arXiv subjects

Martin Heilmaier

Publications and source records attributed to Martin Heilmaier.

3 recordsLinked to original sources

arXiv2025

Creep Behavior of High-Entropy Alloys: A Critical Review

High-entropy alloys (HEAs) comprise a compositionally complex class of materials that in certain cases exhibit outstanding mechanical properties. While substantial progress has been made in understanding their phase stability, microstructure, and deformation mechanisms at room and cryogenic temperatures, the long-term creep behavior (>100 h) of HEAs at high temperatures (>0.6 Tm, where Tm is the melting temperature) remains relatively underexplored. This knowledge gap is critical, as many engineering applications, including those in aerospace, power generation, aero engines and nuclear energy, require materials with good creep resistance to maintain structural integrity over extended service lifetimes. This review provides a focused and critical assessment of the current understanding of high-temperature deformation and creep behavior of HEAs, with particular attention paid to face-centered cubic HEAs and body-centered cubic refractory HEAs. The underlying deformation mechanisms governing their creep response and the influence of phase stability at elevated temperatures are examined in detail. Recent studies reveal mechanistic differences between HEAs and conventional dilute alloys that do not always lead to improved creep resistance belying their initial promise. Based on these findings, we discuss the challenges in designing HEAs for high-temperature structural applications and outline future research directions that may lead to creep-resistant HEAs.

cond-mat.mtrl-sci↗

arXiv2022

Temporal sequence of deformation twinning in CoCrNi under tribological load

Microstructural evolution under tribological load is known to change the friction and wear response of the entire tribological system. It is however not yet fully understood, how these changes take place on an elementary, mechanistic level. Revealing the temporal sequence of deformation mechanisms under a tribological load by experiments is scarce. The discrete strain release in the case of deformation twinning allows the identification of their temporal sequence. Therefore, a medium stacking fault energy material, namely CoCrNi, was investigated due to the significant contribution of deformation twinning to the overall deformation at room temperature. The investigated grain showed three activated twin systems. The evolution sequence of these is discussed critically based on several twin intersection mechanisms. The experimental analysis decodes the temporal sequence of the active twinning systems of highest resolved shear stresses for the first time. This approach gives experimental indications for the stress field under a tribological load.

cond-mat.mtrl-sci↗

arXiv2021

Dislocation-mediated and twinning-induced plasticity of CoCrFeMnNi in varying tribological loading scenarios

Coarse-grained, metallic materials undergo microstructure refinement during tribological loading. This in turn results in changing tribological properties, so understanding deformation under tribological load is mandatory when designing tribological systems. Single-trace experiments were conducted to understand the initiation of deformation mechanisms acting in various tribological systems. The main scope of this work was to investigate the influence of normal and friction forces as well as crystal orientations on the dominating deformation mechanism in a face-centred cubic concentrated solid solution. While varying the normal force is easily realised, varying friction forces were achieved by using several counter body materials paired against CoCrFeMnNi. The subsurface deformation layer was either mediated through dislocation slip or twinning, depending on the grain orientation and on the tribological system. A layer dominated by dislocation-based deformation is characterised by lattice rotation, the formation of a dislocation trace line or subgrain formation. Such behaviour is observed for tribological systems with a low friction coefficient. For systems dominated by deformation twinning, three types of twin appearance were observed: small twins interacting with the surface, large twins and grains with two active twin systems. Two different twinning mechanisms are discussed as responsible for these characteristics.

cond-mat.mtrl-sci↗