arXiv subjects

Martin Vannier

Publications and source records attributed to Martin Vannier.

14 recordsLinked to original sources

arXiv2014

VLTI/AMBER differential interferometry of the broad-line region of the quasar 3C273

Unveiling the structure of the Broad Line Region (BLR) of AGNs is critical to understand the quasar phenomenon. Resolving a few BLRs by optical interferometry will bring decisive information to confront, complement and calibrate the reverberation mapping technique, basis of the mass-luminosity relation in quasars. BLRs are much smaller than the angular resolution of the VLT and Keck interferometers and they can be resolved only by differential interferometry very accurate measurements of differential visibility and phase as a function of wavelength. The latter yields the photocenter variation with wavelength, and constrains the size, position and velocity law of various regions of the BLR. AGNs are below the magnitude limit for spectrally resolved interferometry set by currently available fringe trackers. A new "blind" observation method and a data processing based on the accumulation of 2D Fourier power and cross spectra permitted us to obtain the first spectrally resolved interferometric observation of a BLR, on the K=10 quasar 3C273. A careful bias analysis is still in progress, but we report strong evidence that, as the baseline increases, the differential visibility decreases in the Pa-alpha line. Combined with a differential phase smaller than 3 degree, this yields an angular equivalent radius of the BLR larger than 0.4 milliarcseconds, or 1000 light days at the distance of 3C273, much larger than the reverberation mapping radius of 300 light days. Explaining the coexistence of these two different sizes, and possibly structures and mechanisms, implies very new insights into the BLR of 3C273

astro-ph.GA↗

arXiv2014

PAINTER: a spatio-spectral image reconstruction algorithm for optical interferometry

Astronomical optical interferometers sample the Fourier transform of the intensity distribution of a source at the observation wavelength. Because of rapid perturbations caused by atmospheric turbulence, the phases of the complex Fourier samples (visibilities) cannot be directly exploited. Consequently, specific image reconstruction methods have been devised in the last few decades. Modern polychromatic optical interferometric instruments are now paving the way to multiwavelength imaging. This paper is devoted to the derivation of a spatio-spectral (3D) image reconstruction algorithm, coined PAINTER (Polychromatic opticAl INTErferometric Reconstruction software). The algorithm relies on an iterative process, which alternates estimation of polychromatic images and of complex visibilities. The complex visibilities are not only estimated from squared moduli and closure phases, but also differential phases, which helps to better constrain the polychromatic reconstruction. Simulations on synthetic data illustrate the efficiency of the algorithm and in particular the relevance of injecting a differential phases model in the reconstruction.

astro-ph.IM↗

arXiv2014

Statistical characterization of polychromatic absolute and differential squared visibilities obtained from AMBER/VLTI instrument

In optical interferometry, the visibility squared modulus are generally assumed to follow a Gaussian distribution and to be independent of each other. A quantitative analysis of the relevance of such assumptions is important to help improving the exploitation of existing and upcoming multi-wavelength interferometric instruments. Analyze the statistical behaviour of both the absolute and the colour-differential squared visibilities: distribution laws, correlations and cross-correlations between different baselines. We use observations of stellar calibrators obtained with AMBER instrument on VLTI in different instrumental and observing configurations, from which we extract the frame-by-frame transfer function. Statistical hypotheses tests and diagnostics are then systematically applied. For both absolute and differential squared visibilities and under all instrumental and observing conditions, we find a better fit for the Student distribution than for the Gaussian, log-normal and Cauchy distributions. We find and analyze clear correlation effects caused by atmospheric perturbations. The differential squared visibilities allow to keep a larger fraction of data with respect to selected absolute squared visibilities and thus benefit from reduced temporal dispersion, while their distribution is more clearly characterized. The frame selection based on the criterion of a fixed SNR value might result in either a biased sample of frames or in a too severe selection.

astro-ph.IM↗

arXiv2012

The 2012 Interferometric Imaging Beauty Contest

We present the results of the fifth Interferometric Imaging Beauty Contest. The contest consists in blind imaging of test data sets derived from model sources and distributed in the OIFITS format. Two scenarios of imaging with CHARA/MIRC-6T were offered for reconstruction: imaging a T Tauri disc and imaging a spotted red supergiant. There were eight different teams competing this time: Monnier with the software package MACIM; Hofmann, Schertl and Weigelt with IRS; Thiébaut and Soulez with MiRA ; Young with BSMEM; Mary and Vannier with MIROIRS; Millour and Vannier with independent BSMEM and MiRA entries; Rengaswamy with an original method; and Elias with the radio-astronomy package CASA. The contest model images, the data delivered to the contestants and the rules are described as well as the results of the image reconstruction obtained by each method. These results are discussed as well as the strengths and limitations of each algorithm.

astro-ph.IM↗

arXiv2012

Three recipes for improving the image quality with optical long-baseline interferometers: BFMC, LFF, \& DPSC

We present here three recipes for getting better images with optical interferometers. Two of them, Low- Frequencies Filling and Brute-Force Monte Carlo were used in our participation to the Interferometry Beauty Contest this year and can be applied to classical imaging using V 2 and closure phases. These two addition to image reconstruction provide a way of having more reliable images. The last recipe is similar in its principle as the self-calibration technique used in radio-interferometry. We call it also self-calibration, but it uses the wavelength-differential phase as a proxy of the object phase to build-up a full-featured complex visibility set of the observed object. This technique needs a first image-reconstruction run with an available software, using closure-phases and squared visibilities only. We used it for two scientific papers with great success. We discuss here the pros and cons of such imaging technique.

astro-ph.IM↗

arXiv2010

The 2010 Interferometric Imaging Beauty Contest

We present the results of the fourth Optical/IR Interferometry Imaging Beauty Contest. The contest consists of blind imaging of test data sets derived from model sources and distributed in the OI-FITS format. The test data consists of spectral data sets on an object "observed" in the infrared with spectral resolution. There were 4 different algorithms competing this time: BSMEM the Bispectrum Maximum Entropy Method by Young, Baron & Buscher; RPR the Recursive Phase Reconstruction by Rengaswamy; SQUEEZE a Markov Chain Monte Carlo algorithm by Baron, Monnier & Kloppenborg; and, WISARD the Weak-phase Interferometric Sample Alternating Reconstruction Device by Vannier & Mugnier. The contest model image, the data delivered to the contestants and the rules are described as well as the results of the image reconstruction obtained by each method. These results are discussed as well as the strengths and limitations of each algorithm.

astro-ph.IM↗

arXiv2009

Study of the atmospheric refraction in a single mode instrument - Application to AMBER/VLTI

This paper presents a study of the atmospheric refraction and its effect on the light coupling efficiency in an instrument using single-mode optical fibers. We show the analytical approach which allowed us to assess the need to correct the refraction in J- and H-bands while observing with an 8-m Unit Telescope. We then developed numerical simulations to go further in calculations. The hypotheses on the instrumental characteristics are those of AMBER (Astronomical Multi BEam combineR), the near infrared focal beam combiner of the Very Large Telescope Interferometric mode (VLTI), but most of the conclusions can be generalized to other single-mode instruments. We used the software package caos (Code for Adaptive Optics Systems) to take into account the atmospheric turbulence effect after correction by the ESO system MACAO (Multi-Application Curvature Adaptive Optics). The opto-mechanical study and design of the system correcting the atmospheric refraction on AMBER is then detailed. We showed that the atmospheric refraction becomes predominant over the atmospheric turbulence for some zenith angles z and spectral conditions: for z larger than 30{\circ} in J-band for example. The study of the optical system showed that it allows to achieve the required instrumental performance in terms of throughput in J- and H-bands. First observations in J-band of a bright star, alpha Cir star, at more than 30{\circ} from zenith clearly showed the gain to control the atmospheric refraction in a single mode instrument, and validated the operating law.

astro-ph.IM↗

arXiv2008

AMBER closure and differential phases: accuracy and calibration with a Beam Commutation

The first astrophysical results of the VLTI focal instrument AMBER have shown the importance of the differential and closure phase measures, which are supposed to be much less sensitive to atmospheric and instrumental biases than the absolute visibility. However there are artifacts limiting the accuracy of these measures which can be substantially overcome by a specific calibration technique called Beam Commutation. This paper reports the observed accuracies on AMBER/VLTI phases in different modes, discusses some of the instrumental biases and shows the accuracy gain provided by Beam Commutation on the Differential Phase as well as on the Closure Phase.

astro-ph↗

arXiv2008

"Advanced" data reduction for the AMBER instrument

The amdlib AMBER data reduction software is meant to produce AMBER data products from the raw data files that are sent to the PIs of different proposals or that can be found in the ESO data archive. The way defined by ESO to calibrate the data is to calibrate one science data file with a calibration one, observed as close in time as possible. Therefore, this scheme does not take into account instrumental drifts, atmospheric variations or visibility-loss corrections, in the current AMBER data processing software, amdlib. In this article, we present our approach to complement this default calibration scheme, to perform the final steps of data reduction, and to produce fully calibrated AMBER data products. These additional steps include: an overnight view of the data structure and data quality, the production of night transfer functions from the calibration stars observed during the night, the correction of additional effects not taken into account in the standard AMBER data reduction software such as the so-called "jitter" effect and the visibility spectral coherence loss, and finally, the production of fully calibrated data products. All these new features are beeing implemented in the modular pipeline script amdlibPipeline, written to complement the amdlib software.

astro-ph↗

arXiv2007

AMBER on the VLTI: data processing and calibration issues

We present here the current performances of the AMBER / VLTI instrument for standard use and compare these with the offered modes of the instrument. We show that the instrument is able to reach its specified precision only for medium and high spectral resolution modes, differential observables and bright objects. For absolute observables, the current achievable accuracy is strongly limited by the vibrations of the Unit Telescopes, and also by the observing procedure which does not take into account the night-long transfer function monitoring. For low-resolution mode, the current limitation is more in the data reduction side, since several effects negligible at medium spectral resolution are not taken into account in the current pipeline. Finally, for faint objects (SNR around 1 per spectral channel), electromagnetic interferences in the VLTI interferometric laboratory with the detector electronics prevents currently to get unbiased measurements. Ideas are under study to correct in the data processing side this effect, but a hardware fix should be investigated seriously since it limits seriously the effective limiting magnitude of the instrument.

astro-ph↗

arXiv2007

A compact dust shell in the symbiotic system HM Sge

We present high spatial resolution observations of the mid-infrared core of the dusty symbiotic system HM Sge. The MIDI interferometer was used with the VLT UTs and ATs providing baselines oriented from PA=42° to 105°. The MIDI visibilities are compared with the ones predicted in the frame of various spherical dust shells published in the literature involving single or double dusty shells. The mid-IR environment is unresolved by a 8m telescope and the MIDI spectrum exhibits a level similar to the ISO spectra recorded 10 yr ago. The estimated Gaussian HWHM of the shell of 12AU in the 8-9$μ$m range, and 18AU in the 11-12$μ$m range, are much smaller than the angular separation between the Mira and the White Dwarf of 60AU. The discrepancies between the HWHM at different angle orientations suggest an increasing level of asymmetry from 13 to 8$μ$m. The observations are well fitted by the densest and smallest model published in the literature based on the ISO data, although such a model does not account for the variations of near-IR photometry due to the Mira pulsation cycle suggesting a much smaller optical thickness. These observations also discard the two shells models, developed to take into account the effect of the WD illumination onto the dusty wind of the Mira. These observations show that a high rate of dust formation is occurring in the vicinity of the Mira which seems to be not highly perturbed by the hot companion.

astro-ph↗

arXiv2006

First direct detection of a Keplerian rotating disk around the Be star $α$ Arae using the VLTI/AMBER instrument

Aims. We aim to study the geometry and kinematics of the disk around the Be star $α$ Arae as a function of wavelength, especially across the Br$γ$ emission line. The main purpose of this paper is to answer the question about the nature of the disk rotation around Be stars. Methods. We use the VLTI/AMBER instrument operating in the K band which provides a gain by a factor 5 in spatial resolution compared to previous VLTI/MIDI observations. Moreover, it is possible to combine the high angular resolution provided with the (medium) spectral resolution of AMBER to study the kinematics of the inner part of the disk and to infer its rotation law. Results. We obtain for the first time the direct evidence that the disk is in keplerian rotation, answering a question that occurs since the discovery of the first Be star $γ$ Cas by father Secchi in 1866. We also present the global geometry of the disk showing that it is compatible with a thin disk + polar enhanced winds modeled with the SIMECA code. We found that the disk around $α$ Arae is compatible with a dense equatorial matter confined in the central region whereas a polar wind is contributing along the rotational axis of the central star. Between these two regions the density must be low enough to reproduce the large visibility modulus (small extension) obtained for two of the four VLTI baselines. Moreover, we obtain that $α$ Arae is rotating very close to its critical rotation. This scenario is also compatible with the previous MIDI measurements.

astro-ph↗

arXiv2005

Extrasolar Planets with AMBER/VLTI, What can we expect from current performances ?

We present the current performances of the AMBER / VLTI instrument in terms of differential observables (differential phase and differential visibility) and show that we are already able to reach a sufficient precision for very low mass companions spectroscopy and mass characterization. We perform some extrapolations with the knowledge of the current limitations of the instrument facility. We show that with the current setup of the AMBER instrument, we can already reach $3σ= 10^{-3}$ radians and have the potential to some low mass companions characterization (Brown dwarves or hypothetical very hot Extra Solar Giant Planets). With some upgrades of the VLTI infrastructure, improvements of the instrument calibration and improvements of the observing strategy, we will be able to reach $3σ= 10^{-4}$ radians and will have the potential to perform Extra Solar Giant Planets spectroscopy and mass characterization.

astro-ph↗

arXiv2004

Direct Detection of Sub-stellar Companions with MIDI

Current detection methods of planetary companions do not allow retrieving their spectral information properties. The method of Differential Interferometry has the potential to complement such information by comparing interferometric observables in various spectral channels. We outline the basic aspects of this method and how it can soon be realised by the Mid-infrared Interferometric instrument (MIDI) at the Very Large Telescope Interferometer (VLTI) observatory. A set of possible candidates for such direct observation has been selected among currently identified planetary companions. Differential Interferometry with MIDI would be complementary to other ground-based programs. The method may also be an alternative for future space-based planetary spectroscopy.

astro-ph↗