard to obtain. At millimeter wavelengths, optically thick thermal emission provides a comparatively direct measure of gas temperature. While the Atacama Large Millimeter/submillimeter Array (ALMA) already provides unique diagnostic capabilities, offering temperature diagnostics and high-cadence imaging, the current capabilities are still limiting the study of such dynamic, small-scale phenomena. Improved spatial resolution, enhanced uv-coverage, and simultaneous multi-band observations, as proposed for ALMA2040, would enable transformative progress in capturing dynamic processes across multiple heights and enable time-dependent three-dimensional thermal and magnetic tomography of the chromosphere. Combined with complementary diagnostics and simulations, these measurements would test how small-scale processes contribute to atmospheric heating.

astro-ph.IM↗

Force-Free Field Reconstructions Enhanced by Chromospheric Magnetic Field Data

3D picture of the coronal magnetic field remains an outstanding problem in solar physics, particularly, in active regions. Nonlinear force-free field reconstructions that employ routinely available full-disk photospheric vector magnetograms represent state-of-the-art coronal magnetic field modeling. Such reconstructions, however, suffer from an inconsistency between a force-free coronal magnetic field and non-force-free photospheric boundary condition, from which the coronal reconstruction is performed. In this study we focus on integrating the additional chromospheric and / or coronal magnetic field data with the vector photospheric magnetograms with the goal of improving the reliability of the magnetic field reconstructions. We develop a corresponding modification of the available optimization codes described in Fleishman et al. (2017) and test their performance using a full-fledged MHD model obtained from the Bifrost code by performing a `voxel-by-voxel' comparison between the reconstructed and the model magnetic fields. We demonstrate that adding even an incomplete set of chromospheric magnetic field data can measurably improve the reconstruction of the coronal magnetic field, greatly improve reconstructions of the magnetic connectivity and of the coronal electric current.

astro-ph.SR↗

Casting the Coronal Magnetic Field Reconstruction Tools in 3D Using MHD Bifrost Model

Quantifying coronal magnetic field remains a central problem in solar physics. Nowadays the coronal magnetic field is often modelled using nonlinear force-free field (NLFFF) reconstructions, whose accuracy has not yet been comprehensively assessed. Here we perform a detailed casting of the NLFFF reconstruction tools, such as pi-disambiguation, photospheric field preprocessing, and volume reconstruction methods using a 3D snapshot of the publicly available full-fledged radiative MHD model. Specifically, from the MHD model we know the magnetic field vector in the entire 3D domain, which enables us to perform "voxel-by-voxel" comparison of the restored and the true magnetic field in the 3D model volume. Our tests show that the available pi-disambiguation methods often fail at the quiet sun areas dominated by small-scale magnetic elements, while they work well at the AR photosphere and (even better) chromosphere. The preprocessing of the photospheric magnetic field, although does produce a more force-free boundary condition, also results in some effective `elevation' of the magnetic field components. This `elevation' height is different for the longitudinal and transverse components, which results in a systematic error in absolute heights in the reconstructed magnetic data cube. The extrapolations performed starting from actual AR photospheric magnetogram are free from this systematic error, while have other metrics comparable with those for extrapolations from the preprocessed magnetograms. This finding favors the use of extrapolations from the original photospheric magnetogram without preprocessing. Our tests further suggest that extrapolations from a force-free chromospheric boundary produce measurably better results, than those from the photospheric boundary.

astro-ph.SR↗

First solar observations with ALMA

The Atacama Large Millimeter-Submillimeter Array (ALMA) has opened a new window for studying the Sun via high-resolution high-sensitivity imaging at millimeter wavelengths. In this contribution I review the capabilities of the instrument for solar observing and describe the extensive effort taken to bring the possibility of solar observing with ALMA to the scientific community. The first solar ALMA observations were carried out during 2014 and 2015 in two ALMA bands, Band 3 (3 mm) and Band 6 (1.3 mm), in single-dish and interferometric modes, using single pointing and mosaicing observing techniques, with spatial resolution up to 2arcsec and 1arcsec in the two bands, respectively. I overview several recently published studies which made use of the first solar ALMA observations, describe current status of solar observing with ALMA and briefly discuss the future capabilities of the instrument.

astro-ph.SR↗

Solar ALMA observations: constraining the chromosphere above sunspots

We present the first high-resolution Atacama Large Millimeter/Submillimeter Array (ALMA) observations of a sunspot at wavelengths of 1.3 mm and 3 mm, obtained during the solar ALMA Science Verification campaign in 2015, and compare them with the predictions of semi-empirical sunspot umbral/penumbral atmosphere models. For the first time millimeter observations of sunspots have resolved umbral/penumbral brightness structure at the chromospheric heights, where the emission at these wavelengths is formed. We find that the sunspot umbra exhibits a radically different appearance at 1.3 mm and 3 mm, whereas the penumbral brightness structure is similar at the two wavelengths. The inner part of the umbra is ~600 K brighter than the surrounding quiet Sun (QS) at 3 mm and is ~700 K cooler than the QS at 1.3 mm, being the coolest part of sunspot at this wavelength. On average, the brightness of the penumbra at 3 mm is comparable to the QS brightness, while at 1.3 mm it is ~1000 K brighter than the QS. Penumbral brightness increases towards the outer boundary in both ALMA bands. Among the tested umbral models, that of Severino et al. (1994) provides the best fit to the observational data, including both the ALMA data analyzed in this study and data from earlier works. No penumbral model amongst those considered here gives a satisfactory fit to the currently available measurements. ALMA observations at multiple mm wavelengths can be used for testing existing sunspot models, and serve as an important input to constrain new empirical models.

astro-ph.SR↗

ALMA Discovery of Solar Umbral Brightness Enhancement at λ=3 mm

We report the discovery of a brightness enhancement in the center of a large sunspot umbra at a wavelength of 3 mm using the Atacama Large Millimeter/sub-millimeter Array (ALMA). Sunspots are amongst the most prominent features on the solar surface, but many of their aspects are surprisingly poorly understood. We analyzed a λ=3 mm (100 GHz) mosaic image obtained by ALMA, which includes a large sunspot within the active region AR12470 on December 16, 2015. The 3 mm map has a field-of-view and spatial resolution, which is the highest spatial-resolution map of an entire sunspot in this frequency range. We find a gradient of 3 mm brightness from a high value in the outer penumbra to a low value in the inner penumbra/outer umbra. Within the inner umbra, there is a marked increase in 3mm brightness temperature, which we call an umbral brightness enhancement. This enhanced emission corresponds to a temperature excess of 800 K relative to the surrounding inner penumbral region and coincides with excess brightness in the 1330 and 1400 Å slitjaw images of the Interface Region Imaging Spectrograph (IRIS), adjacent to a partial lightbridge. This λ=3 mm brightness enhancement may be an intrinsic feature of the sunspot umbra at chromospheric heights, such as a manifestation of umbral flashes, or it could be related to a coronal plume since the brightness enhancement was coincident with the footpoint of a coronal loop observed at 171 Å.

astro-ph.SR↗

Millimeter radiation from a 3D model of the solar atmosphere II. Chromospheric magnetic field

We use state-of-the-art, three-dimensional non-local thermodynamic equilibrium (non-LTE) radiative magnetohydrodynamic simulations of the quiet solar atmosphere to carry out detailed tests of chromospheric magnetic field diagnostics from free-free radiation at millimeter and submillimeter wavelengths (mm/submm). The vertical component of the magnetic field was deduced from the mm/submm brightness spectra and the degree of circular polarization synthesized at millimeter frequencies. We used the frequency bands observed by the Atacama Large Millimeter/Submillimeter Array (ALMA) as a convenient reference. The magnetic field maps obtained describe the longitudinal magnetic field at the effective formation heights of the relevant wavelengths in the solar chromosphere. The comparison of the deduced and model chromospheric magnetic fields at the spatial resolution of both the model and current observations demonstrates a good correlation, but has a tendency to underestimate the model field. The systematic discrepancy of about 10 percent is probably due to averaging of the restored field over the heights contributing to the radiation, weighted by the strength of the contribution. On the whole, the method of probing the longitudinal component of the magnetic field with free-free emission at mm/submm wavelengths is found to be applicable to measurements of the weak quiet-Sun magnetic fields. However, successful exploitation of this technique requires very accurate measurements of the polarization properties (primary beam and receiver polarization response) of the antennas, which will be the principal factor that determines the level to which chromospheric magnetic fields can be measured. Consequently, high-resolution and high-precision observations of circularly polarized radiation at millimeter wavelengths can be a powerful tool for producing chromospheric longitudinal magnetograms.

astro-ph.SR↗

Probing the Sun with ALMA: observations and simulations

ALMA will open a new chapter in the study of the Sun by providing a leap in spatial resolution and sensitivity compared to currently available mm wave- length observations. In preparation of ALMA, we have carried out a large number of observational tests and state-of-the-art radiation MHD simulations. Here we review the best available observations of the Sun at millimeter wavelengths.Using state of the art radiation MHD simulations of the solar atmosphere we demonstrate the huge potential of ALMA observations for uncovering the nature of the solar chromosphere. We show that ALMA will not only provide a reliable probe of the thermal structure and dynamics of the chromosphere, it will also open up a powerful new diagnostic of magnetic field at chromospheric heights, a fundamentally important, but so far poorly known parameter.

astro-ph.SR↗

Solar ALMA: Observation-Based Simulations of the mm and sub-mm Emissions from Active Regions

We developed an efficient algorithm integrated in our 3D modeling tool, GX Simulator (Nita et al. 2015), allowing quick computation of the synthetic intensity and polarization maps of solar active regions (AR) in the ALMA spectral range. The algorithm analyzes the photospheric input (white light and magnetogram) to classify a given photospheric pixel to belong to a given photospheric structure. Then, a 1D chromospheric model (Fontenla et al. 2009) is added on top of each pixel, which forms a chromospheric model of the AR. Next step is computation of the mm and sub-mm emission produced from this chromosphere model. A huge advantage of this approach is that emission from any given AR can be synthesized very fast, on the order of a few minutes after the AR selection. Using the GX Simulator tool it is also possible to produce synthetic maps of the microwave (gyroresonance) and EUV emission from the same AR model and compare them with the ALMA synthetic maps and with the corresponding observed microwave and/or EUV data.

astro-ph.SR↗

Millimeter radiation from a 3D model of the solar atmosphere I. Diagnosing chromospheric thermal structure

Aims. We use advanced 3D NLTE radiative magnetohydrodynamic simulations of the solar atmosphere to carry out detailed tests of chromospheric diagnostics at millimeter and submillimeter wavelengths. Methods. We focused on the diagnostics of the thermal structure of the chromosphere in the wavelength bands from 0.4 mm up to 9.6 mm that can be accessed with the Atacama Large Millimeter/Submillimeter Array (ALMA) and investigated how these diagnostics are affected by the instrumental resolution. Results. We find that the formation height range of the millimeter radiation depends on the location in the simulation domain and is related to the underlying magnetic structure. Nonetheless, the brightness temperature is a reasonable measure of the gas temperature at the effective formation height at a given location on the solar surface. There is considerable scatter in this relationship, but this is significantly reduced when very weak magnetic fields are avoided. Our results indicate that although instrumental smearing reduces the correlation between brightness and temperature, millimeter brightness can still be used to reliably diagnose electron temperature up to a resolution of 1". If the resolution is more degraded, then the value of the diagnostic diminishes rapidly. Conclusions. We conclude that millimeter brightness can image the chromospheric thermal structure at the height at which the radiation is formed. Thus multiwavelength observations with ALMA with a narrow step in wavelength should provide sufficient information for a tomographic imaging of the chromosphere.

astro-ph.SR↗