arXiv subjects

Martijn F. S. Zwanenburg

Publications and source records attributed to Martijn F. S. Zwanenburg.

7 recordsLinked to original sources

arXiv2026

Flip-chip integrated superconducting qubits using electroplated bump bonds

Flip-chip integration offers a promising route toward scalable superconducting quantum processors and hybrid semiconductor-superconductor quantum devices. We develop a three-dimensional transmon architecture using electroplated indium in which the qubit electric field is shared nearly equally between two bump-bonded substrates while maintaining low participation at the indium-bump interface. The resulting geometry is well suited for future hybrid qubits, enabling the integration of distinct material platforms while minimizing sensitivity to bump-interface loss. Using this platform, we evaluate electroplated indium interconnects for superconducting quantum circuits. Flip-chip transmons incorporating electroplated indium bumps exhibit qubit quality factors around $10^6$. In addition, a systematic study of coplanar-waveguide resonators is used to identify losses associated with the electroplating process. In particular, we find that surface losses associated with the gold-layer, used to enable good electric contact with the indium, is likely the primary contributor to the qubit decay rate. These results demonstrate the compatibility of electroplated indium technology with high-coherence superconducting circuits and establish a promising platform for three-dimensional hybrid quantum integration.

quant-ph↗

arXiv2026

Experimental Characterization and Modeling of Measurement-Induced State-Transitions in a Fluxonium Superconducting Qubit

Superconducting qubits are most often measured using dispersive readout, which, ideally, implements a projective quantum non-demolition (QND) measurement. While a larger readout drive can increase the signal and, thus, reduce discrimination errors in the readout, strong microwave drives may also cause non-QND errors by driving the qubit to a state outside the computational subspace. In this work, we experimentally characterize measurement-induced state transitions (MIST) in a fluxonium qubit over its full external flux range. We further numerically calculate the MIST errors, and find that the theory accurately predicts eleven experimentally identified regions with increased MIST. In addition to transitions to higher fluxonium levels, we also find that, at certain flux points, MIST errors are dominated by transitions that include the transmission-line-like array modes of the fluxonium's superinductor. The excellent match between theory and experiment validates that the models accurately predict the occurrence of MIST in these systems, and further highlights the influence of array modes in fluxonium readout.

quant-ph↗

arXiv2026

Crosstalk in Multi-Qubit Fluxonium Architectures with Transmon Couplers

In recent years, several architectures have been proposed for implementing two-qubit operations on fluxonium superconducting qubits. A particularly promising approach, which was demonstrated experimentally by Refs. [1,2], employs a transmon superconducting qubit as a tunable coupler between the fluxonium qubits. These experiments have shown that the transmon coupler enables fast, high-fidelity two-qubit operations while suppressing unwanted ZZ crosstalk between the fluxonium qubits. In this work, we numerically study the scalability of this architecture. We find that, when trivially scaling this architecture, crosstalk from spectator qubits limits the gate fidelity to below 90%. We show that these spectator errors can be reduced to below $10^{-4}$ by reducing the coupling strength and by dynamically tuning transmons that are not used for a two-qubit operation to an off position. We further investigate the resilience of the operation to direct capacitive coupling between the transmon couplers and to microwave crosstalk.

quant-ph↗

arXiv2025

Fast microwave-driven two-qubit gates between fluxonium qubits with a transmon coupler

Two qubit gates constitute fundamental building blocks in the realization of large-scale quantum devices. Using superconducting circuits, two-qubit gates have previously been implemented in different ways with each method aiming to maximize gate fidelity. Another important goal of a new gate scheme is to minimize the complexity of gate calibration. In this work, we demonstrate a high-fidelity two-qubit gate between two fluxonium qubits enabled by an intermediate capacitively coupled transmon. The coupling strengths between the qubits and the coupler are designed to minimize residual crosstalk while still allowing for fast gate operations. The gate is based on frequency selectively exciting the coupler using a microwave drive to complete a 2$π$ rotation, conditional on the state of the fluxonium qubits. When successful, this drive scheme implements a conditional phase gate. Using analytically derived pulse shapes, we minimize unwanted excitations of the coupler and obtain gate errors of $10^{-2}$ for gate times below 60~ns. At longer durations, our gate is limited by relaxation of the coupler. Our results show how carefully designed control pulses can speed up frequency selective entangling gates.

quant-ph↗

arXiv2025

Single-Qubit Gates Beyond the Rotating-Wave Approximation for Strongly Anharmonic Low-Frequency Qubits

Single-qubit gates are in many quantum platforms applied using a linear drive resonant with the qubit transition frequency which is often theoretically described within the rotating-wave approximation (RWA). However, for fast gates on low-frequency qubits, the RWA may not hold and we need to consider the contribution from counter-rotating terms to the qubit dynamics. The inclusion of counter-rotating terms into the theoretical description gives rise to two challenges. Firstly, it becomes challenging to analytically calculate the time evolution as the Hamiltonian is no longer self-commuting. Moreover, the time evolution now depends on the carrier phase such that, in general, every operation in a sequence of gates is different. In this work, we derive and verify a correction to the drive pulses that minimizes the effect of these counter-rotating terms in a two-level system. We then derive a second correction term that arises from non-computational levels for a strongly anharmonic system. We experimentally implement these correction terms on a fluxonium superconducting qubit, which is an example of a strongly anharmonic, low-frequency qubit for which the RWA may not hold, and demonstrate how fast, high-fidelity single-qubit gates can be achieved without the need for additional hardware complexities.

quant-ph↗

arXiv2024

Energy participation ratio analysis for very anharmonic superconducting circuits

Superconducting circuits are being employed for large-scale quantum devices, and a pertinent challenge is to perform accurate numerical simulations of device parameters. One of the most advanced methods for analyzing superconducting circuit designs is the energy participation ratio (EPR) method, which constructs quantum Hamiltonians based on the energy distribution extracted from classical electromagnetic simulations. In the EPR approach, we extract linear terms from finite element simulations and add nonlinear terms using the energy participation ratio extracted from the classical simulations. However, the EPR method relies on a low-order expansion of nonlinear terms, which is prohibitive for accurately describing highly anharmonic circuits. An example of such a circuit is the fluxonium qubit, which has recently attracted increasing attention due to its high lifetimes and low error rates. In this work, we extend the EPR approach to effectively address highly nonlinear superconducting circuits, and, as a proof of concept, we apply our approach to a fluxonium qubit. Specifically, we design, fabricate, and experimentally measure a fluxonium qubit coupled to a readout resonator. We compare the measured frequencies of both the qubit and the resonator to those extracted from the EPR analysis, and we find an excellent agreement. Furthermore, we compare the dispersive shift as a function of external flux obtained from experiments with our EPR analysis and a simpler lumped element model. Our findings reveal that the EPR results closely align with the experimental data, providing more accurate estimations compared to the simplified lumped element simulations.

quant-ph↗

arXiv2024

Improved fluxonium readout through dynamic flux pulsing

The ability to perform rapid, high fidelity readout of a qubit state is an important requirement for quantum algorithms and, in particular, for enabling operations such as mid-circuit measurements and measurement-based feedback for error correction schemes on large quantum processors. The growing interest in fluxonium qubits, due to their long coherence times and high anharmonicity, merits further attention to reducing the readout duration and measurement errors. We find that this can be accomplished by exploiting the flux tunability of fluxonium qubits. In this work, we experimentally demonstrate flux-pulse-assisted readout, as proposed in Phys. Rev. Applied 22, 014079 (https://doi.org/10.1103/PhysRevApplied.22.014079), in a setup without a quantum-limited parametric amplifier. Increasing the dispersive shift magnitude by almost 20% through flux pulsing, we achieve an assignment fidelity of 94.3% with an integration time of 280 ns. The readout performance is limited by state initialization, but we find that the limit imposed only by the signal-to-noise ratio corresponds to an assignment fidelity of 99.9% with a 360 ns integration time. We also verify these results through simple semi-classical simulations. These results constitute the fastest reported readout of a fluxonium qubit, with the prospect of further improvement by incorporation of a parametric amplifier in the readout chain to enhance measurement efficiency.

quant-ph↗