arXiv subjects

Mark Goorsky

Publications and source records attributed to Mark Goorsky.

8 recordsLinked to original sources

arXiv2025

Acoustic resonators above 100 GHz

Piezoelectric resonators are a common building block for signal processing because of their miniature size, low insertion loss, and high quality factor. As consumer electronics push to millimeter waves frequencies, designers must increase the operating frequency of the resonator. The current state-of-the-art approach to increase the operating frequency is to decrease the thickness of the piezoelectric film to shorten the acoustic wavelength or to use higher order modes. Unfortunately, maintaining high crystal quality typically requires thicker piezoelectric layers. Thinner layers suffer from higher defect densities and increased surface damping, which degrade the electromechanical coupling and quality factor. While acoustic high order modes can also increase operating frequency, the electromechanical coupling rapidly decreases with increasing mode number. Here, we overcome these limitations by utilizing a piezoelectric stack of three layers of lithium niobate with alternating crystallographic orientations to preferentially support higher order modes and thereby enhance the electromechanical coupling without degrading the quality factor. Our approach improves the figure of merit of millimeter-wave acoustic resonators by roughly an order of magnitude greater compared to state-of-the-art piezoelectric resonators above 60 GHz. This concept of alternating crystallographic orientations facilitates a new path to develop millimeter wave resonators with high figures of merit, low insertion loss, and miniature footprints, enabling new applications in millimeter wave signal processing and computing.

physics.app-ph↗

arXiv2024

Low Thermal Resistance of Diamond-AlGaN Interfaces Achieved Using Carbide Interlayers

This study investigates thermal transport across nanocrystalline diamond/AlGaN interfaces, crucial for enhancing thermal management in AlGaN/AlGaN-based devices. Chemical vapor deposition growth of diamond directly on AlGaN resulted in a disordered interface with a high thermal boundary resistance (TBR) of 20.6 m^2-K/GW. We employed sputtered carbide interlayers (e.g., $B_4C$, $SiC$, $B_4C/SiC$) to reduce thermal boundary resistance in diamond/AlGaN interfaces. The carbide interlayers resulted in record-low thermal boundary resistance values of 3.4 and 3.7 m^2-K/GW for Al$_{0.65}$Ga$_{0.35}$N samples with $B_4C$ and $SiC$ interlayers, respectively. STEM imaging of the interface reveals interlayer thicknesses between 1.7-2.5 nm, with an amorphous structure. Additionally, Fast-Fourier Transform (FFT) characterization of sections of the STEM images displayed sharp crystalline fringes in the AlGaN layer, confirming it was properly protected from damage from hydrogen plasma during the diamond growth. In order to accurately measure the thermal boundary resistance we develop a hybrid technique, combining time-domain thermoreflectance and steady-state thermoreflectance fitting, offering superior sensitivity to buried thermal resistances. Our findings underscore the efficacy of interlayer engineering in enhancing thermal transport and demonstrate the importance of innovative measurement techniques in accurately characterizing complex thermal interfaces. This study provides a foundation for future research in improving thermal properties of semiconductor devices through interface engineering and advanced measurement methodologies.

cond-mat.mtrl-sci↗

arXiv2024

Imaging Hot Photocarrier Transfer across a Semiconductor Heterojunction with Ultrafast Electron Microscopy

Semiconductor heterojunctions have gained significant attention for efficient optoelectronic devices owing to their unique interfaces and synergistic effects. Interaction between charge carriers with the heterojunction plays a crucial role in determining device performance, while its spatial-temporal mapping remains lacking. In this study, we employ scanning ultrafast electron microscopy (SUEM), an emerging technique that combines high spatial-temporal resolution and surface sensitivity, to investigate photocarrier dynamics across a Si/Ge heterojunction. Charge dynamics are selectively examined across the junction and compared to far bulk areas, through which the impact of the built-in potential, band offsets, and surface effects is directly visualized. In particular, we find that the heterojunction drastically modifies the hot photocarrier diffusivities by up to 300%. These findings are further elucidated with insights from the band structure and surface potential measured by complementary techniques. This work demonstrates the tremendous effect of heterointerfaces on charge dynamics and showcases the potential of SUEM in characterizing realistic devices.

physics.app-ph↗

arXiv2024

Unraveling the nature of quasi van der Waals Epitaxy of magnetic topological insulators Cr: (BixSb1-x)2Te3 on a GaAs (111) substrate through coherently strained interface

Quasi van der Waals Epitaxy (qvdWE) has been realized for decades at the interfaces between 3D and 2D materials or van der Waals materials. The growth of magnetic topological insulators (MTI) Cr: (BixSb1-x)2Te3 (CBST) on GaAs (111) substrates for Quantum Anomalous Hall Effect (QAH) is actually one of the examples of qvdWE, which is not well noticed despite the fact that its advantages have been used in growth of various MTI materials. This is distinguished from the growth of MTIs on other substrates. Although the qvdWE mode has been used in many 2D growth on III-V substrates, the specific features and mechanisms are not well demonstrated and summarized yet. Here in this work, we have for the first time shown the features of both coherent interfaces and the existence of strain originating from qvdWE at the same time.

cond-mat.mtrl-sci↗

arXiv2020

Simultaneous Evaluation of Heat Capacity and In-plane Thermal Conductivity of Nanocrystalline Diamond Thin Films

As wide bandgap electronic devices have continued to advance in both size reduction and power handling capabilities, heat dissipation has become a significant concern. To mitigate this, chemical vapor deposited (CVD) diamond has been demonstrated as an effective solution for thermal management of these devices by directly growing onto the transistor substrate. A key aspect of power and radio frequency (RF) electronic devices involves transient switching behavior, which highlights the importance of understanding the temperature dependence of the heat capacity and thermal conductivity when modeling and predicting device electrothermal response. Due to the complicated microstructure near the interface between CVD diamond and electronics, it is difficult to measure both properties simultaneously. In this work, we use time domain thermoreflectance (TDTR) to simultaneously measure the in plane thermal conductivity and heat capacity of a 1 um thick CVD diamond film, and also use the pump as an effective heater to perform temperature dependent measurements. The results show that the in plane thermal conductivity varied slightly with an average of 103 W per meter per K over a temperature range of 302 to 327 K, while the specific heat capacity has a strong temperature dependence over the same range and matches with heat capacity data of natural diamond in literature.

physics.app-ph↗

arXiv2019

Tunable Thermal Energy Transport across Diamond Membranes and Diamond-Si Interfaces by Nanoscale Graphoepitaxy

The development of electronic devices, especially those that involve heterogeneous integration of materials, has led to increased challenges in addressing their thermal operational-temperature demands. The heat flow in these systems is significantly influenced or even dominated by thermal boundary resistance at interface between dissimilar materials. However, controlling and tuning heat transport across an interface and in the adjacent materials has so far drawn limited attention. In this work, we grow chemical-vapor-deposited (CVD) diamond on silicon substrates by graphoepitaxy and experimentally demonstrate tunable thermal transport across diamond membranes and diamond-silicon interfaces. We observed the highest diamond-silicon thermal boundary conductance (TBC) measured to date and increased diamond thermal conductivity due to strong grain texturing in the diamond near the interface. Additionally, non-equilibrium molecular-dynamics (NEMD) simulations and a Landauer approach are used to understand the diamond-silicon TBC. These findings pave the way for tuning or increasing thermal conductance in heterogeneously integrated electronics that involve polycrystalline materials and will impact applications including electronics thermal management and diamond growth.

cond-mat.mes-hall↗

arXiv2018

Direct Visualization of Thermal Conductivity Suppression Due to Enhanced Phonon Scattering Near Individual Grain Boundaries

Understanding the impact of lattice imperfections on nanoscale thermal transport is crucial for diverse applications ranging from thermal management to energy conversion. Grain boundaries (GBs) are ubiquitous defects in polycrystalline materials, which scatter phonons and reduce thermal conductivity. Historically, their impact on heat conduction has been studied indirectly through spatially-averaged measurements, that provide little information about phonon transport near a single GB. Here, using spatially-resolved time-domain thermoreflectance (TDTR) measurements in combination with electron backscatter diffraction (EBSD), we make localized measurements of thermal conductivity within few μm of individual GBs in boron-doped polycrystalline diamond. We observe strongly suppressed thermal transport near GBs, a reduction in conductivity from ~1000 W/m-K at the center of large grains to ~400 W/m-K in the immediate vicinity of GBs. Furthermore, we show that this reduction in conductivity is measured up to ~10 μm away from a GB. A theoretical model is proposed that captures the local reduction in phonon mean-free-paths due to strongly diffuse phonon scattering at the disordered grain boundaries. Our results provide a new framework for understanding phonon-defect interactions in nanomaterials, with implications for the use of high thermal conductivity polycrystalline materials as heat sinks in electronics thermal management.

cond-mat.mes-hall↗

arXiv2017

Probing Growth-Induced Anisotropic Thermal Transport in CVD Diamond Membranes by Multi-frequency and Multi-spot-size Time-Domain Thermoreflectance

The maximum output power of GaN-based high-electron mobility transistors is limited by high channel temperature induced by localized self-heating which degrades device performance and reliability. With generated heat fluxes within these devices reaching magnitude close to ten times of that at the sun surface, chemical vapor deposition (CVD) diamond is an attractive candidate to aid in the extraction of this heat in order to keep the operating temperatures of these high power electronics as low as possible. Due to the observed inhomogeneous structure, CVD diamond membranes exhibit a 3D anisotropic thermal conductivity which may result in significantly different cooling performance from expected in a given application. In this work, time domain thermoreflectance (TDTR) is used to measure the thermal properties of an 11.8-μm CVD diamond membrane from its nucleation side. Starting with a spot size diameter larger than the thickness of the membrane, measurements are made at various modulation frequencies from 1.2 MHz to 11.6 MHz to tune the heat penetration depth, and subsequently the part of diamond sampled by TDTR. We divide the membrane into ten sublayers and assume isotropic thermal conductivity in each sublayer. From this, we observe a 2D gradient of the depth-dependent thermal conductivity for this membrane. By measuring the same region with a smaller spot size at multiple frequencies, the in-plane and cross-plane thermal conductivity are extracted respectively. Through this use of multiple spot sizes and modulation frequencies, the 3D anisotropic thermal conductivity of CVD diamond membrane is experimentally obtained by fitting the experimental data to a thermal model. This work provides insight toward an improved understanding of heat conduction inhomogeneity in CVD polycrystalline diamond membrane that is important for applications of thermal management of high power electronics.

cond-mat.mes-hall↗