arXiv subjects

Mark Holm

Publications and source records attributed to Mark Holm.

3 recordsLinked to original sources

arXiv2024

Joint Power Allocation and Beamforming for In-band Full-duplex Multi-cell Multi-user Networks

This paper investigates a robust joint power allocation and beamforming scheme for in-band full-duplex multi-cell multi-user (IBFD-MCMU) networks. A mean-squared error (MSE) minimization problem is formulated with constraints on the power budgets and residual self-interference (RSI) power. The problem is not convex, so we decompose it into two sub-problems: interference management beamforming and power allocation, and give closed-form solutions to the sub-problems. Then we propose an iterative algorithm to yield an overall solution. The computational complexity and convergence behavior of the algorithm are analyzed. Our method can enhance the analog self-interference cancellation (ASIC) depth provided by the precoder with less effect on the downlink communication than the existing null-space projection method, inspiring a low-cost but efficient IBFD transceiver design. It can achieve 42.9% of IBFD gain in terms of spectral efficiency with only antenna isolation, while this value increases to 60.9% with further digital self-interference cancellation (DSIC). Numerical results illustrate that our algorithm is robust to hardware impairments and channel uncertainty. With sufficient ASIC depth, our method reduces the computation time by at least 20% than the existing scheme due to its faster convergence speed at the cost of < 12.5% sum rate loss. The benefit is much more significant with single-antenna users that our algorithm saves at least 40% of the computation time at the cost of < 10% sum rate reduction.

cs.IT↗

arXiv2021

Design and Analysis of Wideband In-Band-Full-Duplex FR2-IAB Networks

This paper develops a 3GPP-inspired design for the in-band-full-duplex (IBFD) integrated access and backhaul (IAB) networks in the frequency range 2 (FR2) band, which can enhance the spectral efficiency (SE) and coverage while reducing the latency. However, the self-interference (SI), which is usually more than 100 dB higher than the signal-of-interest, becomes the major bottleneck in developing these IBFD networks. We design and analyze a subarray-based hybrid beamforming IBFD-IAB system with the RF beamformers obtained via RF codebooks given by a modified Linde-Buzo-Gray (LBG) algorithm. The SI is canceled in three stages, where the first stage of antenna isolation is assumed to be successfully deployed. The second stage consists of the optical domain (OD)-based RF cancellation, where cancelers are connected with the RF chain pairs. The third stage is comprised of the digital cancellation via successive interference cancellation followed by minimum mean-squared error baseband receiver. Multiuser interference in the access link is canceled by zero-forcing at the IAB-node transmitter. Simulations show that under 400 MHz bandwidth, our proposed OD-based RF cancellation can achieve around 25 dB of cancellation with 100 taps. Moreover, the higher the hardware impairment and channel estimation error, the worse digital cancellation ability we can obtain.

cs.IT↗

arXiv2021

Design of Full-Duplex Millimeter-Wave Integrated Access and Backhaul Networks

One of the key technologies for the future cellular networks is full duplex (FD)-enabled integrated access and backhaul (IAB) networks operating in the millimeter-wave (mmWave) frequencies. The main challenge in realizing FD-IAB networks is mitigating the impact of self-interference (SI) in the wideband mmWave frequencies. In this article, we first introduce the 3GPP IAB network architectures and wideband mmWave channel models. By utilizing the subarray-based hybrid precoding scheme at the FD-IAB node, multiuser interference is mitigated using zero-forcing at the transmitter, whereas the residual SI after successfully deploying antenna and analog cancellation is canceled by a minimum mean square error baseband combiner at the receiver. The spectral efficiency (SE) is evaluated for the RF insertion loss (RFIL) with different kinds of phase shifters and channel uncertainty. Simulation results show that, in the presence of the RFIL, the almost double SE, which is close to that obtained from fully connected hybrid precoding, can be achieved as compared to half duplex systems when the uncertainties are of low strength.

cs.IT↗